Novel system for controlled investigation of environmental partitioning of hydrophobic compounds in water

Partitioning behavior of hydrophobic and semivolatile chemicals (such as many POPs and PAHs) in water is key in controlling their environmental distribution and fate. A new equilibrium method is presented here which allows determination of the equilibrium partition coefficient of hexachlorobenzene with suspended particle (K(SPM)≈ 337 L gOC(-1)) in a complex bulk water sample by correcting for a number of sampling artifacts and for the presence of dissolved matter. The method provides simultaneous experimental determination of the fraction of chemical truly dissolved in water (representing in this case about 54% of the bulk water concentration) and that associated to DM (21%). The Henry's law constant was also experimentally determined during the K(SPM) measurements, providing information on the occurrence of partitioning equilibrium in the system for each single observation. Results showed that the high level of quality control and accuracy provided confidence intervals for the K(SPM) estimates within 1 order of magnitude.     

Enhanced domain disjoint backward recursive TE path computation for PCE-based multi-domain networks

The ability of computing optimal routes poses new challenges when extending it to larger multi-domain network scenarios, as the quality of these computed end-to-end inter-domain routes depends on the selection of the domain sequence to be traversed. In the scope of the Internet Engineering Task Force (IETF), the Path Computation Element (PCE) Working Group has not provided definitive solutions to address the domain sequence selection problem, being still a work in progress. To this goal, the Path Computation Flooding (PCF) approach appears as a possible extension to Backward Recursive PCE-based Computation (BRPC) to calculate optimal end-to-end inter-domain paths without requiring a pre-configured domain sequence. Nonetheless, PCF presents major scalability issues in terms of network control overhead and path computation complexity, thus pleading for more accurate domain sequence selection techniques. This paper describes two novel mechanisms to establish inter-domain paths calculating the sequence of domains to be crossed when it is not known in advance. Both procedures make a good trade-off between the control overhead introduced and the accuracy of the computed end-to-end route. The obtained simulation results show the benefits of the proposed contributions, drastically reducing the control overhead while keeping the connection blocking probability close to the optimal values.     

Steam reforming of ethanol at moderate temperature: Multifactorial design analysis of Ni/La2O3-Al2O3, and Fe- and Mn-promoted Co/ZnO catalysts

Novel Co (10%) catalysts supported on ZnO and promoted with Fe and Mn (1%) were synthesized and characterized by high-resolution transmission electron microscopy (HRTEM), electron energy-loss spectroscopy (EELS), X-ray diffraction (XRD) and X-ray photoelectron spectra (XPS). Their catalytic activity for steam reforming of ethanol was compared with that of Ni catalysts supported on La₂O₃-Al₂O₃. Experiments at 400 and 500 °C, steam to carbon ratios of 2 and 4, and a wide interval of contact time were analyzed following a multifactorial experimental design. At 500 °C and a steam to carbon molar ratio of 4, complete conversion of ethanol was achieved above a contact time of 200 g min mol⁻¹ for all catalysts. The ratio of selectivity between hydrogen and methane was around 23 mol_H2/mol_CH4 in the Co catalysts, while it approached the thermodynamic equilibrium (5.7 mol_H2/mol_CH4) in the Ni catalysts. The Co catalysts do not promote methane-forming reactions like ethanol cracking and acetaldehyde decarbonilation, nor do they facilitate the reverse methane steam reforming reaction. The catalytic behavior of cobalt is enhanced by promotion with iron or manganese through the formation of bimetallic particles, which facilitates cobalt reducibility. This suggests that Co-Mn/ZnO and Co-Fe/ZnO catalysts have a good potential for their use for ethanol reforming at moderate temperature.     

Comparison between conventional and qPCR methods for enumerating Campylobacter jejuni in a poultry processing plant

Campylobacter jejuni is worldwide recognized as a human foodborne pathogen. It is widely present in poultry meat and slaughterhouses, but little is known about its fate during the processing of poultry meat preparations. In stress conditions, this pathogen can enter into a viable but non-culturable state, where quantitative PCR (qPCR) becomes more convenient for its detection. In this study, two different pairs of primers, targeting the rpoB and the hipO genes, were compared for its detection and quantification by PCR. Two calibration curves were prepared: one for the meat samples and the other for the environmental samples. rpoB primers showed higher sensitivity with a quantification limit of 1 log cfu/g or ml. Microbial Assessment Scheme (MAS) was used to select the Critical Sampling Locations (CSLs) along the poultry processing line. Forty-six out of 48 samples were positive by qPCR after enrichment (t = 48 ) while only 6 samples were positive by ISO 10272-1:2006. Forty-three samples showed positive signal without enrichment (t = 0 h), however only 16 samples could be quantified. These results showed the high prevalence of C. jejuni in the poultry industry and the need for new, rapid and sensitive techniques, such as qPCR, for the detection and quantification of C. jejuni in meat and environmental samples.     

Effect of modified atmosphere packaging on the microbiological and sensory quality on a dry cured beef product: "Cecina de león"

The aim of this study was to investigate the shelf-life of commercial “Cecina de León” (CL) packaged in vacuum (VP) and in CO₂/N₂ atmospheres (20/80% CO₂/N₂ and 80/20% CO₂/N₂). Packaged product was stored at 6 °C, measuring microbiological, physico-chemical and sensory parameters during 210 days. The values obtained for mesophilic aerobic, anaerobic and psychrotrophic counts did not vary in both the vacuum and the gas packaged samples after 210 days of storage. Enterobacteria and enterococci were always below the detection limit, and in the gas-packaged CL, pseudomonad numbers were significantly inhibited. No changes were observed in the counts of the typical microflora of CL (Lactic Acid Bacteria, yeasts and moulds and Micrococcaceae) up to 210 days and no differences (p > 0.05) were found between the counts in the VP and in the gas-packaged samples. A pronounced initial fading was observed in redness (a^∗) within the first 15 days in the VP samples and within the second month in the gas-packaged samples attributed to the presence of white film on surface of CL portions. No differences were observed (p > 0.05) in texture parameters evaluated between packaging methods during storage, and the values found are within the range for CL not packaged. The sensory properties of CL stored in 20/80% CO₂/N₂ were slightly less acceptable than the samples packed under vacuum and under 80/20% CO₂/N₂ at 210 days of storage. It is concluded that no clear advantage of the gas packaging was observed compared to the VP of “Cecina de León”.     

Improving wind turbine drivetrain designs to minimize the impacts of non‐torque loads

Non‐torque loads induced by the wind turbine rotor overhang weight and aerodynamic forces can greatly affect drivetrain loads and responses. If not addressed properly, these loads can result in a decrease in gearbox component life. This work uses analytical modeling, computational modeling and experimental approaches to evaluate two distinct drivetrain designs that minimize the effects of non‐torque loads on gearbox reliability: a modified three‐point suspension drivetrain studied by the National Renewable Energy Laboratory (NREL) Gearbox Reliability Collaborative (GRC) and the Pure Torque® drivetrain developed by Alstom. In the original GRC drivetrain, the unequal planetary load distribution and sharing were present and they can lead to gear tooth pitting and reduce the lives of the planet bearings. The NREL GRC team modified the original design of its drivetrain by changing the rolling element bearings in the planetary gear stage. In this modified design, gearbox bearings in the planetary gear stage are anticipated to transmit non‐torque loads directly to the gearbox housing rather than the gears. Alstom's Pure Torque drivetrain has a hub support configuration that transmits non‐torque loads directly into the tower rather than through the gearbox as in other design approaches. An analytical model of Alstom's Pure Torque drivetrain provides insight into the relationships among turbine component weights, aerodynamic forces and the resulting drivetrain loads. In Alstom's Pure Torque drivetrain, main shaft bending loads are orders of magnitude lower than the rated torque and hardly affected by wind speed, gusts or turbine operations. Copyright © 2014 John Wiley & Sons, Ltd.     

The use of carbon dioxide at high pressure to control nine stored-product pests

The development of alternative treatments for pest control in food commodities is an increasing demand from the food industry, which should meet consumer demands for the reduced use or elimination of pesticides. The use of carbon dioxide (CO₂) at high pressure is one of the most rapid options for arthropod pest control among current commercial treatments, offering complete control within hours. The present study aimed to establish the efficacy of the technique against different stages of several insect and mite pests that affect stored-food products. Standard food diets containing eggs, larvae, pupae and adults of Oryzaephilus surinamensis, Cryptolestes ferrugineus, Lasioderma serricorne, Sitophilus oryzae, Rhyzopertha dominica, Acanthoscelides obtectus, Ephestia kuehniella, Liposcelis bostrychophila and Tyrophagus putrescentiae were treated with CO₂ for different times at two high pressures, 15 and 20 bar. A high level of control was achieved for most species and development stages when they were treated with CO₂ at 20 bar for 60 min. However, the efficacy at 15 bar was much lower. The eggs of L. bostrychophila and L. serricorne showed the highest tolerance of all species/stages and survived the most extreme conditions tested. The beetle O. surinamensis, the moth E. kuehniella, and the mite T. putrescentiae were easier to kill than the other species tested. Our results confirmed that the use of high-pressure CO₂ offers an effective and fast way to control most stored-product pests that affect food commodities.     

Dual Costimulatory and Coinhibitory Targeting with a Hybrid Fusion Protein as an Immunomodulatory Therapy in Lupus Nephritis Mice Models

Systemic lupus erythematosus is a complex autoimmune disorder mostly mediated by B-cells in which costimulatory signals are involved. This immune dysregulation can cause tissue damage and inflammation of the kidney, resulting in lupus nephritis and chronic renal failure. Given the previous experience reported with CTLA4-Ig as well as recent understanding of the PD-1 pathway in this setting, our group was encouraged to evaluate, in the NZBWF1 model, a human fusion recombinant protein (Hybri) with two domains: CTLA4, blocking the CD28—CD80 costimulatory pathway, and PD-L2, exacerbating the PD-1–PD-L2 coinhibitory pathway. After achieving good results in this model, we decided to validate the therapeutic effect of Hybri in the more severe MRL/lpr model of lupus nephritis. The intraperitoneal administration of Hybri prevented the progression of proteinuria and anti-dsDNA antibodies to levels like those of cyclophosphamide and reduced the histological score, infiltration of B-cells, T-cells, and macrophages and immune deposition in both lupus-prone models. Additionally, Hybri treatment produced changes in both inflammatory-related circulating cytokines and kidney gene expression. To summarize, both in vivo studies revealed that the Hybri effect on costimulatory-coinhibitory pathways may effectively mitigate lupus nephritis, with potential for use as a maintenance therapy.