A convenient method for preparation of monofluorocarboxylic acids

Monofluoro esters were prepared by the reaction of hydroxy esters with N,N-diethyl-1,1,2,3,3,3-hexafluoro propylamine (PPDA). Saponification of these monofluoroesters with enzyme (lipase MY) was attempted to give their corresponding monofluorocarboxylic acids in moderate yields.     

Two-stage pyrolysis of heavy oils. 3. Pyrolysis of tar-sand bitumens. Relation between ethylene yield and structural characteristics of heavy oils

Thermal cracking of tar-sand bitumens has been carried out using a two-stage pyrolysis reactor with temperature zones of 440°C and 750–800°C, respectively. Feedstocks were pyrolysed in the first stage into cracked oils, which were carried to the second stage for subsequent pyrolysis. Only 12–14 wt% of ethylene was obtained from tar-sand bitumens at the residence time of 1.2 s in the second stage, although 27 and 16 wt% were obtained from Taching and Iranian heavy vacuum residues, respectively. The tar-sand bitumens contain shorter paraffinic straight-chains and have more branched molecules than the vacuum residues of petroleum. A straight-chain paraffin index is proposed, with which a good correlation was obtained between ethylene yield and the fraction of straight-chain paraffin carbons in the heavy oil.     

Nitrous oxide emissions from fertilized upland fields in Thailand

Nitrous oxide (N₂O) emission from fertilized maize fields was measured using a closed chamber at four experimental sites in Thailand. The average measured N₂O flux from unfertilized plots through crop season was 4.16 ± 1.52, 5.05 ± 1.65, 5.25 ± 1.68 and 6.74 ± 2.95 g N₂O-N m^-2 h^-1, at Nakhon Sawan, Phra Phutthabat, Khon Kaen and Chiang Mai, respectively. Increased N₂O emissions by the application of nitrogen fertilizer were 0.22–0.44, 0.19–0.38%, 0.12–0.24 and 0.08–0.15% of the applied N, respectively. Compared to other data, N₂O emission rate to applied nitrogen was not significantly different between the data of Thailand and the Temperate Zone.     

Influence of activated carbon pore structure on oxygen reduction at catalyst layers supported on rotating disk electrodes

Carbon materials are often used as catalyst supports, and for catalysts in electrodes of a polymer electrolyte fuel cell, carbon black has been used. Recently, it was found, however, that activated carbon could replace carbon black and besides, significantly improve the activity of the electrode catalyst layer for oxygen reduction. In the present study, to optimize the pore structure of activated carbon for further activity improvement, the influence of the pore structure on the activity was investigated using activated carbon of various specific surface areas and mean pore diameters. A catalyst layer was formed from activated carbon loaded with platinum and a polymer electrolyte. The activity of the layer was measured in an oxygen-saturated perchloric acid solution, supporting the layer on a rotating glassy carbon disk electrode. We found that increases in the specific surface area and mean pore diameter increased the activity and that the latter was more effective than the former mainly due to the enhanced mass-transfer in the pores; the catalyst layer formed from activated carbon with the largest mean pore diameter was the most active. Unless pores excessively develop and lose connections between particles, a large pore diameter is therefore desired for the fuel cell electrodes.     

The Direct Synthesis of β-hydroxy-acids by Lithium Naphthalene and Acetic Acid

Lithium naphthalene reacts with acetic acid to give α-anion of lithium acetate. The reaction of this anion with various ketones gives the corresponding β-hydroxy-acids in good yield.     

Performance of solvothermally prepared Ga2O3-Al2O3 catalysts for SCR of NO with methane

The solvothermal reaction of mixtures of aluminum isopropoxide (AIP) and gallium acetylacetonate (Ga(acac)₃) directly yielded the mixed oxides of γ-Ga₂O₃-Al₂O₃. In the solvothermal synthesis, the crystal structure of mixed oxides was controlled by the initial formation of γ-Ga₂O₃ nuclei. The mixed oxides prepared in diethylenetriamine have extremely high activities for selective catalytic reduction (SCR) of NO with methane as a reducing agent. With increasing crystallite size of the spinel structure, the catalytic activity increased. The ratio of the amount of methane consumed by combustion to total methane conversion was proportional to the density of acid sites on the surface of the mixed oxides. The mixed oxide catalysts prepared in diethylenetriamine had lower densities of acid sites and showed a higher methane-efficiency for CH₄-SCR than those prepared in other solvents. These catalysts maintained their high activity even when the reaction was carried out under the severe conditions (i.e., high space velocity and low NO concentration).     

Observation of single-walled carbon nanotubes by photoemission microscopy

Single-walled carbon nanotube networks grown on SiO₂ pillars were studied by means of scanning photoemission microscopy. The individual nanotubes or nanotube bundles growing from the pillar tops were observed in C 1s images. Band bending near catalytic Fe/nanotube contacts in an end-bonded configuration was studied by measuring C 1s spectra along the tube axes. Within our experimental resolution, no band bending was observed. This implies that the depletion width is less than the spatial resolution of the scanning photoemission microscope (90 nm) or that the amount of the band bending is less than 0.1 eV.     

Crystalline complex between poly(γ-methyl l-glutamate) and dimethyl phthalate

The crystalline complex between poly(γ-methyl l-glutamate) (PMLG) and dimethyl phthalate (DMP) has been formed in films cast from a solution in dichloroethane. It has the stoichiometry of 1 mol of DMP to three or four residues of PMLG and shows two definite characteristics in X-ray diffraction patterns; one is the large hexagonal unit cell with the edge of around 28 Å and another the ‘extra’ 5.07 Å meridional reflection which can not be interpreted by a PMLG α-helical conformation. The structural examination for the films with various DMP contents is carried out by X-ray, viscoelastic, and d.s.c. measurements and the following structure is proposed for the crystalline complex. Four PMLG are associated to form a group which is hexagonally packed and DMP molecules, located in the gaps between groups, form a specific favourable helical structure along PMLG chains in which the van der Waals stacking of benzene rings of DMP is significant.