A polymerizable photoredox initiation system for vinyl photopolymerization

A polymerizable photoredox system consisting of 4-methacryl oxbenzophenone (MABP) and N,N-dimethlaminoethyl methacrylate (DMAEMA) used for the photopolymerization of acrylonitrile (AN) was studied. It was found that the polymerization rate is proportional to the 0.93th power for the AN concentration, the 0.28th power for the MABP concentration, and the 0.25th power for the DMAEMA concentration. The overall activation energy of the polymerization obtained is 30.43 kJ/mol. The recorded ESR spectrum indicates that the excited-state MABP abstraets hydrogen mainly from the methyl group of the dimethylamino moiety. The comparison of the initiation ability of polymeric MABP or polymeric DMAEMA with their monomeric forms has also been done and the results indicate that in good solvents P (MABP) has a much higher initiation ability than that of monomeric MABP, but monomeric DMAEMA and P (DMAEMA) display almost the same initiation ability. In poor solvent, the initiation ability of P (MABP) is not so obviously higher than that in good solvents. The result of UV analysis of P (AN) initiated by the MABP–DMAEMA system indicates that both MABP and DMAEMA not only initiate the photopolymerization of AN, but also enter into P (AN) polymer chains. © 1994 John Wiley & Sons, Inc.     

STRUCTURE REPRESENTATION OF THE SPECIFIC FRACTIONS FROM PINGSHUO COAL

Basic data of four fractions, PM₁, PM₆, PM₇and PM₈, derived from Pingshuo bituminous coal were obtained by ultimate analyses, mean molecular weight measure, GC/MS, ¹³C-NM R, ¹H-NM R and FTIR technigues. A method of calculating the average molecular parameters of the fractions is introduced. Based on the calculated parameters, the molecular structure models of the fractions of PM₆, PM;and PM₈are constructed. Significant structural information about the saturated hydrocarbon and aromatic hydrocarbon with heteroatom groups is given also.     

单齿泵削角的优化设计

给出了单齿泵削角的优化模型与计算实例，并对理论设计与实验进行了比较分析。     

微机模拟处理pH络合滴定法研究——Ⅱ.终点确定方法和最佳实验条件模拟估计程序

本文利用简便的滴定过程模型,确立了微机模拟处理实验数据,方便、准确地求解络合滴定等当点的方法。设计了最佳实验条件模拟估计程序。该法测定Zn~(2+),Pb~(2+),Cu~(2+),Fe~(3+)结果的相对误差Δ<1％。pH=6-7时,测定Ca~(2+)的相对误差为-1.61％;σ<0.001mmol,(N=5)。     

Reversible watermarking scheme with image-independent embedding capacity

Permanent distortion is one of the main drawbacks of all the irreversible watermarking schemes. Attempts to recover the original signal after the signal passes the authentication process are being made, starting just a few years ago. Some common problems, such as salt-and-pepper artefacts owing to intensity wraparound and low embedding capacity, can now be resolved. However, some significant problems remain unsolved. First, the embedding capacity is signal-dependent, i.e., capacity varies significantly depending on the nature of the host signal. The direct impact of this is compromised security for signals with low capacity. Some signals may be even non-embeddable. Secondly, while seriously tackled in irreversible watermarking schemes, the well-known problem of block-wise dependence, which opens a security gap for the vector quantisation attack and transplantation attack, are not addressed by researchers of the reversible schemes. This work proposes a reversible watermarking scheme with near-constant signal-independent embedding capacity and immunity to the vector quantisation attack and transplantation attack.     

坑道用水下堵漏剂的研制

坑道水下堵漏剂的研制包括F－1、F－2和F－3型。其中F－1是一种有机堵漏剂，它可以在水中固化；F－2是一种无机防水堵漏剂，施工方便；F－3是速凝型，它可在瞬间固化，能对坑道的涌水口进行堵漏。     

Simulation of programmable logic controller

The development and test of a PLC control program takes time, increases equipment down-time, and might damage hardware due to program errors. All of these problems can be eliminated if there is a computer simulation system for testing control programs off line. This paper presented a new method, called Direct Sequential Method, for simulating PLCs. This method resolves a ladder logic sequentially by applying a series of logic deductions. This simulation system has been implemented in C and tested successfully.     

推力矢量控制技术在导弹上的应用及发展

简要介绍了推力矢量控制技术的概念,分析了推力矢量控制的基本原理及特点.在简要分析其技术发展历程的基础上,给出了导弹推力矢量技术的现状和发展趋势.