Comparison of a modified Sugiura procedure with portal systemic shunt for prevention of recurrent variceal bleeding in cirrhosis

BACKGROUND: There is no agreement on the management of patients with cirrhosis and recurrent variceal bleeding after failure of medical or endoscopic treatments or both. Portal systemic shunts are highly effective in preventing rebleeding but are associated with a high incidence of chronic encephalopathy. This study compared the results of a slightly modified Sugiura procedure (esophageal transection plus esophagogastric devascularization plus splenectomy) with those of nonselective portal systemic shunts in patients with previous variceal bleeding. METHODS: Fifty-four patients were included in this randomized controlled study between January 1984 and April 1989. The major end point was chronic encephalopathy. Secondary end points were recurrent variceal bleeding, survival, ascites, and hepatocellular carcinoma. RESULTS: Twenty-seven patients were assigned to each group. The rate of chronic encephalopathy was significantly (p = 0.002) lower after modified Sugiura procedure than after portal systemic shunt. Recurrent variceal bleeding was more frequent after modified Sugiura procedure than after portal systemic shunt, but the difference is not significant. One-, two-, and three-year survival rates were 93%, 81%, and 67%, respectively, in the modified Sugiura group and 78%, 66%, and 39%, respectively, in the portal systemic shunt group (p = 0.044). CONCLUSIONS: These results suggest that the modified Sugiura procedure is better overall than the nonselective portal systemic shunt in the management of patients with cirrhosis and recurrent variceal bleeding. Although the rebleeding rate is higher after the modified Sugiura procedure, this does not seem to affect mortality in these patients.     

Structural allograft in two-stage revisions for failed septic hip arthroplasty

We report 11 patients having revision of total hip arthroplasty using massive structural allografts for failure due to sepsis and associated bone loss. All patients had a two-stage reconstruction and the mean follow-up was 47.8 months (24 to 72). Positive cultures were obtained at the first stage in nine of the 11 patients, with Staphylococcus epidermidis being the most common organism. The other two patients had draining sinuses with negative cultures. There was no recurrence of infection in any patient. The mean increase in the modified Harris hip score was 45 and all the grafts appeared to have united to host bone. Two patients required additional procedures, but only one was related to the allograft. Complications included an incomplete sciatic nerve palsy and one case of graft resorption. Our results support the use of massive allografts in failed septic hip arthroplasty in which there is associated bone loss.     

Anti beta 2glycoprotein I antibodies and lupus anticoagulant in patients with recurrent pregnancy loss: prevalence and clinical significance

Over 2000 electrocution deaths were identified among U.S. construction workers from 1980 to 1991, with the highest mean annual crude mortality rate (2.5 per 100,000 people), and second highest mean age-adjusted rate (2.7 per 100,000 people) of all industries. Although the crude fatality rates showed a downward trend, construction workers are still about four times more likely to be electrocuted at work than are workers in all industries combined. Nearly 40% of the 5083 fatal electrocutions in all industries combined occurred in construction, and 80% were associated with industrial wiring, appliances, and transmission lines. Electrocutions ranked as the second leading cause of death among construction workers, accounting for an average of 15% of traumatic deaths in the industry from 1980 to 1991. The study indicates that the workers most at risk of electrical injury are male, young, nonwhite, and electricians, structural metal workers, and laborers. The most likely time of injury is 11 a.m. to 3 p.m. from June to August. Focusing prevention on these populations and characteristics through better methods of worker and supervisor electrical safety training, use of adequate protective clothing, and compliance with established procedures could minimize the average annual loss of 168 U.S. construction workers.     

Vertical ridge augmentation around dental implants using a membrane technique and autogenous bone or allografts in humans

This study investigated the effect on vertical bone regeneration of the addition of demineralized freeze-dried bone allograft or autogenous bone chips to a membrane technique. Twenty partially edentulous patients with vertical jawbone deficiencies were selected for this study. The patients were divided into two groups of 10 individuals. The 10 patients of Group A received 26 Br?nemark implants in 10 surgical sites. The 10 patients of Group B received 32 implants in 12 surgical sites. Fifty-two out of 58 implants (22 in Group A and 30 in Group B) extended 1.5 to 7.5 mm superior to the bone crest. Titanium-reinforced expanded polytetrafluoroethylene membranes were used to cover the implants and, before complete membrane fixation, demineralized freeze-dried bone allograft particles were condensed under the membrane in Group A, and autogenous bone chips were used in Group B. At the reentry after 7 to 11 months the membranes were removed and a small biopsy was collected from 11 sites comprehending the miniscrews. The clinical measurements from Group A demonstrated a mean vertical bone gain of 3.1 mm (SD = 0.9 mm, range 1 to 5 mm) with a mean percentage of bone gain of 124% (SD = 46.6%). The measurements from Group B showed a mean vertical bone gain of 5.02 mm (SD = 2.3 mm, range 1 to 8.5 mm) with a mean percentage of bone gain of 95% (SD = 26.8%). Histomorphometric analysis of the present study clearly demonstrated a direct correlation between the density of the pre-existing bone and the density of the regenerated bone. The mean percentage of new bone-titanium contact was from 39.1% to 63.2%, depending on the quality of the pre-existing bone. Both the clinical and histologic results indicate a beneficial effect of the addition of demineralized freeze-dried bone allograft or autogenous bone particles to vertical ridge augmentation procedures in humans.     

Molecular basis of resistance to HIV-1 protease inhibition: a plausible hypothesis

The binding thermodynamics of the HIV-1 protease inhibitor acetyl pepstatin and the substrate Val-Ser-Gln-Asn-Tyr-Pro-Ile-Val-Gln, corresponding to one of the cleavage sites in the gag, gag-pol polyproteins, have been measured by direct microcalorimetric analysis. The results indicate that the binding of the peptide substrate or peptide inhibitor is entropically driven; i.e., it is characterized by an unfavorable enthalpy and a favorable entropy change, in agreement with a structure-based thermodynamic analysis based upon an empirical parameterization of the energetics. Dissection of the binding enthalpy indicates that the intrinsic interactions are favorable and that the unfavorable enthalpy originates from the energy cost of rearranging the flap region in the protease molecule. In addition, the binding is coupled to a negative heat capacity change. The dominant binding force is the increase in solvent entropy that accompanies the burial of a significant hydrophobic surface. Comparison of the binding energetics obtained for the substrate with that obtained for synthetic nonpeptide inhibitors indicates that the major difference is in the magnitude of the conformational entropy change. In solution, the peptide substrate has a higher flexibility than the synthetic inhibitors and therefore suffers a higher conformational entropy loss upon binding. This higher entropy loss accounts for the lower binding affinity of the substrate. On the other hand, due to its higher flexibility, the peptide substrate is more amenable to adapt to backbone rearrangements or subtle conformational changes induced by mutations in the protease. The synthetic inhibitors are less flexible, and their capacity to adapt is more restricted. The expected result is a more pronounced effect of mutations on the binding affinity of the synthetic inhibitors. On the basis of the thermodynamic differences in the mode of binding of substrate and synthetic inhibitors, it appears that a key factor to understanding resistance is given by the relative balance of the different forces that contribute to the binding free energy and, in particular, the balance between conformational and solvation entropy.     

An epidemiologic, clinical, and therapeutic study of childhood Guillain-Barré syndrome in Kuwait: is it related to the oral polio vaccine?

We studied Guillain-Barré syndrome, affecting children 12 years old or less, throughout Kuwait, in the period between January 1, 1992, and March 31, 1997. Nineteen children had the diagnostic criteria of Guillain-Barré syndrome, with an overall annual incidence rate of 0.95/100,000 population at risk. Female patients outnumbered male patients with a sex ratio of 1.4:1. There was a clustering of cases in winter and spring and in the year 1996. The disease symptoms were relatively severe in our patients because only 16% (3 of 19) of them were able to walk at the height of their illness, whereas the rest were bed or chair bound or needed assisted ventilation. Two patients had the electrodiagnostic features of axonal neuropathy and both had residual deficits on follow-up, whereas the rest recovered fully. All the patients received intravenous immunoglobulin. The mean time to walk unaided was 23.5 days (range, 2-84 days) after intravenous immunoglobulin and excluding the two patients with axonal neuropathy, and full recovery was achieved in a mean time of 103 days (range, 30-300 days). Contrary to previous studies, we found no correlation between oral polio vaccine administration and Guillain-Barré syndrome in 2 successive years (1995 and 1996) during a nationwide campaign targeting children less than 5 years old.     

Shell-element formulation in the static explicit FEM code for the simulation of sheet stamping

In this paper a formulation of degenerated shell elements implemented in the static explicit FEM code ITAS3D is described. The main features of various integration rules are discussed. A square-cup test is used to select the most efficient element for the simulation of stamping processes. A numerical example of FEM simulation of an outer-door-panel stamping is presented.