影响聚合物段塞流变性因素的研究

本文针对我国表面活性剂/聚合物驱油的实际,研究了石油磺酸盐(PS)、正丁醇(R_4OH)和矿化水对水解聚丙烯酰胺(HPAM)溶液流变性的影响。结果表明,PS对HPAM溶液流变性的影响与介质的矿化度有关:非矿化水介质中,PS对HPAM溶液性质的影响类似于无机盐,能降低HPAM溶液的表现粘度(η_α)和稠度系数(k);当系统中含有一定浓度矿化水时,PS却能升高系统的η_α和k值,降低流型指数(n),使系统的非牛顿性增强。在含有PS和矿化水的HPAM系统中加入R_4OH,系统的η_α和k值会有所增加。     

有杆泵抽油系统可靠性分析

抽油机井有杆果采油装置检泵故障数据的特点在于相邻两次检泵间隔之间的时间并非总是来自同一总体，可能有某种趋势的变化。通过对故障数据的趋势性检验，可验证其对某一随机过程模型的适应性，从而判定某一口井或某一批工况大致相同油井的运行可靠性，实现对生产井运行可靠性的定量评估。还通过实例说明了有杆泵抽油系统检泵故障数据的可靠性分析方法。     

Designing circuits with partial scan

In this scan design methodology, only selected faults are targeted for detection. These faults are those not detected by the designer's functional vectors. The test generator decides exactly which flip-flops should be scanned using one of two methods. In the first method, all possible tests are generated for each target fault, and the set of tests requiring the fewest flip-flops is selected. In the second method, only one test is generated for each fault, and the use of flip-flops is avoided as much as possible during test generation. Examples of actual VLSI circuits show a savings of at least a 40% in full-scan overhead     

线性规划模型的自动生成与求解

本文描述了《有色企业经济活动分析决策支持系统》模型库中线性规划模型的自动生成与求解系统的设计思想、方法及实现     

采用同调约束快速识别的有功校正控制计算

本文发展了文(5)提出的同调约束概念,将同调约束进一步分为正同调约束和反同调约束两组。文中提出了一种新的同调约束识别方法,不必增加任何计算便可快速识别出正反同调约束,显著地降低了解题规模。IEEE30节点样本网络的计算实例证实了本文方法的有效性。     

Efficiency improvement of near-ultraviolet InGaN LEDs using patterned sapphire substrates

The use of conventional and patterned sapphire substrates (PSSs) to fabricate InGaN-based near-ultraviolet (410 nm) light-emitting diodes (LEDs) was demonstrated. The PSS was prepared using a periodic hole pattern (diameter: 3 /spl mu/m; spacing: 3 /spl mu/m) on the (0001) sapphire with different etching depths. From transmission-electron-microscopy and etch-pit-density studies, the PSS with an optimum pattern depth (D/sub h/=1.5 /spl mu/m) was confirmed to be an efficient way to reduce the thread dislocations in the GaN microstructure. It was found that the output power increased from 8.6 to 10.4 mW, corresponding to about 29% increases in the external quantum efficiency. However, the internal quantum efficiency (@ 20 mA) was about 36% and 38% for the conventional and PSS LEDs, respectively. The achieved improvement of the output power is not only due to the improvement of the internal quantum efficiency upon decreasing the dislocation density, but also due to the enhancement of the extraction efficiency using the PSS. Finally, better long-time reliability of the PSS LED performance was observed.     

Location management of correlated mobile users in the UMTS

In this paper, we propose concurrently searching for correlated mobile users in mobile communications networks. Previous work either focuses on locating a single mobile user or assumes that the locations of mobile users are statistically independent. We first propose a mobility model in which the movements of mobile users are statistically correlated. Next, we use the theory of Markov chain to derive the joint probability density function of the locations of mobile users. In addition, we propose a novel approach to discover the correlations among the locations of mobile users without explicitly calculating the joint probability density function. Our simulation results indicate that exploring the correlations among the locations of mobile users could significantly reduce the average paging delay and increase the maximum stable throughput.     

Luminescence Characterization of Mg Doped Y2O2S:Ti Long Afterglow Phosphor

Y1.94-xMgxO2S:0.06Ti (0≤x≤0.10) phosphors with long afterglow were synthesized by solid state reaction route. The photoluminescence spectra, decay curves, thermoluminescent spectra and chromaticity coordinate curves were investigated. The results show that the luminescence intensity of Y1.94-xMgxO2S:0.06Ti (0≤x≤0.10) phosphors decrease gradually with increasing Mg2 ion content, and the shape of luminescence spectra and chromaticity coordinate change as well. Furthermore, two thermoluminescent peaks in single Ti-doped Y2O2S sample are found at 91.8 and 221.5 ℃, respectively. Nevertheless, significant different spectra were found for the Mg, Ti co-doped Y2O2S samples that three thermoluminescence peaks appear at 52.3, 141.7 and 226.8 ℃, respectively. These results indicate that the co-doped Mg ion changes the inherent trap depth of single Ti-doped Y2O2S:Ti phosphor, and induces simultaneously a new trap level in the Y1.94-xMgxO2S:0.06Ti phosphor. Based on the analysis of thermoluminescent spectra, photoluminescent spectra, decay curve and crystal structure defect, it was proposed that the varied structure defect and introduced new trap level by the doped Mg2 ions should be responsible for reducing luminescence intensity and varying color in the Y1.94-xMgxO2S:0.06Ti phosphor.     

JEC-FDTD for 2-D conducting cylinder coated by anisotropic magnetized plasma

The JE convolution finite-difference-time-domain (JEC-FDTD) method is extended to the anisotropic magnetized plasma which incorporates both anisotropy and frequency dispersion at the same time, enabling the transient solution of the electromagnetic wave propagation in anisotropic magnetized plasmas. Two-dimensional JEC-FDTD formulations for magnetized plasma are derived. The back scattering radar cross section (RCS) of a perfectly conducting cylinder coated by a layer of magnetized plasmas is calculated.     

剂量率对聚四氟乙烯辐射裂解的影响

本文研究了在以电子加速器的电子射线为辐射源时,剂量率对PTFE辐射裂解的影响。在剂量相同的条件下,剂量率从1.44×10~4 rad/s增至5.75×10~4 rad/s,裂解效率提高3.3倍。剂量率和各断裂参数(单位剂量裂解度a_0,G(s)值等)均成线性关系。当裂解度一定时,剂量率与剂量成反变关系。