分割电极片状压电致动器——(二)位移特性及狭缝宽度对其影响的实验研究

研究了悬臂梁式分割电极片状压电致动器的位移特性。理论分析表明，分割电极狭缝宽度会减小致动器自由端的位移输出，但当狭缝宽度小于致动器电极宽度的１０％时，可忽略狭缝宽度的影响。致动器端部位移的测试结果大于理论计算值。与现有磁头悬浮臂尺寸相近的致动器，在２０Ｖ～５０Ｖ的电压驱动下均可获得１μｍ～２μｍ的致动位移。对９８５０道／厘米的密度磁盘，该位移能覆盖至少一个磁道宽度，满足磁头定位两级伺服系统对第二级致动器位移的基本要求。     

Synthesis, characteristics and oxygen-sensitive properties of SrMgxTi 1 − xO3 nanocrystals

SrMg_xTi_{1 - x}O₃ nanocrystals (x = 0.1–0.6) were synthesized by the stearic acid gel method. Powder samples were characterized by X-ray diffraction and X-ray photoelectron (XP) spectroscopy. The results showed that the lattice parameter a and the O 1s XP spectrum changed not only with the Mg content x but also with the grain size d of the samples. The conductivity of a thick film specimen fabricated on an aluminium oxide wafer was investigated in a nitrogen—oxygen atmosphere.     

Pore size control of porous silica by sol-gel process

Porous silica glass was prepared by sol-gel process from tetraethoxysilane (TEOS). The effects of solvents (water, ethanol), drying condition, heat treatment temperature on specific surface area and pore size distribution of porous silica were investigated. Gelation process accelerates with an increase of H₂O content, while retards with the increase of ethanol amount. Structure changes during heat treatment were studied by means of DTA, XRD. TEM micrographs show that the gel particles shrink after heated at 500°C, thus the average pore size decreases.     

Effect of processing history on the properties of Ag-based tapes

The Bi-system tapes and coils were prepared by the powder-in-tube method. The effect of processing and heat treatment on the properties of the tapes and coils was studied. It is found that the shearing stress produced by the rolling process may destroy the 2223 phase, and the destroyed 2223 phase cannot be recovered by heat treatment, whereas the pressing stress produced by the uniaxial pressing process only makes the 2223 phase grains break, and the broken 2223 phase can be closed by the heat treatment. TheJ _c values of the rolling samples, pressing sample, and the coil with a diameter of 35 mm are over 1.3×10⁴, 2.5×10⁴, and 4×10³ A/cm² (77 K, 0 T), respectively.     

耿达电站首部枢纽运行中的泥沙淤积及清污处理

简要地介绍了渔子溪二级水电站首部枢纽在10多年运行管理中的泥沙淤积及清污的处理措施。     

U(Ⅳ)-U(Ⅵ)同位素交换反应动力学研究 Ⅰ.Fe~(2+)对U(Ⅳ)-U(Ⅵ)同位素交换反应的催化作用

一、前言由于U(IV)-U(VI)同位素交换体系具有相当大的同位素效应和很好的稳定性,并且容易实现两相回流,这对于分离U同位素的工业应用都是十分有利的。但是,U(IV)-U(VI)同位素交换反应速度非常慢,常温下H~+浓度为1.0—4.0 mol/l时,速度常数为1.0×10~(-4)l~2/mol·s。因此要用U(IV)-U(VI)交换体系浓缩铀同位素,必须研究U(IV)-U(VI)交换反应动力学,找到加快交换反应的方法。     

溶剂萃取分离锂同位素研究Ⅱ.苏丹Ⅰ-中性配位体协萃体系萃取分离锂同位素效应探讨

文章讨论了苏丹I-中性配位体协萃体系萃取分离锂同位素中螯合剂和协萃剂的结构效应。为了获得高的同位素分离效应,螯合剂必须是弱酸性的(PK_α>11),具有强的分子内氢键及易于形成六元螯合环。协萃剂结构不仅要求无空间位阻,而且具有强的配位基。α随配位基的碱性增大而相应提高。萃取络合物中螯合环的增多亦有利于体系α的提高。此外本文还讨论了一些萃取体系的同位素富集方向和萃锂体系用于分离同位素的前景。     

石油系油浆与煤系闪蒸油的焦化性能——I．热解条件的影响

通过偏光显微镜观察了石油系油浆（LH）与煤系闪蒸油（SN）焦化后所得焦块的光学结构。结果表明，在较宽条件下两种原料单独焦化均得不到取向度高的流线型结构。将两种原料以一定比例混合后先热解丙焦化所得焦块的光学结构明显好于二者混合后直接焦化所得焦块的光学结构，其中LH和SN以3：2的重量比混合后在440℃、1MPa下热解3．5h然后再在530℃、1MPa下焦化8h所得焦块为具有较高取向度的流线型结构，适合于作为针状焦的起始原料。     

硫脲型整合树脂在分析上的应用 Ⅰ.岩样中微量银的中子活化分析

前言银和其他贵金属元素一样,在地壳中比较稀少,按其自然丰度为第67号元素,平均含量仅0.07 ppm。由于地质样品成分非常复杂,为测定其微量银,必须进行严格的化学分离。但是迄今文献中报道的许多分离分法,步骤都相当冗长,一般采用氯化银反     

用于重离子核反应实验测量的纵向电场气体电离室

本文报道了一种新型的大动态范围，多叠层探测器系统组件之一的纵向电场气体电离室的构造，性能和在中能得离子核反应实验中的应用。