Crosslinking of polypropylene–polyethylene blends by peroxide and the effect of pentaerythritol tetrallyl ether

Crosslinking of polypropylene–polyethylene (PP-PE) blends involving 10, 20, 30, 40, 50, 60, 70, 80, and 90% of PP with dicumylperoxide (DCP) or tert-butyl perbenzoate (TBPB) and in the presence of coagent pentaerythritol tetrallyl ether (PETA) was investigated at 180°C. It was found that at lower concentrations of peroxide alone (e.g., 2.5% of DCP) only PE component is crosslinked in all compositions of PP-PE blends. In the crosslinking of PP-PE 50:50 with 4% of TBPB, insoluble gel was obtained, which contained 13% PP and 87% PE. If 2% PETA was also used, the portion of PP in gel increased to 39%; the total yield of gel in PP-PE blend increased from 50 to 70%. The lower crosslinking efficiency of coagent PETA in the PP-PE blends compared with PP alone is associated with better solubility of the coagent in the PE phase in contrast to the PP phase. The coagent does not particularly raise the crosslinking efficiency of peroxide in PE, but increases it in the PP phase. A remarkable decrease in melting temperature and temperature of crystallization of both polymer components depending on peroxide concentration was found by calorimetric measurements.     

Separation of stat-copoly(styrene/2-methoxyethyl methacrylate) samples according to composition by gradient high-performance liquid chromatography

Statistical copolymers of styrene (S) and 2-methoxyethyl methacrylate (MEMA) (13–87 mass % of the latter monomer) were investigated by gradient HPLC on columns with either silica or CN-bonded phase packings. The samples were injected in THF solution. The starting eluent was in each case a nonsolvent (isooctane or mixtures of isooctane with THF and methanol). Separation was achieved by increasing the concentration of THF or methanol in the eluent. A calibration mixture of four copolymers (26, 49, 62, and 87% MEMA) was investigated according to the principles of chromatographic cross-fractionation (CCF) by size exclusion chromatography and subsequent gradient HPLC. The influence of molar mass on HPLC retention was small and, for the samples investigated by CCF, independent of copolymer composition. The composition effect on detector signal was also studied. At 230 nm wavelength and with MEMA content in the range between 20 and 40%, the effect was small and caused the average composition calculated from CCF results to deviate from the directly measured value by not more than 0.2 or 0.8% for the two copolymers investigated.     

A Highly Potent and Cellularly Active β‐Peptidic Inhibitor of the p53/hDM2 Interaction

New and improved : The incorporation of a 6‐chlorotryptophan (6‐Cl‐Trp) into a β‐peptide (M)‐3₁₄ helix leads to a high‐affinity hDM2 inhibitor, as demonstrated by fluorescence fluctuation analysis at single molecule resolution. When conjugated to penetratin, the newly derived hDM2 binder specifically inhibits tumour cell growth in vitro.

     

Pharmacological Promiscuity: Dependence on Compound Properties and Target Specificity in a Set of Recent Roche Compounds

What parameters determine promiscuity? A compound's potential for promiscuity (pharmacological activity at multiple targets) may be influenced by molecular parameters such as ionization state, lipophilicity, and molecular weight. In an analysis of recent Roche compounds we found that a positive charge is an important determinant for potential promiscuity; aminergic activity was found to be the main reason for overt promiscuity.

     

CNT Based Elastomer‐Hybrid‐Nanocomposites with Promising Mechanical and Electrical Properties

CNT based elastomer‐hybrid‐nanocomposites prepared by melt mixing have been investigated showing promising results in technologically relevant electrical, mechanical, and fracture‐mechanical properties. It is demonstrated that the incorporation of CNT in silica‐filled natural rubber results in a good dispersion of the CNT. The materials show an enhanced mechanical stiffness and tensile strength, an increased modulus, and a high electrical conductivity with quite low amounts of CNT, though the tear resistance under dynamical loading is slightly reduced. Using DMA and dielectric spectra, a better understanding of the conduction mechanism, the polymer/tube interaction, and the filler networking in CNT nanocomposites is achieved.

     

Application of activated charcoal in the downstream processing of bacterial olefinic poly(3-hydroxyalkanoates)

Medium chain length poly(hydroxyalkanoates) (mcl-PHAs) are bacterial thermoplastic elastomers with a large potential in medical applications. The present study provides a novel process to isolate and purify poly([R]-3-hydroxy-omega-undecenoate-co-3-hydroxy-omega-nonenoate-co-3-hydroxy-omega-heptenoate) (PHUE) and poly([R]-3-hydroxy-omega-undecenoate-co-3-hydroxy-omega-nonenoate-co-3-hydroxyoctanoate-co-3-hydroxy-omega-heptenoate-co-3-hydroxyhexanoate) (PHOUE) from Pseudomonas putida species. Three different types of activated charcoal were compared with regard to their capability to selectively remove impurities. The product 'Charcoal activated, powder, pure' from Merck was found to be most suitable. Using ethyl acetate as solvent, the polyesters were extracted from freeze-dried biomass at room temperature and simultaneously purified by addition of activated charcoal at the beginning of the extraction. The period of extraction was one hour and the ratio solvent to biomass was 15:1 (vol/wt). After extraction, the solids were separated by pressure filtration through a metallic lace tissue. The filtrate was again passed through the previously accumulated filter cake, followed by a second filtration through a 0.45 microm membrane to remove finest coal particles. The resulting filtrate was concentrated, thus yielding polyesters whose quality and yield depended on the quantity of activated charcoal applied. For highly pure PHUE and PHOUE with low endotoxin levels, the optimum ratio of activated charcoal to solvent for extraction (V/V) was found to be 0.5 for PHUE and 0.25 for PHOUE. The yields with regard to the raw polymers amounted to 55 wt% for PHUE and 75 wt% for PHOUE, which are acceptable for polymers that can be used for medical applications.     

Effect of substrate surface roughness on the adherence of NiCrAlY thermal spray coatings

The adherence of plasma sprayed NiCrAlY bond coats can be improved by an appropriate substrate surface finish. The interface fracture energy for crack propagation along the coating/substrate interface has been measured for different surface roughness by means of a specially designed four-point bending test. An increase of the interface fracture energy of about 15% was observed for a three times higher surface roughness. In addition, four-point bending tests with the coating on the side face of bending specimens were performed to analyze the fracture and spalling behavior of the coatings both under large tensile and compressive substrate deformations.     

Thiobarbiturates as sirtuin inhibitors: virtual screening, free-energy calculations, and biological testing

NAD+-dependent histone deacetylases (sirtuins) are enzymes that cleave acetyl groups from lysine residues in histones and other proteins. Potent selective sirtuin inhibitors are interesting tools for the investigation of the biological functions of these enzymes and may be future drugs for the treatment of cancer or neurodegenerative diseases. Herein we present the results from a protein-based virtual screen of a commercial database with subsequent biological testing of the most promising compounds. The combination of docking and in vitro experimental testing resulted in the identification of novel sirtuin inhibitors with thiobarbiturate structure. To rationalize the experimental results, free-energy calculations were carried out by molecular mechanics Poisson-Boltzmann/surface area (MM-PBSA) calculations. A significant correlation between calculated binding free energies and measured Sirt2 inhibitory activities was observed. The analyses suggested a molecular basis for the interaction of the identified thiobarbiturate derivatives with human Sirt2. Based on the docking and MM-PBSA calculations we synthesized and tested five further thiobarbiturates. The MM-PBSA method correctly predicted the activity of the novel thiobarbiturates. The identified compounds will be used to further explore the therapeutic potential of sirtuin inhibitors.     

Addressing the numbers problem in directed evolution

Our previous contribution to increasing the efficiency of directed evolution is iterative saturation mutagenesis (ISM) as a systematic means of generating focused libraries for the control of substrate acceptance, enantioselectivity, or thermostability of enzymes. We have now introduced a crucial element to knowledge-guided targeted mutagenesis in general that helps to solve the numbers problem in directed evolution. We show that the choice of the amino acid (aa) alphabet, as specified by the utilized codon degeneracy, provides the experimenter with a powerful tool in designing "smarter" randomized libraries that require considerably less screening effort. A systematic comparison of two different codon degeneracies was made by examining the relative quality of the identically sized enzyme libraries in relation to the degree of oversampling required in the screening process. The specific example in our case study concerns the conventional NNK codon degeneracy (32 codons/20 aa) versus NDT (12 codons/12 aa). The model reaction is the hydrolytic kinetic resolution of a chiral trans-disubstituted epoxide, catalyzed by the epoxide hydrolase from Aspergillus niger. The NDT library proves to be of much higher quality, as measured by the dramatically higher frequency of positive variants and by the magnitude of catalyst improvement (enhanced rate and enantioselectivity). We provide a statistical analysis that constitutes a useful guide for the optimal design and generation of "smarter" focused libraries. This type of approach accelerates the process of laboratory evolution considerably and can be expected to be broadly applicable when engineering functional proteins in general.     

The promotional effect of Cr on catalytic activity of Pt/ZSM-35 for H2-SCR in excess oxygen

Selective catalytic reduction of NO by hydrogen was studied over Cr modified Pt/ZSM-35 catalysts. The preparation process greatly influenced catalytic activity and sample prepared by co-impregnation method exhibits the best activity. In situ DRIFT studies revealed that on Pt–Cr/ZSM-35, (1) new Pt-NO^δ+ and NO species adsorbed on Pt were detected upon NO + O₂ adsorption; (2) much more ammonia species were formed under reaction condition. Cr addition not only enhanced the adsorption of NO_x but also promoted the formation of surface NH₄⁺ species, which should be the origin of promotional effect of Cr on Pt/ZSM-35 for H₂-SCR reaction.