Effects of SiC content on the densification,microstructure, and mechanical properties of HfB2–SiC composites

To investigate the effects of SiC on microstructure, hardness, and fracture toughness, 0, 10, 20, and 30 vol% SiC were added to HfB₂ and sintered by SPS. Upon adding SiC to 30 vol%, relative density increased about 4%; but HfB₂ grain growth had a minimum at 20 vol% SiC. This may be due to grain boundary silicate glass, responsible for surface oxide wash out, enriched in SiO₂ with higher fraction of SiC. By SiO₂ enrichment, the glass viscosity increased and higher HfO₂ remained unsolved which subsequently lead to higher grain growth. Hardness has increased from about 13 to 15 GPa by SiC introduction with no sensible variation with SiC increase. Residual stress measurements by Rietveld method indicated high levels of tensile residual stresses in the HfB₂ Matrix. Despite the peak residual stress value at 20 vol% SiC, fracture toughness of this sample was the highest (6.43 MPa m^0.5) which implied that fracture toughness is mainly a grain size function. Tracking crack trajectory showed a mainly trans-granular fracture, but grain boundaries imposed a partial deflection on the crack pathway. SiC had a higher percentage in fracture surface images than the cross-section which implied a weak crack deflection.     

Al2O3 Colloidal Nanocrystals with Strong UV Emission

A facile sol–gel procedure has been developed for the synthesis of colloidal alumina nanocrystals. For the first time, optical characterization procedures were employed to study the quantum confinement effects in optical properties of the prepared Al₂O₃ sol. Accordingly, the hyperbolic band model was used to determine the optical band gap of colloidal alumina nanocrystals. X‐Ray diffraction pattern was used to study the crystallographic phase of the dried gel. Morphological characterization was performed using scanning electron microscopy (SEM). Inductively Coupled Plasma (ICP) emission spectroscopy was used to determination purity of the Al₂O₃ powder. High‐resolution TEM showed that the diameter of colloidal nanocrystals is about 10 nm. Photoluminescence spectroscopy demonstrated that quantum yields for colloidal nanocrystals are 68% with 300 nm excitation wavelength. The experimental observations confirm that highly stable alumina sol with strong UV emission was synthesized. The mentioned optical properties have not been reported before.     

A Code Assignment Algorithm for Nonblocking OVSF Codes in WCDMA

OVSF codes are used as channelization codes in WCDMA. Due to code blocking property of OVSF codes, the bandwidth available in the system is severely limited. Code reassignments mitigate the impact of the blocking property at the expense of causing delays and decreasing the throughput of the system. Nonblocking OVSF (NOVSF) codes have been proposed to alleviate the adverse effect of code reassignments. This paper presents a code assignment algorithm for NOVSF codes, which does not require any code reassignments. Simulation results show that NOVSF codes achieve better throughput than OVSF codes, even though code reassignments are allowed in the assignments of OVSF codes.     

Iodo-2'-deoxyuridine (IUdR) and 125IUdR loaded biodegradable microspheres for controlled delivery to the brain

The aim of this work was to develop sustained local release systems for radioiodinated iodo-2'-deoxyuridine (125IUdR) from biodegradable polymeric microspheres to facilitate the controlled delivery of 125IUdR to brain tumours. The selective uptake of IUdR into the cell nucleus results in cell disruption over the short range of the low energy Auger electrons. The biodegradable microspheres can be precisely implanted in the brain by stereotactic techniques and the IUdR within the microspheres is protected from degradation and thus a sustained source of radiolabelled IUdR is available in the vicinity of the residual tumour cells. Poly(lactic-co-glycolic acid), PLGA (85:15), microspheres containing cold IUdR and the Auger-electron emitter 125I, as 125IUdR were prepared using the O/W, O/O and W/O/W emulsion-solvent evaporation methods. The W/O/W emulsion method was most effective in achieving good drug loading with the use of bovine plasma in the internal water phase. Also effective in improving the drug loading was the use of 20% acetone in the dichloromethane and the presence of Span 40 in the organic phase. Electrolytes (NaCl and IUdR) in the external aqueous phase also improved drug loading. After an initial rapid release from the microspheres, a sustained release was observed over 15 days for the 'cold' IUdR. The sustained release portions of the release curves showed Higuchi (t1/2), diffusion controlled release kinetics. The radiolabelled IUdR microspheres showed a burst release effect of 30-40% followed by a sustained release over 35 days.     

Autocorrelation model-based identification method for ARMA systems in noise

A novel method for parameter estimation of minimum-phase autoregressive moving average (ARMA) systems in noise is presented. The ARMA parameters are estimated using a damped sinusoidal model representation of the autocorrelation function of the noise-free ARMA signal. The AR parameters are obtained directly from the estimates of the damped sinusoidal model parameters with guaranteed stability. The MA parameters are estimated using a correlation matching technique. Simulation results show that the proposed method can estimate the ARMA parameters with better accuracy as compared to other reported methods, in particular for low SNRs.     

Determination of vitality from a non-invasive biomedical measurement for use in fingerprint scanners

Fingerprints are the oldest and most widely used biometrics for personal identification. Unfortunately, it is usually possible to deceive automatic fingerprint identification systems by presenting a well-duplicated synthetic or dismembered finger. This paper introduces one method to provide fingerprint vitality authentication in order to solve this problem. Detection of a perspiration pattern over the fingertip skin identifies the vitality of a fingerprint. Mapping the two-dimensional fingerprint images into one-dimensional signals, two ensembles of measures, namely static and dynamic measures, are derived for classification. Static patterns as well as temporal changes in dielectric mosaic structure of the skin, caused by perspiration, demonstrate themselves in these signals. Using these measures, this algorithm quantifies the sweating pattern and makes a final decision about vitality of the fingerprint by a neural network trained by examples.     

Computerized facility layout design

The paper describes a computerized facility layout designer, COMLAD II, for plant layout development. Besides developing an efficient layout, COMLAD II has useful features which allow fixing the departments, changing the shape of the departments and changing the length and width dimensions of the overall layout.     

Characterization of rheological properties of systems containing sugar substitutes and carrageenan

The effects of addition of κ-carrageenan to solutions containing 40% (w/w) sugar substitute on the rheological properties of these systems were investigated at 25 °C using a rotational viscometer at rotational speeds of 6, 12, 30, and 60 rev min⁻¹. The flow behaviour of the solutions was adequately described by the power law model with or without yield stress. The consistency index ( K ) and the flow behaviour index ( n ) were determined from shear stress vs. shear rate data. The flow parameters of the solutions depended on the carrageenan concentration. The apparent viscosities of the systems decreased with increasing shear rate, indicating pseudoplastic behaviour. The final carrageenan concentration was found to be an effective factor controlling the degree of sliminess of the model food systems studied.     

Studies on the interactions of metal oxides and Na2 SO4 at 1100 and 1200 K in oxygen

The interaction of different metal oxides such as Co₃O₄, NiO, Al₂O₃, Cr₂O₃, Fe₂O₃ and SiO₂ with Na₂SO₄ at a temperature of 1100 and 1200 K in flowing oxygen has been studied. The thermogravimetric studies for each system were carried out as a function of Na₂SO₄ in the mixture. The presence of different constituents in the reaction products were identified by X-ray diffraction analysis and the morphologies of the reaction products were characterized using metallography and scanning electron microscopy (SEM). The formation of products was also investigated by thermodynamic computation of free energies of the reactions and the study of relevant equilibrium phase diagrams. The soluble species in the aqueous solutions of the reaction products were determined quantitatively using atomic absorption spectrophotometry. The high temperature interaction products usually contain a 3-phase structure namely, Na₂O·M₂O _x , M₂O _x and metal sulphide and/or metal sulphate. The formation of Na₂O·M₂O _x depends upon the solid state solubility of metal oxide in the molten salt at high temperatures. Under limited solubility conditions Na₂O·M₂O _x is invariably formed, but as soon as this condition is relaxed the oxide. M₂O _x , precipitates and forms a separate phase.