Invasiveness of LiTaO/sub 3/ and GaAs probes in external E-O sampling

Disturbances of signals on a coplanar waveguide (CPW) induced by the presence of LiTaO/sub 3/ and GaAs electrooptic probes in external electrooptic (EO) sampling have been simulated and compared quantitatively. The finite-difference-time-domain method is used to simulate the full wave field around a coplanar waveguide on a GaAs substrate in an external EO sampling configuration. The results indicate that the induced signal disturbance, or invasiveness, of a LiTaO/sub 3/ probe is almost ten times that of a GaAs probe in terms of the magnitude of S/sub 11/, but that LiTaO/sub 3/ yields about two times the EO response for a given S/sub 11/ and optical probing wavelength. The transparency of LiTaO/sub 3/ to shorter wavelengths, however, allows an even higher sensitivity for this material relative to GaAs. The results suggest that these probes do not exhibit significant invasiveness (magnitude of S/sub 11/ smaller than -40 dB), if they are removed from contact by the distance of CPWs center conductor width.<>     

Effect of silver addition on superconductivity in the Bi1.6Pb0.4Sr1.6Ca2Cu3O10−y system

Silver/superconductor composites containing 0 to 80 vol% silver have been prepared and their properties determined. Optimum heat treatment at sintering temperatures ( 800° C) under low oxygen pressures produces material with high critical current density and improves physical properties. Magnetic susceptibility measurements have been found to be consistent with resistivity results. In order to retain a single high-T _c phase with increasing silver content, decreased oxygen partial pressures are required. Using the normal-state resistivity of these composites, a percolation threshold at a silver volume fraction of 43% was observed, while zero resistivity measurements show that a continuous superconducting network can be obtained with up to 80 vol% silver. The critical current density of 21 vol% silver-doped samples was found to be 1520 A cm^–2 at 77.3 K, compared to 260 A cm^–2 for an undoped sample.     

Site occupations and ordering behaviour of O phase in Ti2AlNb—based intermetallics

1　ＩＮＴＲＯＤＵＣＴＩＯＮＴｈｅｏｒｔｈｏｒｈｏｍｂｉｃａｌｌｏｙｓａｒｅｏｆｇｒｅａｔｔｅｃｈ ｎｏｌｏｇ ｉｃａｌｉｎｔｅｒｅｓｔｉｎｈｉｇｈｔｅｍｐｅｒａｔｕｒｅａｐｐｌｉｃａｔｉｏｎｓｓｉｎｃｅｔｈｅｙｈａｖｅａｇｏｏｄｂａｌａｎｃｅａｍｏｎｇｓｔ     

Facile synthesis of nitrogen and oxygen co-doped hierarchical porous carbon materials for high performance super capacitors

Journal of Porous Materials - Nitrogen and oxygen co-doped hierarchical porous carbons (NOPCs) is prepared by the pyrolysis of polyethylene glycol-200 (PEG) and triazine carbon forming agent (CFA)...     

用CAXA电子图板求解冲模压力中心

在模具设计中 ,冲裁模压力中心通常采用解析法或图解法求解。本文提出一种用CAXA绘图软件在设计制图时直接求解的方法 ,快速直接 ,简单方便 ,精度较高。     

环氧氯丙烷下游产品生产现状及市场前景

论述了环氧氯丙烷的主要下游产品环氧树脂、合成甘油、氯醇橡胶等的生产现状、市场前景等,指出:我国氯碱行业应该重视这些环氧氯丙烷下游精细化工产品的开发,以促进我国环氧氯丙烷的发展。     

Influence of volatile matter and deposited carbon on coke yield from coals

The relations between coke yields and the volatile matter content of 30 individual and 30 blended coals were investigated. Coke yields and deposited carbon related to volatile matter content can be expressed in the following equations: CY (%) = 97.89?0.86 VMch+VMc; and DC (%)= ?2.24+0.16 VMch; where: CY=real coke yield; VMch = volatile matter content of charging coal; VMc=volatile matter content of coke, and in the case of <2%; DC = deposited carbon. The test results show excellent correlation with practice.     

中国观赏石文化与收藏

以推动人类文明进步发展的观念为先导,以详实的地质学、岩石学、石文化史料为切入点,介绍了我国观赏石文化的起源、发展及现状;阐述了赏石审美的本质、形式、石体标准、传统性、现代性等理论要点及其以小见大、以丑为美的审美理念。对赏石修身养性、以石陶情及赏石文化与道教情结的学术价值进行了评述;对从古至今的中华文化名人为赏石理论的创立、鉴赏、收藏和发展作出的不可磨灭的历史贡献进行了评价。     

用预分解技术改造Φ4×60m预热器窑的又一成功实例

介绍南京水泥工业设计研究院用预分解生产技术对山东水泥厂Φ4×60m预热器窑烧成系统进行的成功技术改造。技改设计指标为：熟料产量保证指标1500t／d，争取指标1700t／d，熟料热耗＜3762kJ／kg，熟料28d抗压强度＞60MPa。整个工程停产施工耗时仅用48d，烧成系统技改共耗资约3000万元。技改后一次点火投料成功，且点火当月即实现72h达标考核，所有设计指标均达标。     

如何提高预焙铝电解槽阳极质量

预焙阳极的质量已严重制约铝电解技术的发展，必须予以足够的重视．国外在提高阳极质量方面的有效措施，可以供国内阳极工厂技术改造及科研攻关借鉴．