Comparative analysis for power generation and ethanol production from sugarcane residual biomass in Brazil

This work compares the technical, economic and environmental (GHG emissions mitigation) performance of power generation and ethanol production from sugarcane residual biomass, considering conversion plants adjacent to a sugarcane mill in Brazil. Systems performances were simulated for a projected enzymatic saccharification co-fermentation plant (Ethanol option) and for a commercial steam-Rankine power plant (Electricity option). Surplus bagasse from the mill would be used as fuel/raw material for conversion, while cane trash collected from the field would be used as supplementary fuel at the mill. For the Electricity option, the sugarcane biorefinery (mill+adjacent plant) would produce 91 L of ethanol per tonne of cane and export 130 kWh/t of cane, while for the Ethanol option the total ethanol production would be 124 L/t of cane with an electricity surplus of 50 kWh/t cane. The return on investment (ROI) related to the biochemical conversion route was 15.9%, compared with 23.2% for the power plant, for the conditions in Brazil. Considering the GHG emissions mitigation, the environmentally preferred option is the biochemical conversion route: the net avoided emissions associated to the adjacent plants are estimated to be 493 and 781 kgCO₂eq/t of dry bagasse for the Electricity and Ethanol options, respectively.     

Comparison of Simple and Rapid Extraction Procedures for the Determination of Pesticide Residues in Fruit Juices by Fast Gas Chromatography–Mass Spectrometry

Three sample treatment methods, based on QuEChERS, solid-phase extraction (SPE) and solid-phase microextraction (SPME), were compared and evaluated in order to obtain the best conditions to determine pesticide residues in fruit juice by fast gas chromatography–mass spectrometry (single quadrupole GC-MS). Analysis were performed under selected ion monitoring, acquiring the three most abundant and/or specific ions for each analyte and using their relative intensity ratios as a confirmatory parameter. The 3 methodologies (QuEChERS, SPE and SPME) were validated taking 15 selected pesticides as model compounds, using commercial apple juice. QuEChERS procedure was based on the AOAC Official Method 2007.01, using acetonitrile (containing 1 % acetic acid) as extraction solvent and primary–secondary amine during the dispersive solid-phase extraction. Oasis hydrophilic–lipophilic balance cartridges were used for SPE, and polyacrylate fibers were used for direct immersion SPME procedure. Three isotopically labeled standards were added to the samples before extraction and used as surrogate standards. Validation parameters as recoveries, limits of detection, and limits of quantification (LOQ), as well as matrix effects and sample throughput, were obtained and compared for the three extraction procedures. QuEChERS was considered faster and led to the best quantitative results. In this way, validation was extended to up to 56 pesticides by applying QuEChERS in multi-fruit juice samples, obtaining LOQs ranging from 2 to 20 μg/L for most compounds. Accuracy and precision were evaluated by means of recovery experiments at two concentration levels (10 and 100 μg/L), obtaining recoveries between 70 and 120 % in most cases and relative standard deviations below 15 %. Finally, the QuEChERS method was applied to the analysis of commercial juices, including mango–apple, pineapple, grapefruit and orange.     

Multivariate analysis of the water quality variation in the Serra da Estrela (Portugal) Natural Park as a consequence of road deicing with salt

The concentration of some anions (Cl, F, NO₃, and SO₄), cations (Na, K, Ca, and Mg), pH and conductivity was determined in seven sampling points in the Serra da Estrela Mountains (Portugal) to verify if the application of road deicing with salt provokes impact in the water quality. Multivariate chemometric data analysis techniques of clustering and factor analysis were used. Preliminary analysis shows an overall conductivity increase in late spring and a decrease in late summer. A strong association between sodium chloride and the conductivity was observed by cluster analysis. Factor analysis supports the previous results and shows that the variation of the concentration of sodium chloride is the main source of the variance of the data along the year. In conclusion, the spreading of salt during the winter creates a local and seasonal impact on the water quality.     

Stress and strain distribution in demineralized enamel: A micro‐CT based finite element study

Physiological oral mechanical forces may play a role on the progression of enamel carious lesions to cavitation. Thus, the aim of this study was to describe, by 3D finite element analysis, stress, and strain patterns in sound and carious enamel after a simulated occlusal load. Micro‐CT based models were created and meshed with tetrahedral elements (based on an extracted third molar), namely: a sound (ST) and a carious tooth (CT). For the CT, enamel material properties were assigned according to the micro‐CT gray values. Below the threshold corresponding to the enamel lesion (2.5 g/cm³) lower and isotropic elastic modulus was assigned (E = 18 GPa against E₁ = 80 GPa, E₂ = E₃ = 20 GPa for sound enamel). Both models were imported into a FE solver where boundary conditions were assigned and a pressure load (500 MPa) was applied at the occlusal surface. A linear static analysis was performed, considering anisotropy in sound enamel. ST showed a more efficient transfer of maximum principal stress from enamel to the dentin layer, while for the CT, enamel layer was subjected to higher and concentrated loads. Maximum principal strain distributions were seen at the carious enamel surface, especially at the central fossa, correlating to the enamel cavity seen at the original micro‐CT model. It is possible to conclude that demineralized enamel compromises appropriate stress transfer from enamel to dentin, contributing to the odds of fracture and cavitation. Enamel fracture over a dentin lesion may happen as one of the normal pathways to caries progression and may act as a confounding factor during clinical diagnostic decisions. Microsc. Res. Tech. 78:865–872, 2015. © 2015 Wiley Periodicals, Inc.     

Polymerisation of styrene using Y, USY and β zeolites as catalysts

The homopolymerisation of styrene is studied in the presence of Y, USY and beta zeolites. High molecular weight polymers, in the range 0.7 × 10⁶–1 × 10⁶, are obtained in good yields. The activity of zeolite beta is only slightly increased by calcination of the as-synthesised material, pointing to an important role of the zeolite outer surface. The influence of the catalyst acidity upon the polymer molecular weight is evaluated by the use of dealuminated zeolites. This revised version was published online in July 2006 with corrections to the Cover Date.     

A Survey of Institutional Investors' Attitudes and Perceptions of Residential Property: The Swiss,Dutch and Swedish Cases

This paper provides evidence about institutional investors' attitudes and perceptions of residential property as an investment asset group in three European countries (Switzerland, the Netherlands and Sweden). These countries stand out, with an extraordinarily large institutional residential ownership, in fact, residential institutional allocation represents about 6 per cent, 2 per cent and 3 per cent of the total institutional investment in Switzerland, the Netherlands and Sweden, respectively. Housing is the most important institutional property asset type in Switzerland and the Netherlands, comprising over 52 per cent and 50 per cent of their institutional property portfolios, respectively. In Sweden residential property plays an important, but not dominant role in the domestic institutional property portfolios, representing about 21 per cent of the institutional property holdings. Using a postal survey of representatives of pension funds, insurance companies, property investment and asset management companies the study analyses the attractiveness of residential property in terms of institutional investment goals. The survey examines the institutional investors' perceptions of housing investment, namely with respect to its returns, volatility, inflation hedging, liabilities matching and correlation with shares, bonds and non-residential property. Additionally, the survey looks at the institutional investors' experiences regarding the private rented sector. The survey suggests that investment in residential property equity is likely to be done through larger portfolios, which tend to invest in housing directly. Residential property is seen mainly as an earning asset group able to provide diversification benefits for investors even when portfolios already include non-residential property. The respondents are mainly concerned with rent regulation issues, the lack of well-structured investment vehicles is undoubtedly a less important problem.     

Automatic control systems for submerged membrane bioreactors: a state-of-the-art review

Membrane bioreactor (MBR) technology has become relatively widespread as an advanced treatment for both industrial and municipal wastewater, especially in areas prone to water scarcity. Although operational cost is a key issue in MBRs, currently only a few crucial papers and inventions aimed to optimise and enhance MBR efficiency have been published. The present review summarises the available solutions in the area of automatic control systems and widely explores the advances in automation and control for MBRs. In this review of state of the art, different control systems are evaluated comparatively, distinguishing between control systems used for the filtration process and those used for the biological process of MBRs and describing the challenge faced by integrated control systems. The existing knowledge is classified according to the manipulated variables, the operational mode (open-loop or closed-loop) and the controlled variables used.