碳酸盐岩气藏加砂压裂重复改造试验效果分析

针对碳酸盐岩气藏部分气井生产效能低的状况，决定在长庆气田下古生界尝试开展加砂压裂重复改造试验，以期提高低产、低效气井的产量，延长气田稳产期。通过潜心研究、精细设计及现场质检监控，优选了4口老井进行加砂压裂重复改造现场试验。从试验结果来看，虽然只有1口井取得明显的改造效果，但4口井加砂压裂施工都是成功的，说明对碳酸盐岩气藏实施加砂压裂是可以实现的，但在选井思路和压裂工艺方面还有待探索和研究。     

对称配筋小偏心受压构件的截面设计

对小偏心受压构件在对称配筋情况下的截面配筋计算，提出用最佳一次逼近多项式简化基本公式，直接按二次方程求解ξ的近似方法，具有精度高，相对误差小，计算方便等优点，可供工程设计人员参考。     

大窝山隧道进口围岩快速掘进施工组织与管理

结合工程概况及工程特点,从机械设备配置、劳动力组织、现场管理等方面介绍了大窝山隧道进口Ⅱ级,Ⅲ级围岩段的快速掘进施工组织与管理措施,为类似隧道的快速掘进施工组织与管理提拱了相关经验.     

PURIFICATION AND PROPERTIES OF TRANSGLUTAMINASE FROM STREPTOVERTICILLIUM MOBARAENSE

Transglutaminase (TGase) was separated from the culture broth of an isolated strain of Streptoverticillium mobaraense. The crude enzyme was prepared by centrifugation, ultrafiltration, precipitation by alcohol, centrifugation and freeze‐drying. The yield after these processes was 65–70%. Then the enzyme was purified to homogeneity by chromatography on CM‐cellulose and Sephadex G‐75 on which the yields were about 70% and 80%, respectively; the purified folds reached 2.5–4.7 and 1.08–2.06, respectively. The molecular weight of this TGase was 39,500–40,100 Da by gel filtration chromatography. Optimum enzyme activity was observed in the pH range of 5.0–7.0, and it was maintained stable at 20–40C. The optimal temperature and pH was 52C and 6.0, respectively. At 1 mM and 5 mM metal ion or inhibitors concentration, TGase activity was strongly inhibited by Zn²⁺ and NEM, and not affected obviously by Ba²⁺, Ca²⁺, Co²⁺, Cu²⁺, Fe²⁺, Fe³⁺, Mg²⁺, Mn²⁺, Na⁺ as well as PMSF and EDTA. The effects of these additions on this TGase were compared with those of other microbial TGases.     

均匀设计法分析制备过程对钴钼硫化物催化剂机械强度的影响

建立了CoMoP/Al2O3加氢精制催化剂机械强度及其可靠性在制备过程中的数学模型,采用均匀设计考察了浸渍、干燥、煅烧、硫化4个制备过程中,浸渍时间、干燥温度、干燥时间、煅烧温度、煅烧时间、硫化温度和硫化升温速率7个实验因子对催化剂强度均值、Weibull模量的影响,同时考察了这些因素对颗粒密度的影响。方差分析表明所有模型都是充足的。实验结果表明,硫化过程是影响催化剂强度均值的主要过程。在实验范围内提高硫化温度、降低硫化时的升温速率有利于提高催化剂的强度。影响催化剂Weibull模量的因素主要为各个制备过程的交互效应。要提高催化剂强度的可靠性就必须全面考虑催化剂制备的各个过程,特别是各个制备过程的交互效应。     

平衡阀和双向液压锁的正确选用

双向液压锁和平衡阀在一定场合下都能作为闭锁元件使用，可以保证工作装置不会因自重等外部原因出现下滑、超速或窜动，但在一些特定速度载荷的情况下却不能互换使用。下面针对2种产品的结构形式，谈谈笔者的一些看法。     

储层压力与天然气分布关系——以鄂北塔巴庙地区上古生界储层为例

通过分析塔巴庙地区储层压力的分布特征，建立了研究区泥岩压实曲线，并对影响和控制该区储层压力的主要因素和机理进行了探讨，对“欠压实”剩余压力、生气增压、抬升引起的降压进行了定量计算。分析结果表明，晚三叠-早白垩世末“欠压实”作用和晚侏罗-早白垩世末烃源岩大量生烃作用使塔巴庙地区上古生界形成异常高压；晚白垩系构造抬升降压，使得现今储层为正常-低异常压力。同时证实了“欠压实”对天然气有压力封盖作用，天然气都分布在最大“欠压实”幅度以下的储层当中。烃源岩生气高峰为晚侏罗-早白垩世末，但天然气大规模运移是在晚白垩世，方向以沿过剩压力梯度降低较快的方向（太原-山西组至下石盒子组）垂向运移，通道主要为裂缝，运移的动力主要为异常高压。由于储层致密，聚集成藏能量有限，造成天然气充注不足、气水分异不好、含气饱和度低。     

Structural transformation of FePt nanocomposite films during annealing and its effects on magnetic properties

Fe100-xPtx(x=30at.%-60at.% ) nanocomposite films were deposited on natural-oxidized Si(100) substrates by magnetron sputtering. The as-deposited films were annealed between 373 and 1073 K. In situ X-ray diffraction shows that the FePt nanocomposite films undergo a phase transformation from a disordered FCC phase to an ordered L10 phase between 673 and 773 K. The coercivity is 306 kA·m-1 whiles the average grain sizes is about 10 nm in the optimized FePt alloy film sample annealed at 673K. The adjustable coercivity and fine grain size suggest that this FePt nanocomposites system is suitable as recording media at extremely high areal density.     

固有频率在车轮设计有限元分析中的应用

以三维软件进行车轮造型,用CAD软件建立固有频率分析数学模型,对车轮固有频率进行分析和处理.结合其他试验的分析,对车轮进行优化设计.