Laser irradiation of oligosiloxane copolymer thin films functionalized with side chain bulky carbosilane moieties

Linear oligosiloxanes functionalized with bulky side chain tris(trimethylsilyl)hexyl (TTSH) substituents were transformed into cross-linked materials by UV 193 nm excimer pulsed laser ablation. The process occurred without any catalyst, by reactions of radicals formed in UV laser induced photolysis of side tris(trimethylsilyl)hexyl groups. Chemical changes were monitored by FTIR, LC/UV, GC/MS and solubility tests.     

A formal model of composing components: the TLA+ approach

In this paper, a method for writing composable TLA⁺ specifications that conform to the formal model called Masaccio is introduced. Specifications are organized in TLA⁺ modules that correspond to Masaccio components by means of a trace-based semantics. Hierarchical TLA⁺ specifications are built from atomic component specifications by parallel and serial composition that can be arbitrary nested. While the rule of parallel composition is a variation of the classical joint-action composition, the authors do not know about a reuse method for the TLA⁺ that systematically employs the presented kind of a serial composition. By combining these two composition rules and assuming only the noninterleaving synchronous mode of an execution, the concurrent, sequential, and timed compositionality is achieved.     

Aerodynamic optimization via multi-objective micro-genetic algorithm with range adaptation,knowledge-based reinitialization,crowding and ε-dominance

In this study, an optimization of the airfoil of a sailplane is carried out by a recently developed multi-objective genetic algorithm based on microevolution, containing crowding, range adaptation, knowledge-based reinitialization and ε-dominance. Its efficiency was tested on a set of test problems. The results are encouraging, suggesting that very small populations can be used effectively to solve real-world multi-objective optimization problems in many cases of interest.     

An electronically tunable current-mode quadrature oscillator using PCAs

This article presents a new realisation of active RC sinusoidal oscillator with electronically tunable condition and frequency of oscillation (FO). As compared to the class of three resistors, two capacitors (3R-2C)-based canonic oscillators, the circuit proposed here uses only two resistors and two capacitors as the passive components and still provides non-interactive tuning laws for the condition of oscillation and the FO. The proposed circuit employs new bipolar programmable current amplifier as the active building block and is capable of simultaneously providing two explicit quadrature current outputs. SPICE simulation results have been included to verify the workability of the circuit as an oscillator and the tuning range of the FO.     

New resistorless and electronically tunable realization of dual-output VM all-pass filter using VDIBA

In this paper, a new active element called voltage differencing inverting buffered amplifier (VDIBA) is presented. Using single VDIBA and a capacitor, a new resistorless voltage-mode (VM) first-order all-pass filter (APF) is proposed, which provides both inverting and non-inverting outputs at the same configuration simultaneously. The pole frequency of the filter can be electronically controlled by means of bias current of the internal transconductance. No component-matching conditions are required and it has low sensitivity. In addition, the parasitic and loading effects are also investigated. By connecting two newly introduced APFs in open loop a novel second-order APF is proposed. As another application, the proposed VM APF is connected in cascade to a lossy integrator in a closed loop to design a four-phase quadrature oscillator. The theoretical results are verified by SPICE simulations using TSMC 0.18 μm level-7 CMOS process parameters with ±0.9 V supply voltages. Moreover, the behavior of the proposed VM APF was also experimentally measured using commercially available integrated circuit OPA860 by Texas Instruments.     

New voltage-mode universal filter and sinusoidal oscillator using only single DBTA

In this article, a new voltage-mode second-order universal frequency filter and sinusoidal oscillator using only single differential-input buffered and transconductance amplifier (DBTA) is presented. The proposed voltage-mode filter structure using single DBTA and four passive elements can provide all standard filter functions, i.e. low-, band-, high-pass, band-stop, and all-pass without changing the circuit topology and enables independent control of the quality factor Q using single passive element. The circuit requires the minimal number of active and passive elements with no conditions for component matching. By slight modification of the proposed filter structure, the new DBTA-based sinusoidal oscillator is easily obtained. The oscillation condition and the oscillation frequency are independently adjustable by different virtually grounded passive elements. The proposed sinusoidal oscillator employs only grounded capacitors. The passive and active sensitivities of all the proposed circuit configurations are low. PSPICE simulations using a BJT realisation of DBTA and experimental results based on commercially available amplifiers OPA860 and MAX436 are included, which prove the workability of the proposed circuits.     

Advances in reflective oxygen saturation monitoring with a novel in-ear sensor system: results of a human hypoxia study

Pulse oximetry is a well-established, noninvasive photoplethysmographic method to monitor vital signs. It allows us to measure cardiovascular parameters, such as heart rate and arterial oxygen saturation, and is considered an essential monitoring tool in clinical routine. However, since many of the conventional systems work in transmission mode, they can only be applied to the thinner or peripheral parts of the body, such as a finger tip. This has the major disadvantage that, in case of shock-induced centralization and a resulting drop in perfusion, such systems cannot ensure valid measurements. Therefore, we developed a reflective in-ear sensor system that can be worn in the ear channel like a headphone. Because the sensor is integrated in an ear mold and positioned very close to the trunk, reliable measurement is expected even in case of centralization. An additional advantage is that the sensor is comfortable to wear and has considerable resistance to motion artifacts. In this paper, we report on hypoxia studies with ten healthy participants which were performed to analyze the system with regard to the detection of heart rate and arterial oxygen saturation. It was shown earlier that, due to the high signal quality, heart rate can easily be detected. Using the conventional calculation principle, based on Beer-Lambert's law combined with a single-point calibration method, we now demonstrate that the detection of arterial oxygen saturation in the human ear canal is possible using reflective saturation sensors.     

Voltage-mode multifunction filter with mutually independent Q and \omega _0 control feature using VDDDAs

The paper focuses on the application possibilities of the newly presented voltage differencing active building block called voltage differencing differential difference amplifier. Using this active element, a multifunction frequency filter is designed featuring the possibility of mutually independent control of quality factor Q and characteristic frequency \(\omega _0\) by means of active elements. The structure of the filter is based on the idea of the Akerberg-Mossberg (AM) filter, i.e. the integrators in the structure are always realized only by two active elements. This fact results in better phase compensation for the filter. Compared to the AM opamp based filter, the newly proposed structure features high-impedance inputs, low-impedance output, and all basic frequency responses. The performance of the proposed structure has been verified by SPICE simulations using the TSMC \(0.18\,\upmu \hbox {m}\) level-7 SCN018 CMOS process parameters with \(\pm 0.9\,\hbox {V}\) supply voltage.     

Cultivar differences of total anthocyanins and anthocyanidins in red and purple-fleshed potatoes and their relation to antioxidant activity

Total anthocyanins (TAC) and individual anthocyanidins (AN) after hydrolysis were measured in 15 red and purple-fleshed potato cultivars produced in five different locations in the Czech Republic and a new cultivar Blaue St. Galler from Switzerland. It was found that TAC, expressed as cyanidin content, varied between 0.7 mg 100 g⁻¹ FW (cv. Blue Congo) and 74.3 mg 100 g⁻¹ FW (cv. Blaue Ludiano). Major differences in cultivars were found for AN relative abundance. For cv. Highland Burgundy Red a high proportion of pelargonidin (98.7%) was characteristic, whereas cv. British Columbia Blue contained almost exclusively cyanidin. Cultivars Violette and Vitelotte showed a relatively high content of malvidin. Cultivar Shetland Black differed from others with its higher content of peonidin (on average 36.7%). High petunidin abundance in the cultivars Valfi, Blue Congo, Salad Blue, Blaue St. Galler, Blaue Hindel Bank, Blaue Ludiano, Blaue Schweden, Farbe Kartoffel and Salad Red was found. TAC and AN contents highly corresponded with antioxidant activity (AA) determined with the ABTS, FRAP and DPPH assays in vitro. High AA was shown by the cultivars Vitelotte, Violette, Blaue Ludiano, Hafija, and Highland Burgundy Red. Increased height above sea level, higher annual sum of precipitation, and lower annual average temperatures caused higher AA and TAC. A high degree of hydroxylation and/or methoxylation of individual anthocyanidins could contribute in conjunction with other phenolics to high AA (peonidin, delphinidin and malvidin in the cultivars Blue Congo, Highland Burgundy Red and Shetland Black). Consequently, new red and purple-fleshed cultivars with high TAC and highly methoxylated and/or hydroxylated AN could be a promising source of favourable antioxidants in human nutrition.     

Distribution of isoflavones and coumestrol in neglected tropical and subtropical legumes

BACKGROUND: Isoflavones and coumestrol from dietary legumes are plant constituents showing multiple beneficial effects on humans. Owing to their ability to bind with mammalian estrogenic receptors and thereby intervention in several kinds of hormone‐related cancers, they have received much attention. Soybean (Glycine max) is currently the major source of isoflavonoids in human diet. However, dozens of tropical and subtropical leguminous species remain unexplored for their isoflavonoids content. RESULTS: We have analyzed 55 extracts from 41 tropical and subtropical legume species used either in human or animal diet by high‐performance liquid chromatography for the content of soy isoflavones, biochanin A, daidzein, daidzin, formononetin, genistein, genistin, sissotrin, ononin and the coumestan coumestrol. Genistein and biochanin A were the most abundant compounds. The highest content of genistein was found in aerial parts of Andira macrothyrsa, seeds of Pachyrhizus tuberosus and aerial parts of Calopogonium mucunoides (598, 250 and 184 µg g^?1, respectively) and biochanin A in aerial parts of Cratylia argentea, C. mucunoides and flowers of A. macrothyrsa (76, 53 and 40 µg g^?1, respectively). CONCLUSION: None of the samples tested was richer overall source of soy isoflavones and coumestrol than soybean; nevertheless several species (C. mucunoides or A. macrothyrsa) may serve as a promising source of individual compounds. © 2012 Society of Chemical Industry