Multichannel frequency conversion experiment using fibre four-wave mixing

Multichannel frequency conversion is demonstrated using four-wave mixing. A polarisation independent configuration is employed, by which polarisation control for each signal is not necessary. By setting the pump light frequency at the zero-dispersion wavelength of the fibre, three FSK modulated signals with a frequency spacing of 70 GHz are simultaneously converted with an equal efficiency of -27.5 dB. Bit error rate measurements confirm the feasibility of this conversion scheme.<>     

A High-Speed, High-Sensitivity Digital CMOS Image Sensor With a Global Shutter and 12-bit Column-Parallel Cyclic A/D Converters

This paper presents a high-speed, high-sensitivity 512times512 CMOS image sensor with column parallel cyclic 12-bit ADCs and a global electronic shutter. Each pixel has a charge amplifier for high charge-to-voltage conversion gain despite of using a large-size photodiode, and two sample-and-hold stages for the global shutter and fixed pattern noise (FPN) canceling. High-speed column-parallel cyclic ADC arrays with 12-bit resolution having a small layout size of 0.09 mm ² are integrated at both sides of image array. A technique for accelerating the conversion speed using variable clocking and sampling capacitance is developed. A digital gain control function using 14-bit temporal digital code is also set in the column parallel ADC. The fabricated chip in 0.25-mum CMOS image sensor technology achieves the full frame rate in excess of 3500 frames/s. The in-pixel charge amplifier achieves the optical sensitivity of 19.9 V/lxmiddots. The signal full scale at the pixel output is 1.8 V at 3.3-V supply and the noise level is measured to be 1.8mV_rms, and the resulting signal dynamic range is 60 dB     

Compositional design of Pb(Zr, Ti)O3 for highly reliableferroelectric memories

We have investigated Pb(Zr,Ti)O₃ (PZT) film composition suitable for highly reliable ferroelectric RAM (FeRAM) application. To obtain a wide operational margin for 2T/2C (two transistors and two capacitors) FeRAMs, the PZT film capacitor is needed to have a low coercive voltage (V_c) and a high dielectric constant on the polarization switching (ϵ_S) and a low dielectric constant on the nonswitching (ϵ_N), or essentially a large ϵ_S/ϵ_N ratio. Concerning the B-site composition in the perovskite structure, it is found that lowering the Zr/Ti ratio from 47/53 to Ti-richer ones increases the ratio of ϵ_S/ϵ_N as a positive effect on the wide operational margin, but increased V_c as a negative effect. Taking the balance of these factors into consideration, it is concluded that an optimum composition, such as Zr/Ti=30/70, provides the maximum operational margin. The A-site composition, on the other hand, affects the long-term reliability of a PZT capacitor. The endurance to the fatigue and imprint are enhanced by reduction of the Pb-excess and dope of La in the A-site. A La-doped PZT (Zr/Ti =30/70) capacitor is successfully integrated to the 8 kbit FeRAM macro with double-layer Al wiring to confirm the feasibility of this capacitor     

Implementation in Japan [ISDN]

INS-Net, Nippon Telegraph and Telephone's (NTT's) commercial integrated services digital network (ISDN) service, is described. There are two types of INS-Net service. INS-Net 64 provides basic rate interface service, and INS-Net 1500 provides primary rate interface service. The implementation of INS-Net and the promotion, application, and penetration of ISDN services are discussed. It is argued that as the number of useful applications grows, the number of subscribers will rise accordingly, particularly among business users. This increased volume of both applications and users will in turn lead to lower ISDN CPE costs, and will make ISDN an indispensable means to business activities in the 1990s     

Waveguide polarization-independent optical circulator

We fabricated a new type of waveguide polarization-independent optical circulator which does not need a polarization-beam splitter. The circulator is based on a non-reciprocal Mach-Zehnder interferometer which consists of two waveguide Faraday rotators, two thin-film half-waveplates and two planar lightwave circuit-type 3-dB couplers. The fabricated circulator provides a 14.0-23.7-dB isolation and a 3.0-3.3 dB insertion loss at λ=1.55 μm. This circulator presents a new possibility for developing non-reciprocal devices in the field of integrated optics     

Transverse-junction-stripe GaAs-AlGaAs lasers for squeezed lightgeneration

We fabricated 850-nm GaAs transverse-junction-stripe (TJS) lasers by an improved metal-organic chemical vapor deposition (MOCVD) and double Zn diffusion process. The high V/III ratio used during the MOCVD growth significantly reduced the intermixing of GaAs active layer and AlGaAs cladding layers. The modified process realized good confinement for both carriers and photons and smaller saturable loss. We measured squeezing of -2.8 dB (-4.5 dB after correction for detection efficiency) at a pumping rate of I/I_th≈20 from these lasers, which is in close agreement with the theoretical limit. This squeezing remained unchanged under injection locking, indicating almost perfect conservation of the intensity noise correlation among the longitudinal modes. These TJS lasers had very small low-frequency 1/f noise     

Interactive multimedia communication systems for next-generationeducation using asymmetrical satellite and terrestrial networks

We propose a new concept of a hierarchical network structure for remote education. This system combines broadband satellite networks and simple terrestrial communication networks effectively to meet the demands of point-to-multipoint communications. Remote education experiments have been conducted using the proposed satellite communication networks. The results of network characteristics and degree of satisfaction are discussed. Acceptable communication quality was achieved ensuring an interactive lecture environment     

Association of cytoskeletons with the Golgi apparatus: three-dimensional observation and computer-graphic reconstruction

The association of cytoskeletons with the Golgi apparatus (GA) in cultured 3Y1 cells was investigated by stereo electron microscopy of thick sections and computer-graphic reconstruction of serial thin sections. The 3-dimensional analysis has demonstrated that: 1) both microtubules (MT) and vimentin intermediate filaments (IF) were abundantly present in close vicinity to GA, and some of them were closely associated with GA; and 2) such GA-associated cytoskeletons were attached to GA either at their termini or at their lateral side. The present observations suggest that both MT and vimentin IF are responsible for maintaining the structural integrity of GA.     

A New Public-Key Cryptosystem over a Quadratic Order with Quadratic Decryption Time

We present a new cryptosystem based on ideal arithmetic in quadratic orders. The method of our trapdoor is different from the Diffie—Hellman key distribution scheme or the RSA cryptosystem. The plaintext m is encrypted by mp ^r , where p is a fixed element and r is a random integer, so our proposed cryptosystem is a probabilistic encryption scheme and has the homomorphy property. The most prominent property of our cryptosystem is the cost of the decryption, which is of quadratic bit complexity in the length of the public key. Our implementation shows that it is comparably as fast as the encryption time of the RSA cryptosystem with e=2 ¹⁶ +1 . The security of our cryptosystem is closely related to factoring the discriminant of a quadratic order. When we choose appropriate sizes of the parameters, the currently known fast algorithms, for example, the elliptic curve method, the number field sieve, the Hafner—McCurley algorithm, are not applicable. We also discuss that the chosen ciphertext attack is not applicable to our cryptosystem. Received 29 June 1998 and revised 15 November 1998