Iodine reaction of vinyl acetate/vinyl propionate copolymers. III. Iodine affinities of the radically polymerized copolymers and the copolymers derived from partially saponified polyvinyl acetate

The minimum sequence lengths (n_c) of vinyl acetate (VAc) units necessary to form a colored iodine complex were determined to be 4 and 17 for radically polymerized VAc/vinyl propionate (VPr) and VAc/isopropenyl acetate (IPAc) copolymers, respectively. The iodine affinities (I/VAc) of VAc/VPr copolymers (SP-series) obtained by propionylation of partially saponified polyvinyl acetate (PVAc) were remarkably affected by the saponification conditions. An increase of the water content in acetone/water mixture as saponification solvent brought about a decrease of the iodine affinities of the SP-series. The dependence of the iodine affinity on the saponification of monomer units in the SP-series was compared with that in the radically polymerized VAc/VPr copolymers by taking the sequence probability as the measure of monomer unit distribution. The results strongly supported an occurence of the slide fastener reaction at high degrees of saponification, which was well-known in the saponification of PVAc. Furthermore, it was found that the saponification mode of PVAc at low degrees of saponification was influenced uniquely by the water content in saponification solvents and the saponification temperature.     

Novel method of preparing Ag–Hg alloy on polyacrylamide films and their structure

A novel method is proposed of preparing thin Ag–Hg alloy on PAAm film surface at room temperature: The film of interest is formed by holding PAAm aqueous solution with AgNO₃ in Hg-saturated atmosphere. Two kinds of films, one of which is a conductor and the other an insulator, can be selectively formed with pH-controlled PAAm solution by ammonia. The conducting surface is assigned to the α phase of Ag–Hg alloy by means of X-ray analysis. Potentiometric titration and IR spectral studies suggest the existence of PAAm–Ag⁺ complexes. On the basis of their structure and the oxidation and reduction potential of Ag⁺ and Hg²⁺, the mechanism of film formation is also discussed.     

Skeletonized hybrid liposomes

Summary Giant hybrid liposomes of polymerizable lipid and cholesterol were prepared by the hydration method and were polymerized by UV irradiation. The obtained giant liposomes were freeze-dried and washed with chloroform to skeletonize the frame structure of the polymerized membrane. The skeletonized liposomes were directly confirmed by scanning electron microscopy. The single-layered and fully spherical liposome frame were easily confirmed by the stereo-pair of the obtained micrographs.     

Temperature Dependence of KIC for High-Pressure Hot-Pressed Si3N4 Without Additives

Temperature dependence of K_IC values for Si₃N₄ bodies sintered at high pressures without additives was studied from room temperature to 1400°C. Little change in K_K was found in this range.     

Balanced corpus of contemporary written Japanese

The balanced corpus of contemporary written Japanese (BCCWJ) is Japan’s first 100 million words balanced corpus. It consists of three subcorpora (publication subcorpus, library subcorpus, and special-purpose subcorpus) and covers a wide range of text registers including books in general, magazines, newspapers, governmental white papers, best-selling books, an internet bulletin-board, a blog, school textbooks, minutes of the national diet, publicity newsletters of local governments, laws, and poetry verses. A random sampling technique is utilized whenever possible in order to maximize the representativeness of the corpus. The corpus is annotated in terms of dual POS analysis, document structure, and bibliographical information. The BCCWJ is currently accessible in three different ways including Chunagon a web-based interface to the dual POS analysis data. Lastly, results of some pilot evaluation of the corpus with respect to the textual diversity are reported. The analyses include POS distribution, word-class distribution, entropy of orthography, sentence length, and variation of the adjective predicate. High textual diversity is observed in all these analyses.     

Fatigue behavior of medium-density polyethylene pipes

A round bar specimen and a square bar specimen cut out from medium-density polyethylene pipes with a notch were made and a fatigue test was conducted to cause a brittle fracture. The initiation and growth of a craze and crack at the tip of a notch was observed. In the range where loading cycles are few and displacement of the specimen does not increase, the craze prior to crack initiation occurs. Also, the effect of frequency was investigated. The pure creep failure and the fatigue failure at low frequency were compared. The lower the frequency, the smaller the reciprocal of the actual loading time T_f becomes. It is also found that this tensile fatigue test is a useful test method to assure the quality of pipes.     

Interactions oftrans-cinnamic acid,its related phenolic allelochemicals,and abscisic acid in seedling growth and seed germination of lettuce

Phenolic compounds have been identified as the most common allelochemicals produced by higher plants. Inhibitions of cinnamic acid, its related phenolic derivatives, and abscisic acid (ABA) on seedling growth and seed germination of lettuce were studied.trans-Cinnamic acid, ando-,m-, andp-coumaric acids inhibited the growth of etiolated seedlings of lettuce at concentrations higher than 10^–4 M and seed germination above 10^–3 M. Coumarin inhibited seedling growth and seed germination at 10^–5 M or above. Chlorogenic acid inhibited seedling growth above 10^–4 M, but did not inhibit seed germination at 10^–5–5×10^–3 M. Low concentrations (below 10^–3 M) of caffeic and ferulic acids promoted the elongation of hypocotyls, but higher concentrations (over 10^–3 M) inhibited seedling growth and seed germination. These phenolic compounds and abscisic acid had additive inhibitory effects both on seedling growth and seed germination. The inhibition on lettuce was reversed by caffeic and ferulic acids at concentrations lower than 10^–3 M except for the inhibition of germination by coumarin. These results suggest that in naturetrans-cinnamic acid,o-, m-, p-coumaric acids, coumarin, and chlorogenic acid inhibit plant growth regardless of their concentration. However, caffeic and ferulic acids can either promote or inhibit plant growth according to their concentration.     

Diffusion/adsorption model of cellulose dyeing. II. Ordinary cellulose–direct dye system

The diffusion and adsorption of C.I. Direct Yellow 12 and Blue 15 in water-swollen ordinary cellophane sheets were examined at various ionic strengths. The concentration dependence of apparent diffusion coefficients, D_c, for these dyes was obtained from the diffusion profiles in the substrate, which were measured by the use of the cylindrical film roll method. The decrease of apparent porosity with an increase in the amounts of adsorption was observed. To explain the diffusion/adsorption behaviors of these systems, a variable porosity model was proposed and was applied to analyze the concentration dependence of D_c's. The diffusion/adsorption behaviors of these dyes could be quantitatively described by this model at relatively low ionic strengths. At higher ionic strengths and/or lower values of C, i.e., at the large values of C_im/C_m, where the C's are the concentrations of immobilized (suffix im) and mobile (suffix m) species, it needed to introduce the concept of dynamic equilibria which occurred simultaneously with diffusion but deviated from the true equiliblia measured by the adsorption experiments.     

Thermal Expansion of Solid Solutions in the ZrTiO4—In2O3—M2O5 (M = Sb, Ta) System

Axial and dilatometric thermal expansions and phase transformations were studied for solid solutions having the α-PbO₂ structure in the ZrTiO₄—In₂O₃—M₂O₅ (M = Sb, Ta) system with nominal formulas of Zr _x Ti _y In _z Sb _z O₄ and Zr _x Ti _y In _z Ta _z O₄ where x + y + 2 z = 2. With increased substitution of z , the cell volume increased, the difference in the b parameters at room temperature between those quenched from 1400° and 1000°C decreased, and the thermal expansion decreased. The axial thermal expansion of ZrTi _y In _z · Ta _z O₄ with z = 0.3 was almost identical with that of HfTiO₄, and those with z = 0.4 and z = 0.45 were smaller than that of HfTiO₄. Unit-cell volumes of these compound were compared with those of single oxides to make it clear that the unit-cell volume of ZrTiO₄ was small anomalously and to distinguish the normal and abnormal substitution systems. These results were explained by the working hypothesis proposed for these compounds.     

Glass transition behavior of emulsion-polymerized polymer films containing a surface-active agent

The glass transition behavior of emulsion-polymerized poly(methyl methacrylate) and polystyrene films containing sodium laurylsulfate as emulsifier was studied by measurements of dynamic mechanical properties and thermal depolarization current. The film specimens of the emulsion-polymerized polymers were prepared by casting from their benzene solutions. The glass transition temperatures of the emulsion-polymerized films are higher than those of the bulk-polymerized films. The higher glass transition temperature of the emulsion-polymerized films is attributed to the colloidal properties of sodium laurylsulfate in the process of the film formation. The restriction of the molecular chains in the emulsion-polymerized films is attributed to the interaction between the hydrophobic groups of sodium laurylsulfate and the polymer molecules.