Assessing the Potential Content of Ethyl Carbamate in White,Red, and Rosé Wines as a Key Factor for Pursuing Urea Degradation by Purified Acid Urease

The ethyl carbamate (EC) content of a wine after a given temperature‐time storage was theoretically predicted from the potential concentration of ethyl carbamate (PEC), as determined via an accelerated EC formation test. Such information was used to decide whether an enzymatic treatment was needed to reduce the wine urea level before bottling/aging. To this end, 6 white, red, and rosé wines, manufactured in Italy as such or enriched with urea, were tested for their PEC content either before or after enzymatic treatment using a purified acid urease preparation derived from Lactobacillus fermentum. The treatment was severely affected by the total phenolic content (TP) of the wine, the estimated pseudo‐first‐order kinetic rate constant for NH₃ formation reducing by a factor of approximately 2000 as the TP increased from 0 to 1.64 g L^‐1. Such a sensitivity to TP was by far greater than that pertaining to a killed cell‐based enzyme preparation used previously. Urea hydrolysis was successful at reducing EC concentration in wines with low levels of TP and other EC precursors.     

Stock diffusion theory: a dynamic model for inventory control

This paper proposes a dynamic approach for inventory management, which can be used for a definitely non stationary demand whose rate evolves both in mean and in variance. Specifically, the stock consumption is modelled as a Markov process with a slow diffusion term and the Fokker Planck equation is used to derive the probability distribution of the stock consumption and that of the reorder time. The knowledge of these distributions makes it possible to manage the inventory in a dynamical way and to keep the safety stock to a minimum level. To test the model, some typical demand patterns are used: results demonstrate its ability to capture both the evolution of the mean and that of the variance of the demand.     

Curvature Ratio Effect on Two-Phase Pressure Drops in Horizontal Return Bends: Experimental Data for R134a

This article presents 154 pressure drop data points measured during two-phase flow of R-134a in horizontal return bends. The tube diameter is constant at 10.85 mm and the curvature ratio is either 7.74 or 5.53. Saturation temperature varies from 15 to 20°C, vapor quality from 0.05 and 0.95, and mass velocity ranges from 300 to 600 kg m^?2 s^?1. Return bend pressure drops are calculated by subtracting the straight tube pressure drop from the total measured pressure drop along the bend. The perturbations induced up- and downstream of the singularity are taken into account in the measurements. The comparison of the pressure drops for the two configurations (curvature ratio of 5.53 and 7.74) showed that they are greater (about 10%) for the larger curvature ratio. This can be attributed to the effect of the developed length on the pressure drop; on the other side the pressure gradients are larger for the lower curvature ratio, which can be explained by the effect of the centrifugal force and the perturbations up- and downstream of the return bend. The experimental data are compared against four prediction methods available in the literature. The Domanski and Hermès correlation is the best at predicting the present data.     

Disposable indicators for monitoring lighting conditions in museums

Photoinduced alterations of light-sensitive artifacts represent one of the main problems that conservators and curators have to face for environmental control in museums and galleries. Therefore, increasing attention has been recently devoted to developing strategies of indoor light monitoring, especially aimed at minimizing the cumulated light exposure for the objects on exhibit. In this work a prototype of a light dosimeter, constituted by a photosensitive dyes/polymer mixture applied on a paper substrate, is presented. This indicator, specially designed for a preventive assessment of the risk of damage for highly light-sensitive objects, undergoes a progressive color variation as its exposure to the light increases. Different, easily distinguishable color steps are exhibited depending on the light dose received, so that the dosimeter can be used straightforwardly to have a first, instrumentation-free estimation of the total light exposure. A reflectance spectroscopy study in the 350-860 nm range was carried out on prototype dosimeters exposed to light emitted from a tungsten-halogen lamp to investigate the response of the dosimeter to the light and to study the fading mechanism. Two different approaches were evaluated for the calibration of the prototype: colorimetry and principal component analysis of the reflectance spectra. The usefulness of the two methods in providing a quantitative indication of the light dose received was evaluated.     

Catalytic steam gasification of Miscanthus X giganteus in fluidised bed reactor on olivine based catalysts

The Miscanthus X giganteus (MXG) presents many advantages (high yield, perennial crop, easy harvesting…) so it can be considered as a good candidate in terms of renewable energy sources. Several works have been carried out and were devoted to the MXG, especially in the agricultural field, but this study is the first which deals with gasification in order to produce syngas. The catalytic steam gasification of MXG in a fluidised bed reactor into presence of olivine based catalysts was investigated. Three parameters were studied, the temperature (800 °C and 900 °C), the pellets size (6 mm and 8 mm) and the nature of catalyst (olivine and Ni/olivine). Noteworthy is the efficiency shown by the Ni/olivine at 800 °C, which leads to the production of 1.7 m³ kg^− 1 daf of gas, containing 50% of H₂. Ni/olivine catalyst was characterised by XRD, TPR and SEM-EDX in order to monitor its structural changes during the process. Moreover, a solvent system of tar recovery was tested, which allows to obtain a more representative set of the whole tars. Then, the tars composition was determined by GC/MS. The identification of different compounds shows the presence of different PAHs, in majority naphthalene.     

Proprotein Convertase Subtilisin Kexin Type 9 Inhibitors Reduce Platelet Activation Modulating ox-LDL Pathways

Background: Proprotein convertase subtilisin kexin type 9 inhibitors (PCSK9i) lower LDL-cholesterol and slow atherosclerosis preventing cardiovascular events. While it is known that circulating PCSK9 enhances platelet activation (PA) and that PCSK9i reduce it, the underlying mechanism is not still clarified. Methods: In a multicenter before–after study in 80 heterozygous familial hypercholesterolemia (HeFH) patients on treatment with maximum tolerated statin dose ± ezetimibe, PA, soluble-NOX2-derived peptide (sNOX2-dp), and oxidized-LDL (ox-LDL) were measured before and after six months of PCSK9i treatment. In vitro study investigates the effects of plasma from HeFH patients before and after PCK9i on PA in washed platelets (wPLTs) from healthy subjects. Results: Compared to baseline, PCSK9i reduced the serum levels of LDL-c, ox-LDL, Thromboxane (Tx) B2, sNOX2-dp, and PCSK9 (p < 0.001). The decrease of TxB2 correlates with that of ox-LDL, while ox-LDL reduction correlated with PCSK9 and sNOX2-dp delta. In vitro study demonstrated that wPLTs resuspended in plasma from HeFH after PCSK9i treatment induced lower PA and sNOX2-dp release than those obtained using plasma before PCSK9i treatment. This reduction was vanished by adding ox-LDL. ox-LDL-induced PA was blunted by CD36, LOX1, and NOX2 inhibition. Conclusions: PCSK9i treatment reduces PA modulating NOX2 activity and in turn ox-LDL formation in HeFH patients.     

Rhodium‐Catalyzed Enantioselective Hydrogenation of (E)‐Enol Acetate Acids

The novel rhodium complex [Rh(S)‐Phanephos(cod)]‐catalyzed hydrogenation of disubstituted (E)‐enol acetate carboxylic acids is reported. The catalytic cycle works under 30 bar of hydrogen under conventional heating giving different 3‐acetoxy‐2,3‐disubstituted carboxylic acids with ee ≥90%. Hydrogenation occurred also under microwave dielectric heating without eroding the enantioselectivity but improving the overall efficiency of the process. With microwaves, hydrogen pressure and reaction time required for complete hydrogenation dropped to 5 bar and 30 min, respectively. The best performance of this catalyst under microwave irradiation was TON 100, TOF 196 h⁻¹ with ee 99% on a 6‐g scale.