Chemical,thermal, and mechanical properties and ultraviolet transmittance of novel nano-hydroxyapatite/polyethylene terephthalate milk bottles

Polyethylene terephthalate (PET)/nano-hydroxyapatite (nHAp) composite granules were obtained using twin-screw extruder. Preforms were prepared by injection molding and then PET/nHAp bottles were produced by blow molding. For PET bottles with nHAp, the migration amounts of carboxylic acid (COOH), acetaldehyde (AA), diethylene glycol (DEG), and isophthalic acid (IPA); glass transition temperature (T_g); melting temperature (T_m); and the maximum crystallization temperature (T_cry) were measured. The load-carrying capacity, burst strength, stress cracking, and regional material distribution tests were carried out on the bottles. X-ray diffraction, scanning electron microscopy, Fourier transform infrared spectroscopy, differential scanning calorimetry, and ultraviolet transmittance analyses were conducted to explain the changes in mechanical, chemical, physical properties, and light transmission of bottles. It was found out that the COOH amount increased and the AA content decreased with increasing nHAp amount. On the other hand, no change was observed in the amounts of DEG and IPA. Although the mechanical properties such as load-carrying capacity and burst strength of the bottles have improved, it has been determined that the standard environmental stress crack resistance test procedure cannot be applied to such a composite. Experimental findings indicate that nHAp disrupts the chemical structure of PET and it isolates harmful chemicals such as AA by forming intermolecular bonds. Moreover, with the addition of up to 0.8% nHAp, PET bottles block the light transmission approximately 80% within 400–700 nm wave length zone. The study demonstrates that the PET/nHAp composite bottles can be used in the food industry, particularly in the packaging of milk and milk products which are vulnerable to light exposure.     

Analysis of corrosion behavior of LY12 in sodium chloride solution with wavelet transform technique

1　ＩＮＴＲＯＤＵＣＴＩＯＮＴｈｅｓｔｕｄｙｏｆｓｐｏｎｔａｎｅｏｕｓｃｕｒｒｅｎｔｏｒｐｏｔｅｎｔｉａｌｆｌｕｃ ｔｕａｔｉｏｎｓ,ｗｈｉｃｈｈａｓｂｅｅｎｄｅｓｉｇｎａｔｅｄａｓｅｌｅｃｔｒｏｃｈｅｍｉｃａｌｎｏｉｓｅ(ＥＮ) ,ｆｏｒｔｈｅｃｈａｒａｃｔｅ     

Cu-16%Sn-8%P合金的球状Cu3P与热处理特性

利用金相和电子探针研究了Cu-16%Sn-8%P合金的微观结构,热处理条件对合金结构和硬度的影响.结果表明:在Cu-16%Sn-8%P合金中,P主要以Cu3P化合物形式存在,在Sn的影响下该化合物形成非常圆整的球状;Sn以Cu10Sn和Cu5Sn两种化合物存在.在560℃下保温,时间越长淬火组织中形成的条状Cu3P化合物越多,球状Cu3P化合物直径越小;硬度先降低,然后大幅度升高.对淬火组织进行退火处理,可进一步促进Cu3P化合物以块状、条状形态析出.     

微机点焊恒流控制器的研究

本文介绍了以８０３１单片机为主控单元的微机点或焊恒流控制器的基本硬件结构、工作原理及系统的主要功能和特点。     

Effect of trace rare earth element Er on high pure Al

1　INTRODUCTIONAsit swellknown ,Chinaisrichinrareearths ,whoseprovedreservesare 80 %ofthetotalreservesoftheworld ,rankingfirstintheworld .Atpresent,theresearchandapplicationofREinsteel&ironareratherprofoundinChina .ThoughtheapplicationandstudiesaboutREinaluminumanditsalloysbeganearly ,it snotuntillateinthe 1970 sthattheinvesti gationandexploitationbeganonalargescaleandgraduallycametoaclimax[13] .Inthepast ,there searchofREaluminummainlyfocusedontheapplica tionofsomeelementssuchasLa ,…     

Graphite intercalated polymer coatings on stainless steel

The use of graphite modified polymer films has been investigated, on stainless steel. Polythiophene and polypyrrole films have been synthesized electrochemically on stainless steel, and then very thin graphite layers were realized on polymer films. Since the graphite layer is not applicable as a top coat, polymeric top films were also electrosynthesized on graphite layers. Following this procedure, polypyrrole-graphite-polypyrrole and polythiophene-graphite-polythiophene coatings have been obtained on stainless steel. The corrosion behaviours of coated samples have been investigated in 0.1 M H₂SO₄ solution, by means of electrochemical impedance spectroscopy (EIS) and anodic polarization curves. The intercalation of graphite layer altered the performance and properties of coatings significantly. Especially, polypyrrole coating system was found to exhibit almost an excellent coating behaviour that hindered the attack of corrosive environment within 96 h exposure time. The EIS results of polypyrrole coating system were indicating to almost a perfect capacitive behaviour that the response was reflecting capacitive behaviour in a wide frequency region. This property was also examined with successive cyclic voltammograms in a potential range between 0.10 and 0.40 V (vs. Ag/AgCl). The charge densities involved in oxidation and reduction regions were determined for successive cycles and it was shown that coated sample was able to exhibit charge-discharge (i.e. oxidation and reduction) behaviour successfully, without any degradation.     

一种基于Matrix的QR分解向量化方法

提出一种基于Matrix的Givens旋转的QR分解向量化方法。针对Matrix的体系结构特点,对向量数据访存和计算进行优化,使计算均衡分布到各个向量处理单元;设计双缓冲DMA的数据传输策略,使得内核的计算与DMA数据搬移的时间完全重迭,内核始终处于峰值计算,从而取得最佳的计算效率。实验结果表明,该方法能够取得较高的计算效率和性能加速比。     

High-capacity quantum key distribution using Chebyshev-map values corresponding to Lucas numbers coding

We propose an approach that achieves high-capacity quantum key distribution using Chebyshev-map values corresponding to Lucas numbers coding. In particular, we encode a key with the Chebyshev-map values corresponding to Lucas numbers and then use k-Chebyshev maps to achieve consecutive and flexible key expansion and apply the pre-shared classical information between Alice and Bob and fountain codes for privacy amplification to solve the security of the exchange of classical information via the classical channel. Consequently, our high-capacity protocol does not have the limitations imposed by orbital angular momentum and down-conversion bandwidths, and it meets the requirements for longer distances and lower error rates simultaneously.     

无线传感器网络分簇路由节能研究

在大规模传感和环境监测中,节约能源延长传感器节点生命已成为无线传感器网络最重要的研究课题之一。提供合理的能源消耗和改善无线网络生命周期的传感器网络系统,必须设计一种新的有效的节能方案和节能路由体系。方案采用一种聚类算法减少无线传感器网络的能量消耗,创建一种cluster-tree分簇路由结构的传感器网络。该方案主要目标是做一个理想的分簇分配,减少传感器节点之间的数据传输距离,降低传感器节点能源消耗,延长寿命。实验结果表明,该方案有效地降低了能源消耗从而延长无线传感器网络生命。     

虚拟环境下Web服务动态负载均衡策略改进

为了提高Web服务集群的伸缩性和自动化能力,从虚拟化和负载均衡两方面研究集群系统,对现有负载采集策略做了改进,设计并实现了一种可根据负载值自动控制集群规模的模型XCluster。新模型运行在Xen提供的虚拟化环境中,实时监视宿主机层和虚拟机层的负载状态,随着集群系统总负载的增长,逐渐引入新的虚拟机来扩大集群规模,同时将任务合理分配到各个虚拟机节点上;当总负载下降时,逐渐关闭虚拟机缩小集群规模,释放出来的硬件资源又可以提供给其他集群系统使用。理论分析和实验结果表明,XCluster只需占用很少的网络通信量完成信息收集和命令下达,能够充分利用虚拟机易于管理的优势完成后端节点的调度,并且在任务总量相同的情况下,使用尽可能少的集群节点来执行任务。