Some experimental findings in compression-after-impact (CAI) tests of CF/PEEK (APC-2) and conventional CF/epoxy flat plates

Compression-after-impact (CAI) tests have been conducted for quasi-isotropic thick plates with 48 plies by using the NASA method and on plates with 32 plies by using the SACMA method. Specimens are made of CF/PEEK (APC-2) and conventional CF/epoxy for the NASA plates and CF/epoxy for the SACMA plates. In the NASA CAI tests, the sequence of delamination buckling and its propagation is clearly revealed through various experimental techniques. One major technique is moiré topography, and the other is thermo-mechanical stress analysis with a high-accuracy infrared sensor. The arrest of delamination propagation just before catastrophic failure due to high fracture toughness is clearly captured by the moiré camera. This behavior provides good CAI values of CF/PEEK. The initial buckling properties of the delaminated region by the impact are then extensively discussed. Numerical predictions of initial buckling stress have been obtained by modelled geometry of the delaminated region simplified from its precise structure clarified by ultrasonic C-scanning. They agree fairly well with the experimental results. The in-plane stress distribution in the delaminated region before initial buckling is measured by an infrared stress graphic system. This compared favorably with finite element predictions. Two types of symmetric buckling modes with respect to the central plate surface, twin and single peak ones, are experimentally captured.     

Characterization of temporal response, spectral responsivity and its spatial uniformity in photoconductive diamond detectors

Three photoconductive diamond detectors with highly oriented diamond (HOD) films fabricated by the same process were characterized with respect to temporal response, spectral responsivity and its spatial uniformity over the wavelength range from 190 to 250 nm. Temporal measurements showed a drift in the baseline, suggesting the presence of deep level carrier traps. The responsivity of specimen No. 2 was more than twice those of the other two specimens, but it showed an unpredictable current fluctuation. It was found that the spatial uniformities of all the specimens were too low for radiometric purposes. A prominent peak, thought to be due to photoemission, was found in the responsivity spatial distribution of specimen No. 3 under a negative applied voltage.     

Endogenous adenosine exerts inhibitory effects upon the development of spreading depression and glutamate release induced by microdialysis with high K+ in rat hippocampus

Spreading depression (SD) is known to be involved in the N-methyl-D-aspartate receptor-mediated neuronal damage. In urethane-anesthetized rats, we examined the release of adenosine and glutamate during SD induced by microdialysis of high K+ perfusate through the hippocampal CA1 area. The effects of endogenous adenosine upon SD were studied by applying an adenosine antagonist, theophylline (1 mM) and by a simultaneous application of adenosine uptake blockers, dipyridamole (DPR) (100 microM) and nitrobenzylthioinosine (NBI) (50 microM). The dialysates were sampled every 5 or 10 min and analyzed by HPLC. SD was identified by flattening of background EEg and disappearance of population spikes recorded from the pyramidal cell layer of CA1 area by a glass microelectrode. Adenosine and glutamate release was enhanced significantly in association with the occurrence of SD. Theophylline increased the release of glutamate and the incidence of SD and decreased the latency of the SD occurrence. DPR+NBI decreased the release of glutamate and the occurrence of SD, but increased extracellular adenosine concentration. The effects of DPR+NBI were blocked by application of a selective antagonist of adenosine A1 receptor, 8-cyclopentyl-1,3-dipropylxanthine (DPCPX, 0.1 microM). These findings suggest that endogenous adenosine exerts inhibitory influences upon the development of SD and the glutamate release through the A1 receptor in rat hippocampus.     

Distributed architecture for energy management D-structure

Electric power systems are expanding in size and complexity, and the requirement for the energy management system (EMS) is becoming more important. In this computer control system, a single control computer is used mainly as the primary computer and its software is very complicated because of its hugh number of small, quick tasks to obtain high response speed. Therefore, much effort is needed to develop and modify the programs, and the responsiveness of this centralized architecture varies greatly when many faults occur in the power system. This paper describes a new distributed architecture for the EMS. Distributed processors execute the functions cooperatively with periodic access to the common bulletin board database in which information about the power system exist. This architecture facilitates the software development and maintenance, and it also enhances the performance by the parallel processing of the distributed functions.     

A far-infrared spectroscopic study of low temperature soft phonon mode in Tris-Sarcosine Calcium Chloride(TSCC)

Temperature dependences of the soft phonon frequency and the damping constant in Tris-Sarcosine Calcium Chloride (TSCC) single crystal have been investigated between 5K and 100K by using a Fourier-transform far-infrared spectrometer. It has been observed that the soft phonon frequency decreases gradually and the damping constant increases as the transition temperature is approached from below The damping constant varies from 7cm^-1 a 90K to less than 0.5cm^-1 at 5K. It has been found that the damping constant is approximately proportional to temperature below about 60K.     

The elimination of hepatitis B virus infection: changing seroepidemiology of hepatitis A and B virus infection in Okinawa, Japan over a 26-year period

Serial changes in hepatitis A virus (HAV) and B virus (HBV) markers were determined from 1970 to 1996 in healthy Japanese residents of a rural area of Okinawa, Japan. All 190 serum samples taken in 1970, 791 in 1980, 708 in 1988, and 523 in 1996 from residents 0 to more than 60 years of age were tested for antibody to HAV (anti-HAV), antibody to hepatitis B core antigen (anti-HBc), and hepatitis B surface antigen (HBsAg). The age-adjusted prevalences of anti-HAV and anti-HBc decreased significantly from 83.9% and 74.9%, respectively, in 1970 to 39.7% and 36.6%, respectively, in 1996. In residents < or = 29 years of age, the prevalences of anti-HAV and anti-HBc decreased significantly from 65.3% and 83.8%, respectively, in 1970 to 0.7% and 8.2%, respectively, in 1996. The age-adjusted HBsAg prevalence decreased significantly from 8.2% in 1980 to 4.1% in 1988. These results indicate that exposure to HAV and HBV infections among Okinawa residents less than 29 years of age is decreasing, probably because of improvements in socioeconomic conditions since 1970. Infection with HBV may be eliminated there in the near future.     

Restriction fragment length polymorphism of genes of the alpha 2(XI) collagen, bone morphogenetic protein-2, alkaline phosphatase, and tumor necrosis factor-alpha among patients with ossification of posterior longitudinal ligament and controls from the Japanese population

STUDY DESIGN: The present study analyzed the restriction fragment length polymorphism patterns of alpha 2(XI) collagen, bone morphogenetic protein-2, alkaline phosphatase, and tumor necrosis factor-alpha genes in patients with ossification of the posterior longitudinal ligament. This study investigates the genetic polymorphism of bone-induced factors in patients with ossification of the posterior longitudinal ligament and compares it with healthy control subjects. OBJECTIVES: To clarify the genetic markers linked to ossification of the posterior longitudinal ligament. SUMMARY OF BACKGROUND DATA: Ossification of the posterior longitudinal ligament is a genetic disease associated with abnormal calcium metabolism involving the posterior longitudinal ligament. Previous genetic studies have not identified the pathologic mechanism of ossification of the posterior longitudinal ligament. Histopathologic studies of ossification of the posterior longitudinal ligament and the animal model, the spinal hyperostotic mouse, have revealed an increase in Type XI collagen and bone morphogenetic protein-2 expression. METHODS: Eighteen Japanese patients with ossification of the posterior longitudinal ligament and 51 healthy, unrelated control subjects were investigated for the restriction fragment length polymorphism patterns of COL11A2, bone morphogenetic protein-2, alkaline phosphatase, and tumor necrosis factor-alpha, genes with various restriction endonucleases. RESULTS: The gene frequencies of COL11A2 obtained with BamHl (10.0 kb fragment) and HindIII (19.0 kb fragment) observed in patients with ossification of the posterior longitudinal ligament were higher compared with control subjects (0.43 and 0.14, respectively). These differences were statistically significant (BamHl P = 0.018; Hindlll P = 0.046). Two new restriction fragment length polymorphism patterns were detected of the bone morphogenetic protein-2 gene with Mspl and Taql and one already known restriction fragment length polymorphism pattern of the tumor necrosis factor-alpha gene with Ncol. However, they were not significantly different from the control subjects. CONCLUSIONS: Seven restriction fragment length polymorphisms of COL11A2 gene were identified. Two of them (BamHl, 10.0/10.0 kb genotype; HindIII, 19.0/19.0 kb genotype) were significantly different in patients with ossification of the posterior longitudinal ligament.     

Preparation of rod-shaped BaTiO3 powder

Rod-shaped BaTiO₃ powder particles have been prepared from rod-shaped TiO₂ ·nH₂O and BaCO₃ in molten chloride. The morphology of BaTiO₃ particles was studied referring to the effects of the chemical species of the starting titanium compound, amount of chloride, particle size of the titanium compound and reaction conditions, and the preparation condition of rod-shaped BaTiO₃ has been determined: i.e., large TiO₂ ·nH₂O particles were heated at 700°C in molten salt with an equal amount of BaTiO₃. This condition was effective in suppressing the formation of BaTiO₃ by a solution-precipitation process as well as the deformation of either TiO₂ ·nH₂O or BaTiO₃, which are responsible for the formation of equiaxed BaTiO₃ particles. The obtained rod-shaped BaTiO₃ particles had a cubic symmetry. Electron diffraction analysis showed that the following topotactic relation is retained; 0 1 0_{potassium tetratitanate} 0 1 0_{hydrated titania} 1 0 0_anatase 1 0 0_{barium titanate}     

Growth of Al2O3 whiskers by vapour-phase reactions

Needle-like or wool-like Al₂O₃ whiskers can be grown on a substrate by the hydrolysis of aluminium fluoride vapour. Effects of the growth conditions on the morphology of the crystals and growth processes of the whisker were investigated, and the optimum growth condition of whiskers was examined. Adequate vapour pressure conditions of the reactant gases for the growth of the wool-like whisker were found to be . Aluminium oxyfluoride was assumed to be the most probable intermediate species for the growth of Al₂O₃ whiskers. A variety of crystal morphologies are also shown and described with respect to the experimental conditions.