Chromate leaching from inhibited primers: Part I. Characterisation of leaching

Leaching and characterisation studies have been undertaken on two chromate-inhibited epoxy polyamide primers. Leaching was carried out in 5% (w/v) NaCl solutions at different pH values (1, 3, 5 and 7) and the amount of Cr released into solution was monitored over time. Cr release was initially high, but as the immersion time increased the leaching from the primers slowed. Prior to and after immersion, the primers were characterised by a number of techniques including electron microprobe analysis, X-ray microdiffraction, Raman spectroscopy, and positron annihilation lifetime spectroscopy. The unexposed primers were found to contain the inorganic phases SrCrO₄, BaSO₄ and TiO₂ (anatase or rutile). Upon immersion, water uptake by the primers was observed, together with a decrease in the amount of SrCrO₄ in the primers. These studies provide insights into the mechanism of chromate leaching from inhibited primers.     

AIR STRIPPING AND DISSOLUTION RATES OF AROMATIC HYDROCARBON PARTICLES IN A BIOREACTOR

The design of bioremediation reactors for destroying toxic organic compounds requires an understanding of the mass transfer behavior of these chemicals into and out of the vessel. The dissolution rates and air stripping of three aromatic hydrocarbon particles were measured and theoretically modeled in a well mixed bioreactor with varying agitation speed, temperature, slurry concentration and air flow rate. It was confirmed that the dissolution rate of particles is influenced by both solubility and molecular structure. The volumetric mass transfer coeffcient of dissolution increased with higher agitation speeds and higher temperatures. This studyindicates that stripping from the liquid phase to the gas phase was controlled by physical properties: that is high Henry's law constant and relatively low solubility. The mechanistic model successfully predicted the disappearance of particles and the dissolved concentration of aromatic compounds due to simultaneous dissolution and air stripping.     

Activated extraction of coal using a hydrogen-donor solvent

The kinetics of the extraction of a high-volatile bituminous coal with 1,2,3,4-tetrahydronaphthalene (tetralin) under the influence of ultrasonic energy has been studied at five temperatures: from 47 to 87°C. The effects of intensity of ultrasonic energy, particle size, and hydrogen content of the coal were also recorded. Analysis of the results showed that a second-order reaction followed by a first-order reaction best describes the kinetics of the extraction process. The enthalpies of the second-order and first-order regions were respectively 8.7 and 2.5 kcal/mol, suggesting essentially physical control. The entropies were respectively ?44 and ?70 e.u. Auxiliary experiments and the kinetic data obtained suggest a model for the extraction process. The mechanism of the overall reaction is undoubtedly complex, but the data indicate that van der Waals and hydrogen-bonding forces are most affected by the ultrasonic energy, although stronger bonding is also affected giving much higher yields than would be expected. From the yields obtained in this study it is concluded that ultrasonic energy acts by rupturing bonds that are not affected by the solvent alone; the bonds affected are either strong hydrogen bonds or aliphatic covalent bonds, but not aromatic bonds.     

Sex pheromone specificity as a reproductive isolating mechanism among the sibling speciesArchips argyrospilus andA. mortuanus and other sympatric tortricine moths (Lepidoptera: Tortricidae)

MaleArchips argyrospilus (Walker) were maximally attracted to a 60404200 admixture of (Z)-11-tetradecenyl, (E)-11-tetradecenyl, (Z)-9-tetradecenyl and dodecyl acetates. The identification of (Z)-9-tetradecenyl acetate, in addition to the other 3 components reported previously, is the first report of a 4-component pheromone system in moths.Archips mortuanus Kearfoot, a sibling species, was maximally attracted to a blend of the same components, but in a 90101 mix of the tetradecenyl acetates. Among a number of tortricine moths that co-occur on apples and other hosts in New York, British Columbia, and elsewhere, differences in diel rhythms of attraction and seasonal distribution are insufficient to maintain reproductive isolation. Although the attractant systems of these species often possess components in common, males are maximally attracted to a speciesspecific blend. In tortricine moths attraction specificity appears to be a paramount mechanism for species partitioning.     

Transient Stability Enhancement of Multi–Machine Power Systems: Synchronization via Immersion of a Pendular System

In this paper the problem of designing excitation controllers to improve the transient stability of multi‐machine power systems is addressed adopting two new perspectives. First, instead of the standard formulation of stabilization of an equilibrium point, we aim here at the more realistic objective of keeping the difference between the generators rotor angles bounded and their speeds equal—which is called synchronization in the power literature—and translates into a problem of stabilization of a set. Second, we adopt the classical viewpoint of power systems as a set of coupled nonlinear pendula, and express our control objective as ensuring that some suitable defined pendula dynamics are (asymptotically) immersed into the power system dynamics. Our main contribution is the explicit computation of a control law for the two–machine system that achieves global synchronization. The same procedure is applicable to the n–machine case, for which the existence of a locally stabilizing solution is established.     

Restructuring butterfat through blending and chemical interesterification. 3. Rheology

Interesterified and noninteresterified butterfat-canola oil blends, ranging from 100% butterfat to 60∶40 butterfat-canola oil (w/w) in 10% increments, were evaluated for hardness index (HI), dropping point, viscosity, and viscoelastic properties at small deformation. Both blending and chemical interesterification diminished HI in a nonlinear fashion. HI changes in interesterified blends were more pronounced than in noninteresterified blends. Dropping points yielded information on the structure of the blends. Butterfat’s dropping point (DP) was 34.4°C, whereas that of interesterified butterfat was 37.0°C, which is indicative of a more structured network for the latter. DP values of blends with 60–90% butterfat (interesterified vs. noninteresterified) were not significantly different (P<0.05). Interesterified blends had a higher crystallization onset temperature than did noninteresterified blends. All blends in the liquid state displayed Newtonian behavior. Oscillatory frequency sweep measurements at small amplitude showed that interesterified blends generally had lower storage moduli (G′) than their noninteresterified counterparts. BothG′ andG″ were frequency-dependent. Replacement of 30% butterfat by canola oil led to notable changes in small deformation measurements, whereas replacement of 20% butterfat led to big changes in large deformation measurements.     

Practical Design Model for Calculating Bubble Diffuser Contactor Ozone Transfer Efficiency

Ozone transfer to water or wastewater is necessary before desirable, effective ozone reactions occur. Several factors affect ozone transfer efficiency, including water quality characteristics, contactor configuration, and applied ozone characteristics. The design model presented in this paper addresses all factors affecting ozone transfer. The model was used to compare measured transfer efficiency with predicted transfer efficiency at four full-scale wastewater ozone disinfection facilities. A relatively good prediction was obtained at each plant.

The paper presents an example calculation of ozone transfer efficiency. Also, the effect of changes to some of the factors affecting transfer efficiency is presented, such as changes in diffuser depth, plant elevation, ozone concentration, water quality (i.e., ozone demand), pH, detention time, temperature, and acombination of factors. The design model may be used to evaluate the effect of changes in plant design on transfer efficiency, but cannot provide an absolute value for transfer efficiency until difficult-to-measure parameters, such as bubble diameter, are known.     

The pheromone of the eastern tent caterpillar,Malacosoma americanum (F.) (lepidoptera,Lasiocampidae)

The pheromone system of the eastern tent caterpillar,M. americanum, has been identified as a mixture of (E,Z)-5,7-dodecadienal and the corresponding alcohol. Field data on the attractiveness of the aldehyde alone were not consistent, but mixtures of aldehyde and alcohol in varying proportions were attractive to males. Addition of small amounts ofE,Z acetate toE,Z aldehyde had no effect on male response, but larger amounts reduced trap catch. Traps baited withZ,E, E,E, orZ,Z aldehydes were not more attractive than blank traps. Pherocon IC traps fortified with extra adhesive and baited with lures consisting of 500 µg (E,Z)-5,7-dodecadienal with either 250 or 100 µg of the corresponding alcohol trapped as many as 100 males/trap/night with means of 15–20. Lures prepared from purified (94%E,Z) aldehyde and alcohol were more attractive than those prepared from unpurified (58%E,Z) materials.DeceasedMention of a company name or proprietary product does not constitute an endorsement by the U.S. Department of Agriculture.     

Intergranular oxidation of silicon in 20Cr-25Ni niobium-stabilized stainless steel at 1140–1230 K

The kinetics of intergranular oxidation of silicon in a 20Cr-25Ni Nb-stabilized stainless steel are reported, at temperatures in the range 1140–1230 K, in CO₂ at 40 bar pressure. The depth of attack increased parabolically with respect to time, with an activation energy of 335±30 kJ/mol. The mechanism of growth is discussed in terms of classical internal-oxidation theories, and an alternative explanation based on an available-space theory is developed. The internal oxidation rates in a number of different alloys are compared with diffusivities of metals in the base alloy. It is proposed that intergranular oxidation in the 20–25 Nb steel is controlled by the rate of outward diffusion of iron or chromium in the alloy.     

A new approach for mapping of Biological Soil Crusts in semidesert areas with hyperspectral imagery

Biological Soil Crusts (BSCs), consisting of cyanobacteria, algae, microfungi, lichens and bryophytes in varying proportions, live within or immediately on top of the uppermost millimeters of soil, where they form a more or less firm aggregation of soil particles and organisms. They mainly occur in soils of arid and semi-arid regions, which cover more than 35% of the earth's land surface and are assumed to play a major role as primary producers, C- and N-sinks and soil stabilizers.

In order to establish a methodology for mapping of BSCs, their spectral characteristics with respect to different crust types were analyzed. The resulting reflectance spectra of different crust types had a shallow absorption feature centered around 680 nm in common, in which they differed from the spectra of bare soil.

In October 2004, hyperspectral CASI data with a spatial resolution of 1 m were recorded in conjunction with field spectroscopic measurements in the Succulent Karoo, South Africa. Available spectral indices for Biological Soil Crusts were tested on the image but did not produce satisfying classifications. Therefore, an alternative approach was established based on spectral field data, field observations and the hyperspectral dataset. The newly developed Continuum Removal Crust Identification Algorithm (CRCIA) is based on small and narrow spectral characteristics, that were extracted by continuum removal and subsequently expressed as a set of logical conditions. Using this method, 16.2% of the area which covers 12 km² of gently sloping hills with some granite outcrops were classified as BSCs. Validation of the classification resulted in a Kappa index of 0.831.

In a next step, the methodology will be tested with regard to scale-dependent effects and applied to images covering areas with additional types of BSCs and soil to develop a robust and generally applicable method.