Effects of early-postmortem glycolytic rate on beef tenderness

Electrical stimulation (ES) was applied at 500 V to one side from each of 60 beef carcasses at 30 to 40 min postmortem. Wide ranges of early-postmortem glycolytic and cooling rates were produced in the musculature by use of three different forms of ES (in addition to non-ES treatment of the contralateral sides) and application of chilling routines of four different degrees of severity. Panel and Warner-Bratzler shear evaluations of loin steaks from all 120 sides showed that tenderness was highest when glycolysis had proceeded at an intermediate rate (corresponding to the attainment of a 3-h pH of about 6·1) and was appreciably lower on both sides of this mid-value. The toughening effect of rapid glycolysis (relative to that of a moderately increased glycolytic rate) persisted through 14 days of aging at 2°C.

These observations appear to be incompatible with the view that lysosomal enzymes contribute significantly to ES-induced tenderization. They also indicate that the effect of ES on tenderness is highly dependent on the subsequent cooling rate, very slow chilling sometimes accelerating the already high rate of pH fall to such an extent that the tissue is significantly toughened. Finally, they suggest that the goal of maximizing the early-postmortem rate of pH decline in bovine muscle is misguided and, if attained, will cause sub-optimal tenderness.     

Effects of 2-Hz and 60-Hz electrical stimulation on the microstructure of beef

A comparative electron-microscope study was made of the structural changes brought about in bovine longissimus dorsi muscle by 2-Hz and 60-Hz electrical stimulation. Apart from the frequency difference, the two treatments were identical: 500V AC, 600 pulses (2Hz × 300s and 60 Hz × 10 s), and a time of application of about 40 min post mortem. The low-frequency current produced no detectable tissue disruption or irregularity in sarcomere length, whereas the 60-Hz treatment caused widespread supercontraction and the formation of contraction nodes; many sarcomeres in the internodal zones were stretched or fractured. The observations confirm and extend those of our earlier light-microscope study, and support the view that fiber disruption contributes significantly to the tenderizing effect of high-voltage electrical stimulation.     

Non-Coding RNAs Set a New Phenotypic Frontier in Prostate Cancer Metastasis and Resistance

Prostate cancer (PCa) mortality remains a significant public health problem, as advanced disease has poor survivability due to the development of resistance in response to both standard and novel therapeutic interventions. Therapeutic resistance is a multifaceted problem involving the interplay of a number of biological mechanisms including genetic, signaling, and phenotypic alterations, compounded by the contributions of a tumor microenvironment that supports tumor growth, invasiveness, and metastasis. The androgen receptor (AR) is a primary regulator of prostate cell growth, response and maintenance, and the target of most standard PCa therapies designed to inhibit AR from interacting with androgens, its native ligands. As such, AR remains the main driver of therapeutic response in patients with metastatic castration-resistant prostate cancer (mCRPC). While androgen deprivation therapy (ADT), in combination with microtubule-targeting taxane chemotherapy, offers survival benefits in patients with mCRPC, therapeutic resistance invariably develops, leading to lethal disease. Understanding the mechanisms underlying resistance is critical to improving therapeutic outcomes and also to the development of biomarker signatures of predictive value. The interconversions between epithelial-to-mesenchymal transition (EMT) and mesenchymal-to-epithelial transition (MET) navigate the prostate tumor therapeutic response, and provide a novel targeting platform in overcoming therapeutic resistance. Both microRNA (miRNA)- and long non-coding RNA (lncRNA)-mediated mechanisms have been associated with epigenetic changes in prostate cancer. This review discusses the current evidence-based knowledge of the role of the phenotypic transitions and novel molecular determinants (non-coding RNAs) as contributors to the emergence of therapeutic resistance and metastasis and their integrated predictive value in prostate cancer progression to advanced disease.     

The AFLATOX® Project: Approaching the Development of New Generation,Natural-Based Compounds for the Containment of the Mycotoxigenic Phytopathogen Aspergillus flavus and Aflatoxin Contamination

The control of the fungal contamination on crops is considered a priority by the sanitary authorities of an increasing number of countries, and this is also due to the fact that the geographic areas interested in mycotoxin outbreaks are widening. Among the different pre- and post-harvest strategies that may be applied to prevent fungal and/or aflatoxin contamination, fungicides still play a prominent role; however, despite of countless efforts, to date the problem of food and feed contamination remains unsolved, since the essential factors that affect aflatoxins production are various and hardly to handle as a whole. In this scenario, the exploitation of bioactive natural sources to obtain new agents presenting novel mechanisms of action may represent a successful strategy to minimize, at the same time, aflatoxin contamination and the use of toxic pesticides. The Aflatox^® Project was aimed at the development of new-generation inhibitors of aflatoxigenic Aspergillus spp. proliferation and toxin production, through the modification of naturally occurring molecules: a panel of 177 compounds, belonging to the thiosemicarbazones class, have been synthesized and screened for their antifungal and anti-aflatoxigenic potential. The most effective compounds, selected as the best candidates as aflatoxin containment agents, were also evaluated in terms of cytotoxicity, genotoxicity and epi-genotoxicity to exclude potential harmful effect on the human health, the plants on which fungi grow and the whole ecosystem.     

Multicomponent Bioluminescence Imaging with Naphthylamino Luciferins

Bioluminescent tools have been used for decades to image processes in complex tissues and preclinical models. However, few distinct probes are available to probe multicellular interactions. We and others are addressing this limitation by engineering new luciferases that can selectively process synthetic luciferin analogues. In this work, we explored naphthylamino luciferins as orthogonal bioluminescent probes. Three analogues were prepared using an optimized synthetic route. The luciferins were found to be robust emitters with native luciferase in vitro and in cellulo. We further screened the analogues against libraries of luciferase mutants to identify unique enzyme-substrate pairs. The new probes can be used in conjunction with existing bioluminescent tools for multi-component imaging.     

Solvent-free oxidation of benzyl alcohol with oxygen using zeolite-supported Au and Au–Pd catalysts

The oxidation of benzyl alcohol to benzaldehyde has been investigated in the absence of solvent using zeolite-supported Au and Au–Pd catalysts. Three zeolites were investigated, ZSM-5, zeolite β and zeolite Y, and these were contrasted with the titanoslicalite TS-1 and TiO₂ as supports. For the Au catalysts the best results are obtained with zeolite β as the support and the conversions were comparable or better than those observed with TiO₂ in terms of turn over frequencies. However, the selectivities observed with the acidic zeolites were lower than the non-acidic TS-1 and TiO₂. This is due to the subsequent reaction of benzaldehyde via acid catalysed reactions to give benzyl benzoate and its dibenzyl acetal, and, in some cases dibenzylether. Initial catalysts were evaluated with a gold loading of 2 wt% and increasing this to 4 wt% showed the expected increase in activity, indicating that there is scope to improve the performance of these catalysts. The most active catalysts were prepared by impregnation and catalysts prepared by deposition precipitation were considerably less active. Introduction of Pd into the catalyst improved the activity without significantly affecting the selectivity.     

Time and shear dependent rheology of maleated polyethylene and its nanocomposites

Dipole-dipole and/or hydrogen-bonding interactions between the pendant functional groups within maleated high-density polyethylene (PE-g-MAn) establish a physical polymer network, whose formation kinetics and shear-sensitivity are revealed by dynamic oscillatory testing. The pronounced time and shear dependent viscoelastic properties of PE-g-MAn were not observed for a corresponding imide derivative, PE-g-imide, presumably due to weakened functional group associations in the latter material.The melt compounding of PE-g-MAn with onium-ion exchanged montmorillonite clay (NR₄⁺-MM) resulted in a partially exfoliated hybrid nanocomposite structure, whose viscoelastic behaviour differed significantly from that of the unfilled polymer. The presence of dispersed clay platelets altered the extent of functional group associations, thereby changing the dynamics of network formation.     

Brain mass estimation by head circumference and body mass methods in neonatal glycaemic modelling and control

Introduction

Hyperglycaemia is a common complication of stress and prematurity in extremely low-birth-weight infants. Model-based insulin therapy protocols have the ability to safely improve glycaemic control for this group. Estimating non-insulin-mediated brain glucose uptake by the central nervous system in these models is typically done using population-based body weight models, which may not be ideal.

Method

A head circumference-based model that separately treats small-for-gestational-age (SGA) and appropriate-for-gestational-age (AGA) infants is compared to a body weight model in a retrospective analysis of 48 patients with a median birth weight of 750 g and median gestational age of 25 weeks. Estimated brain mass, model-based insulin sensitivity (S_I) profiles, and projected glycaemic control outcomes are investigated. SGA infants (5) are also analyzed as a separate cohort.

Results

Across the entire cohort, estimated brain mass deviated by a median 10% between models, with a per-patient median difference in S_I of 3.5%. For the SGA group, brain mass deviation was 42%, and per-patient S_I deviation 13.7%. In virtual trials, 87–93% of recommended insulin rates were equal or slightly reduced (Δ < 0.16 mU/h) under the head circumference method, while glycaemic control outcomes showed little change.

Conclusion

The results suggest that body weight methods are not as accurate as head circumference methods. Head circumference-based estimates may offer improved modelling accuracy and a small reduction in insulin administration, particularly for SGA infants.     

Carbonization and liquid-crystal (mesophase) development. 12. Mechanisms of the co-carbonization of coals with organic additives

In industrial situations, coals interact with solvents or additives to produce liquid fuels, solvent-refined coal, coal extract and metallurgical coke. In these processes there occurs a wide variation in effects or modifications of the coal by these additives. This paper describes the modifications which can occur, using a wide range of rank of coal, when these coals interact and are co-carbonized with a wide range of additives of different chemical properties. The optical texture of the resultant cokes is given special attention. The objective of the paper is to summarize the current state of knowledge of the mechanisms of these interactions. Possible mechanisms of interactions are summarized, kinetic and chemical structural aspects of reactions are outlined, the importance is mentioned of the formation of liquid phases enabling anisotropic optical textures in modified cokes to be created, and the industrial relevance of its possible development is discussed.     

Carbonization and liquid-crystal (mesophase) development. 8. The co-carbonization of coals with acenaphthylene and decacyclene

Several coals of different rank have been carbonized singly and also co-carbonized with acenaphthylene and decacyclene. The resultant cokes were mounted in resin and polished surfaces were examined for optical texture using a polarized-light optical microscope fitted with a half-wave retarder plate. The optical texture can be assessed qualitatively (visually) or quantitatively by a point-counting technique in terms of size and shape of constituent isochromatic anisotropic units. Some cokes from coals were Isotropic. Acenaphthylene was only able to exert a smaller influence than decacyclene on the optical texture of the resultant cokes from co-carbonizations. Decacyclene was able to modify the optical texture for both the low-rank non-fusible and the caking coals. The effects of changing the proportions of coal to additive were examined. Results are interpreted in terms of ‘depolymerization’ of the coal by the action of the additive (as solvent) and also by the action of the additive in modifying the processes of formation of semi-coke via nematic liquid crystals.