Strongyloidiasis associated with nephrotic syndrome

We report a nephrotic syndrome patient with eosinophilia who developed ileus, epigastralgia and malabsorption due to strongyloidiasis which became symptomatic by steroid therapy. The patient was then treated with thiabendazole and recovered. A percutaneous renal biopsy revealed minimal change nephrotic syndrome. This renal injury may be brought on by severe infection of Strongyloides stercoralis. It is important to rule out strongyloidiasis prior to corticosteroid therapy to patients from eosinophilia endemic areas.     

Titania NOx sensors for exhaust monitoring

Oxide semiconductors have been examined to develop NO_x sensors for exhaust monitoring. Titania doped with trivalent elements, such as Al³⁺, Sc³⁺, Ga³⁺ or In³⁺, has a good sensitivity and selectivity to NO between 450 and 550 °C, and shows rapid response. A sensor probe for monitoring exhaust NO_x has been fabricated. Many kinds of interference gases, such as C₃H₆, CO and SO₂, have been found to have only a slight influence on the sensor response to NO. The influence of O₂ and H₂O is also negligible, except for the cases of 0% H₂O and fuel-rich conditions. In accordance with these results, the sensor probe operates satisfactority in the exhaust gas of various combustion conditions without interference from the various kinds of gas species in the exhaust gases.     

Path tracking control of Lagrange systems with obstacle avoidance

This paper addresses a path tracking problem with obstacle avoidance for Lagrange systems. The proposed method is based on field potential methods in combination with navigation functions for obstacle avoidance. First, it is shown that a simple combination of the navigation function with the conventional path tracking controller does not work. Therefore, in order to cope with this problem, a new feedback law is proposed for a path parameter which characterizes the reference path. It is proved that the proposed controller achieves both path following and collision avoidance. Moreover, since the method adopts bounded navigation functions, the proposed controllers generate bounded input signals even when target systems approach obstacles. Finally, an experimental evaluation is performed with a two-link manipulator to illustrate the effectiveness of the proposed method.     

Pseudo-binary system Bi2O3-TeO2 in air

The phase equilibria in the pseudo-binary system Bi₂O₃-TeO₂ at 600° 950° C in air were examined by solid-state reaction techniques and X-ray powder diffraction method. Four pseudo-binary compounds appeared, i.e., -Bi₂O₃ type solid solution having a compositional range of (1-x)Bi₂O₃·xTeO₂ wherex=0 0.4 a new compound Bi₆Te₂O₁₅ which has an orthorhombic cell of a=2.27(4) nm, b=1.06(1) nm and c = 0.539(8) nm, 2Bi₂O₃ · 3TeO₂, and an unidentified phase Bi₂O₃·2TeO₂. The formation of the phase Bi₆Te₂O₁₅, in which all the Te ions are hexavalent, was confirmed by the thermogravimetry and by the Mössbauer spectra. The liquidus curves for whole system were determined by DTA method.     

Effect of Silicon Dioxide on the Thermal Diffusivity of Aluminum Nitride Ceramics

The thermal diffusivity of AlN ceramics was significantly decreased by the addition of SiO₂. The AlN ceramics with 4 wt% SiO₂ could not be densified by pressureless sintering in the temperature range 1400° to 1800°C. The thermal diffusivity of these samples was very low because of their porous structure. The AlN ceramics containing 2, 4, and 8 wt% SiO₂ were densified by hot-pressing and also had low thermal diffusivity. In these samples, the grains of the 27R polytype that resulted from the reaction between AlN and SiO₂ were dispersed, obstructing the conduction of heat. The relation between the amount of 27R polytype and the thermal diffusivity of the AlN ceramics was determined.     

Reverse osmosis separation of hydrocarbons in aqueous solutions using porous cellulose acetate membranes

A physicochemical parameter, represented by the symbol Σs^*, based on molar solubility in water and molar attraction constants of Small, has been developed to express quantitatively the relative hydrophobicity, or nonpolar character, of the hydrocarbon molecule. The value of Σs^* can be calculated for a hydrocarbon from its chemical structure. The scale of Σs^* is consistent within each group of aromatic, cyclic, and noncyclic hydrocarbons. Reverse osmosis data have been obtained at 250 psig for single-solute aqueous feed solution systems involving low concentrations of 39 different hydrocarbons (including 13 aromatics, 10 cyclic, and 16 noncyclic compounds) and several samples of cellulose acetate membranes of different surface porosities. The effect of operating pressure on membrane performance has also been studied for two aromatic hydrocarbon solutes. The values of Σs^* for the solutes used were in the range of 425 to 924 for aromatic hydrocarbons, 521 to 931 for cyclic hydrocarbons, and 369 to 960 for noncyclic hydrocarbons. The reverse osmosis data have been correlated with Σs^* for each group of hydrocarbons studied. In all cases, positive solute separations were obtained, and the ratio [PR]/[PWP] was less than 1. With respect to each film, solute separation increased with increase in Σs^*, and decreased with increase in operating pressure. Also, solute separation decreased in the order aromatic hydrocarbon > cyclic hydrocarbon > noncyclic hydrocarbon at any given value of Σs^*. At a given operating pressure, for low values of Σs^* (～500 or less) solute separation increased with progressive decrease in average pore size on the membrane surface. For high values of Σs^* (～800 or more), solute separation initially increased with decrease in average pore size, then passed through a maximum and minimum with further decrease in average pore size, and again increased with still further decrease in average pore size. The results are discussed on the basis of preferential sorption of solute at the membrane–solution interface under the experimental conditions studied.     

Reverse osmosis separations of polyethylene glycols in dilute aqueous solutions using porous cellulose acetate membranes

Reverse osmosis separations of eight polyethylene glycol (PEG) solutes in the average molecular weight range of 200 to 6750 in single-solute dilute aqueous solutions have been studied using porous cellulose acetate membranes at the operating pressures of 50, 75, and 100 psig. Diffusivity data for the above PEG solutes have also been obtained from experimental data on intrinsic viscosities. From an analysis of all experimental data, numerical values for the parameters representing the polar (?ΔΔG/RT), steric (δ^*ΣE_s), and nonpolar (ω^*Σs^*) forces governing reverse osmosis separations of PEG solutes have been generated. These numerical values are useful for precise characterization of cellulose acetate membranes for whose specifications sodium chloride is not the appropriate reference solute because of its low or practically negligible separation under reverse osmosis operating conditions. This work also illustrates that solute separation in reverse osmosis can predictably increase or decrease with increase in operating pressure depending on experimental conditions.     

Effect of compressive and tensile strains on the electrical resistivity of carbon microcoil/silicone-rubber composites

Spring-shaped carbon microcoils (CMCs) were embedded in silicone-rubber to form CMC/silicone-rubber composites. The electrical and mechanical properties of the composites were examined and compared with those of the composites involving straight carbon nanofibers and carbon blacks as a conductor. The electrical resistivity of the CMC/silicone-rubber composites decreased dramatically by increasing the CMC content and was as low as 100 Ω cm at 10% CMC volume content. With a compressive or tensile strain, the resistivity increased sharply much more than that of the other composites. The high resistive sensitivity of the composites is ascribed to an easy-to-deform configuration of the CMCs in the composites under an applied stress.     

Oxidation of unsaturated and hydroxy fatty acids by ruthenium tetroxide and ruthenium oxyanions

The reactions of ruthenium VIII tetroxide (RuO₄) and the ruthenium VII and VI oxyanions, perruthenate (RuO₄ ⁻) and ruthenate (RuO₄ ⁼) with hydroxy substituted and unsaturated fatty acids have been studied. At a 1:1 molar ratio, ruthenium tetroxide (RuO₄) and both oxyanions (RuO₄ ⁻ and RuO₄ ⁼) oxidized 12-hydroxystearic acid to 12-ketostearic acid. With 9, 10-dihydroxystearic acid, the type of oxidation products obtained depended on the amount of ruthenium oxidant used. At high ratios of oxidant to substrate, cleavage to pelargonic and azelaic acids occurred whereas at lower ratios, partial oxidation to diketo and acyloin derivatives predominated. The oxidation of oleic acid with excess ruthenium tetroxide (RuO₄) or perruthenate anion (RuO₄ ⁻) gave the cleavage products pelargonic and azelaic acid through the intermediate formation of dihydroxy and diketo intermediates. Ruthenate anion (RuO₄ ⁼) did not react with the double bond of oleic acid. Agricultural Research Service, U.S. Department of Agriculture.     

Method for correcting molecular weight from gel-permeation chromatography. I. Skewing and concentration corrections

The purpose of this paper is to present a metod to calculate real molecular weight averages of polymer samples from GPC chromatograms where the instrumental spreading functions are skewed and the concentration effect exists. In this method, it is assumed that (1) the skewed chromatograms of monodisperse polymer samples can be represented as resultant of halves of two different Gaussians, (2) the resolution factors are regarded as constant in the case of low sample loading, and (3) the peak elution volume is independent of the presence of other components in the case of low sample loading. Adequate monodisperse polystyrenes and the mixtures (binary, seven and ten components) were examined for this purpose; and the molecular weight averages calculated by this method were compared with the ones obtained by Rosen and Provder's method. From the results in our study, it is found that this method can be available for correcting molecular weight from GPC chromatograms except for very narrow high molecular weight samples.