Structural studies on Ca3Al4MgO10 (C3A2M)—A ternary phase in the system CaO–Al2O3–MgO

In a sequence of temperature-dependent solid-state reactions in the system CaO–Al₂O₃–MgO the formation of the ternary phase Ca₃Al₄MgO₁₀ or C₃A₂M has been studied. Whereas the compound could not be prepared at 1200°C, a yield of 85 wt.-% of Ca₃Al₄MgO₁₀ was obtained at 1320°C (incongruent melting point: 1330°C). Powder diffraction data compare well with results of previous investigations from the 1960s. Single crystals of Ca₃Al₄MgO₁₀ could be retrieved from the sinter-pellets. Basic crystallographic data are as follows: orthorhombic symmetry, space group Pbcm, a = 5.14073(8), b = 16.7576(2), c = 10.70977(16) Å, V = 922.61(2) ų, Z = 4. Using synchrotron diffraction data it was possible to solve the crystal structure. Least-squares refinements resulted in a residual of R(|F|) = 0.021 for 1000 independent observed reflections with I > 2σ(I) and 97 parameters. The structure contains [TO₄]-tetrahedra (T=Al,Mg) forming a three-dimensional (3-D) framework whose topological characteristics have been determined. Al-Mg distributions on the different T-sites have been studied. The calcium cations are located in voids of the network. More than 50 years after its first observation our investigation clarifies the crystal structure of a compound belonging to a system that is of relevance for several fields of materials science.     

Spurenstoffabtrennung mit keramischen Nanofiltrationsmembranen als Rotationsscheibenfilter

Reducing micropollutant pollution of water bodies is an important objective of water management and an integral part of environmental policy. Ceramic nanofiltration membranes were developed as multichannel membranes of increased membrane area and rotating disk filters. The membranes developed show retention of over 80 % for PEG 400. The membranes are currently being tested for the separation of micropollutants from wastewater contaminated with pharmaceuticals. With the help of a downstream oxidative process, the trace substances remaining in the permeate are degraded.     

Fabrication of Ti3SiC2-based pastes for screen printing on paper-derived Al2O3 substrates

This paper describes the development and fabrication of pastes suitable for screen printing process using Ti₃SiC₂ as the ceramic filler and ethyl cellulose as the binder. With the aim of obtaining high quality screen printed films, the influence of different amounts of Ti₃SiC₂ filler (20–40?vol%) and binder (0–5?vol%) on the rheological properties of the pastes was investigated. Samples with higher viscosity, such as pastes containing 30?vol% and 40?vol% Ti₃SiC₂ filler, regardless of the amount of ethyl cellulose, showed a higher printing quality compared to the samples with other compositions. The different paste compositions were screen printed onto paper-derived Al₂O₃ substrates containing 28.6 ± 4.8% open porosity and sintered for 1?h under an argon atmosphere at 1600?°C. X-ray diffraction (XRD) measurements and scanning electron microscopy (SEM) analysis showed that the sintered films contained TiC as a primary phase and Ti₃SiC₂ as a secondary phase. The partial decomposition of Ti₃SiC₂ after sintering can be attributed to residual carbon from the organic additives, which decreases the thermal stability of this material.     

Off-Pathway-Sensitive Protein-Splicing Screening Based on a Toxin/Antitoxin System

Protein-splicing domains are frequently used engineering tools that find application in the in vivo and in vitro ligation of protein domains. Directed evolution is among the most promising technologies used to advance this technology. However, the available screening systems for protein-splicing activity are associated with bottlenecks such as the selection of pseudo-positive clones arising from off-pathway reaction products or fragment complementation. Herein, we report a stringent screening method for protein-splicing activity in cis and trans, that exclusively selects productively splicing domains. By fusing splicing domains to an intrinsically disordered region of the antidote from the Escherichia coli CcdA/CcdB type II toxin/antitoxin system, we linked protein splicing to cell survival. The screen allows selecting novel cis- and trans-splicing inteins catalyzing productive highly efficient protein splicing, for example, from directed-evolution approaches or the natural intein sequence space.     

可持续理念的体现——杭州来福士中心

正UNStudio由Ben van Berkel和Caroline Bos创立,是一个国际性的建筑设计网络。拥有三个全方位服务的国际事务所,分别位于阿姆斯特丹、香港和上海。专于建筑、室内建筑、产品设计、城市发展和基础设施项目。地址:浙江省杭州市钱江新城富春路业主方:凯德集团建筑面积:392526m~2项目年份:2017醒目的裙楼之上坐落着两座流线型的高楼,从中可以饱览钱塘江和西湖的迷人风光。     

Low‐Temperature Chemical Synthesis of High‐Purity Diacylglycerols (DAG) from Monoacylglycerols (MAG)

A chemical method was developed for low‐temperature synthesis of DAG from MAG followed by an easy purification procedure in order to obtain high‐purity DAG. Solvent‐assisted and solvent‐free reaction conditions were used, combined with different catalysts (sodium methoxide, p‐toluenesulfonic acid, methanesulfonic acid, and sulfuric acid). All reactions were performed at 35 and 70 °C. By increasing both acidity and polarity of the catalyst the equilibrium shifts towards the formation of DAG. When using sulfuric acid in solvent‐assisted condition at 70 °C, 88 % conversion was obtained after 20 min of reaction (77 % w/w DAG in the reaction mixture after evaporation of the solvent). After purifying by means of column chromatography, 96 % pure DAG were obtained. The overall yield of DAG was 81 %.     

A new ternary phase in the system CaO–Al2O3–Cr2O3: Crystal structure and thermal expansion of CaAl2Cr2O7

Polycrystalline material of a novel phase in the system CaO–Al₂O₃–Cr₂O₃ has been obtained by solid-state reactions. Chemical analysis indicated the composition CaAl₂Cr₂O₇. Single-crystal growth of the new compound using borax as a mineralizer was successful. Diffraction experiments at ambient conditions on a crystal with composition CaAl_2.13Cr_1.87O₇ yielded the following basic crystallographic data: space group P 3, a = 7.7690(5) Å, c = 7.6463(5) Å, V = 399.68(6) ų, Z = 3. Structure determination and subsequent least-squares refinements resulted in a residual of R(|F|) = 2.3% for 1440 independent observed reflections and 113 parameters. To the best of our knowledge, the structure of CaAl_2.13Cr_1.87O₇ or CaAl₂Cr₂O₇ represents a new structure type. It belongs to the group of double layer structures where individual double layers contain octahedrally and tetrahedrally coordinated cation positions. Linkage between neighboring sheet packages is provided by additional calcium cations. Furthermore, thermal expansion has been studied in the interval between 29 and 790°C using in situ high-temperature single-crystal diffraction. No indications for a structural phase transition were observed. From the evolution of the lattice parameters the thermal expansion tensor has been obtained. A pronounced anisotropy is evident. The response of structural building units to variable temperature has been discussed.     

Efficient Parallelization of Polyphase Arbitrary Resampling FIR Filters for High-Speed Applications

This article describes a method for increasing the sampling rate of efficient polyphase arbitrary resampling FIR filters. An FPGA proof of concept prototype of this architecture has been implemented in a Xilinx Kintex-7 FPGA which is able to convert the sampling rate of a signal from 500 MHz to 600 MHz. This article compares this new architecture with other best known efficient resampling architectures implemented on the same FPGA. The area usage on the FPGA shows that our proposed implementation is very proficient in high bandwidth applications without requiring significantly more resources on the FPGA. A theoretical calculation of the resampling error introduced on a modulated data stream is provided to evaluate the new architecture against other existing resampling architectures.     

Configuration in smart service systems: A practice‐based inquiry

In this paper, we develop a new perspective on configuration processes inherent to smart service systems that brings human actors to the theoretical foreground, is informed by practice theory, and is grounded in an intervention study of smart locating systems used in home care of persons with dementia. Maintaining control of the location of persons with dementia is a major source of caregiver burden, and assistive technologies such as smart locating systems hold the promise of enhancing quality of life and reducing caregiver burden. Drawing from research on smart service systems, organizational configuration research, and practice theory, we articulate a conceptual model of configuring in practice to explain how practice elements and the capabilities of smart technologies become mutually configured. Our analysis of study participants' experiences with the locating systems identified three distinctive configurations, characterized as enhanced smartness, degraded smartness, and fragile smartness, which developed through configuring processes. The configuring in practice model we develop here helps explain why unexpected and anticipated configurations develop and thus the conditions that facilitate or inhibit value cocreation in smart service systems.