The advantages of the magnetic structure in ferromagnetic-film-coated carbon nanotube probes

The magnetic structures of ferromagnetic-film-coated carbon nanotube (CNT) probes and conventional pyramidal probes for a magnetic force microscope (MFM) were simulated using three-dimensional micromagnetic simulation. The CNT-MFM probes with a total probe diameter less than 60?nm are almost uniformly magnetized along the longitudinal direction of the CNT, which is the ideal magnetic structure for MFM observations. On the other hand, the pyramidal probes had a vortex structure around the point tip, which suggests that they require a greater thickness of the ferromagnetic film because only part of the magnetic moment participates in the detection of the z-component of the stray field from samples. The advantages of the CNT-MFM probe are uniform magnetization along the longitudinal direction and magnetic imaging ability using a smaller coating thickness.     

Mechanically durable and highly conductive elastomeric composites from long single-walled carbon nanotubes mimicking the chain structure of polymers

By using long single-walled carbon nanotubes (SWNTs) as a filler possessing the highest aspect ratio and small diameter, we mimicked the chain structure of polymers in the matrix and realized a highly conductive elastomeric composite (30 S/cm) with an excellent mechanical durability (4500 strain cycles until failure), far superior to any other reported conductive elastomers. This exceptional mechanical durability was explained by the ability of long and traversing SWNTs to deform in concert with the elastomer with minimum stress concentration at their interfaces. The conductivity was sufficient to operate many active electronics components, and thus this material would be useful for practical stretchable electronic devices.     

Simultaneous visualization of oxygen distribution and water blockages in an operating triple-serpentine polymer electrolyte fuel cell

Visualization inside polymer electrolyte fuel cells (PEFCs) is important for elucidating reaction distributions to improve the performance and durability of the cells. An O₂-sensitive porphyrin luminescent dye film was used to visualize oxygen partial pressures and water blockages simultaneously in triple-serpentine gas flow channels in an operating PEFC. Water droplets formed near the exit of a gas-flow channel lowered the oxygen partial pressure noticeably over the channel by blocking air flow near the entrance. Meanwhile, air was continuously supplied from the other channels through the gas diffusion layer, thus allowing power to be generated in the blocked channel. With water blockages, however, the catalyst layer under the channel became flooded by the water produced during the reaction, and the flooded state continued to exist in the catalyst and/or porous layers, even after blowing the water droplet out, so that the power generation was lowered along the channel.     

Impurity Effects on Energy Gap in Bi<Subscript>2</Subscript>Sr<Subscript>2</Subscript>CaCu<Subscript>2</Subscript>O<Subscript>8+<Emphasis Type="Italic">y</Emphasis></Subscript> Investigated by Electronic Raman Scattering

The Raman scattering experiments were carried out in Zn-doped and Zn-free Bi₂Sr₂CaCu₂O_8+y with optimal hole concentration below and above T _c . The energy of pair-breaking peak in the B _1g Raman spectrum, corresponding to the magnitude of superconducting gap 2Δ ₀, is suppressed by 1% Zn-doping. In the normal state, the B _1g Raman spectrum for Zn-doped sample shows no pseudogap behaviour, suggesting that the pseudogap is strongly smeared by Zn-doping.     

Numerical Flow Simulation in Turbine Mode of Counter-Rotating Type Pumping Unit to Cooperate with Wind Turbine

This serial research has proposed the hybrid power system combined the wind power unit with the counter-rotating type pump-turbine unit, to provide the constant output for the grid system, even at the suddenly fluctuating/turbulent wind circumstance. In this paper, the tandem impellers prepared for the counter-rotating type pumping unit were operated at the turbine mode, and the performances and the flow conditions were investigated numerically with accompanying the experimental results. Even though providing the pumping unit for the turbine mode, the maximum hydraulic efficiency is close to one of the counter-rotating type hydroelectric unit designed exclusively for the turbine mode. Besides, the runners/impellers of the unit work evidently so as to coincide the angular momentum change through the front runners/impellers with that through the rear runners/impellers, namely to take the axial flow at not only the inlet but also the outlet, without the guide vanes. From these results, it can be concluded that this type unit is effective to work at not only the pumping but also the turbine modes.     

Transient kinetic studies of pH-dependent hydrolyses by exo-type carboxypeptidase P on a 27-MHz quartz crystal microbalance

pH-Dependent kinetic parameters (k(on), k(off), and k(cat)) of protein (myoglobin) hydrolyses catalyzed by exo-enzyme (carboxypeptidase P, CPP) were obtained by using a protein-immobilized quartz crystal microbalance (QCM) in acidic aqueous solutions. The formation of the enzyme-substrate (ES) complex (k(on)), the decay of the ES complex (k(off)), and the formation of the product (k(cat)) could be analyzed by transient kinetics as mass changes on the QCM plate. The Kd (k(off)/k(on)) value was different from the Michaelis constant Km calculated from (k(off) + k(cat))/k(on) due to k(cat) > k(off). The rate-determining step was the binding step (k(on), and the catalytic rate k(cat) was faster than other k(on) and k(off) values. In the range of pH 2.5-5.0, values of k(on) gradually increased with decreasing pH showing a maximum at pH 3.7, values of k(off) were independent of pH, and k(cat) increased gradually with decreasing pH. As a result, the apparent rate constant (k(cat)/Km) showed a maximum at pH 3.7 and gradually increased with decreasing pH. The optimum pH at 3.7 of k(on) is explained by the optimum binding ability of CPP to the COOH terminus of the substrate with hydrogen bonds. The increase of k(cat) at the lower pH correlated with the decrease of alpha-helix contents of the myoglobin substrate on the QCM.     

Garlic extract and its selected organosulphur constituents promote ileal immune responses ex vivo

The effects of garlic extract and three organosulphur compounds of garlic on intestinal immune responses in mice were investigated. Peyer’s patch (PP) cells were isolated from mice orally administered with garlic extracts or one of three organosulphur compounds (alliin, allicin, diallyl disulphide (DADS)). PP cells isolated from mice that had been orally injected with ethanol extract significantly produced interferon (IFN)-γ and interleukin (IL)-4. IL-2 production in PP cells was significantly reduced by hot-water and ethanol extracts from garlic. PP cells from mice administered with two organosulphur compounds, alliin or DADS (5 mg/kg/day), could produce IL-2, IFN-γ and IL-4, whereas allicin showed moderate activity. The enhancement activity of IL-2 and IFN-γ productions in PP cells by DADS was higher than those obtained by administration of alliin or allicin. Comprehensive analyses of genetic profiles in PP tissue from mice administered with ethanolic extracts, allicin or alliin revealed that oral administration of samples increased 68–144 genes and decreased 50–52 genes by ?1.8-fold. Analyses of clustering profiles of microarrays indicated that ethanol extract and alliin upregulated the expression of IFN-γ. These data showed that garlic and its organosulphur compounds stimulate de novo IFN-γ biosynthesis in PP cells, thereby promoting ileal immune responses.     

Annealing behavior of (Pu,Cm)O2 lattice and bulk expansion from self-irradiation damage

In order to investigate the effect of self-irradiation damage and accumulation of He on oxide fuel pellets containing minor actinides, the expansion and annealing behavior of (Pu_0.95Cm_0.05)O₂ lattice and bulk were examined comparatively. Since the lattice and bulk expansion at room temperature showed a similar dependence on the storage duration, the main factor of bulk expansion was found to be the lattice expansion due to the generation of point defects. The lattice parameter recovered to the undamaged value by annealing at 1429 K for 2 h, whereas the bulk expanded again by annealing at 1433 K and did not recover to the undamaged value. In the micrographs of the fracture surface of the annealed pellet, the formation of gas bubbles along grain boundaries was confirmed. The He gas bubble formation resulted in the pellet swelling, and it may affect the pellet thermal conduction.     

Fermentation Process and Grain Structure of Baked Breads from Frozen Dough Using Freeze-Tolerant Yeasts

The fermentation process for frozen doughs using freeze‐sensitive (Saccharomyces cerevisiae, Kyowa for sweet bread; S. cerevisiae, FC for white bread) and freeze‐tolerant (S. cerevisiae, YF for sweet bread) yeasts was traced by magnetic resonance imaging (MRI). Grain network structures of baked breads were also visualized by MRI. Prefermentation before freezing, punching and remolding, or resheeting and molding treatments increased loaf volume by 10 to 110% for the baked breads using freeze‐tolerant yeast, while these treatments decreased loaf volume by 70% using freeze‐sensitive yeast. The first fermentation before freezing and the second fermentation with punching or resheeting after thawing are useful for obtaining good quality breads from frozen dough using freeze‐tolerant yeast.     

Analysis of pesticides including chlorine in welsh onions and mushrooms using gas chromatograph with an atomic emission detector (GC-AED)

An analytical method for the determination of 32 kinds of pesticide residues in onions, Welsh onions and mushrooms using gas chromatograph with an atomic emission detector (GC-AED) was developed. The pesticides were extracted with acetone-n-hexane (2:3) mixture. The crude extract was partitioned between 5% sodium chloride and ethyl acetate-n-hexane (1:4) mixture. The extract was passed through a Florisil mini-column for cleanup with 10 mL of acetone-n-hexane (1:9) mixture. Although the sensitivity of GC-AED was inferior to that of GC-ECD, GC-AED has a superior element-selectivity. Therefore pesticide residues in foods could be analyzed more exactly by using GC-AED. Thirty-two pesticides including chlorine in onion, Welsh onion and shiitake mushroom were detected without interference. Recoveries of these pesticides from samples determined by GC-AED were 64-114%, except for a few pesticides.