Normal-incidence InAs self-assembled quantum-dot infrared photodetectors with a high detectivity

An InAs/AlGaAs quantum-dot infrared photodetector based on bound-to-bound intraband transitions in undoped InAs quantum dots is reported. AlGaAs blocking layers were employed to achieve low dark current. The photoresponse peaked at 6.2 /spl mu/m. At 77 K and -0.7 V bias, the responsivity was 14 mA/W and the detectivity, D*, was 10/sup 10/ cm/spl middot/Hz/sup 1/2//W.     

SAR-retrieved wind in polar regions-comparison with in situ data and atmospheric model output

European remote sensing (ERS) satellites synthetic aperture radar (SAR) wind retrievals using CMOD-IFR2 are, for the first time, retrieved in the marginal ice zone (MIZ) and in Arctic coastal areas and compared with in situ observations from reseach vessels (RVs) and output from a high-resolution atmospheric model. The root mean squares (rms) of the comparisons were 1.6 m s/sup -1/ and 2 m s/sup -1/, respectively. The spatial variation of the SAR wind fields established a decrease in wind speed close to the ice edge for the late summer situations where the wind was along the ice edge with the ice to the left. This decrease is believed to be due to changes in atmospheric stability, possibly through development of an internal boundary layer caused by the cold ice cover and melt water. Lower wind speed near the ice edge is confirmed by the atmospheric model and the in situ observations. Furthermore, good results are obtained from SAR wind retrieval in leads when compared with model output during a cold-air outbreak. Routine measurements in the MIZ are useful for estimating the wind stress, and therefore SAR may play an important role in this region. Finally, the identification of a jet out from Hinlopen Strait in the Svalbard region and low wind wakes along the coast in the SAR-retrieved wind field is confirmed by in situ observations as the RV moves through the region. The jet is also confirmed by the atmospheric model, which is able to reproduce the situation.     

Flicker noise in gate overlapped polycrystalline silicon thin-filmtransistors

A study of the noise performance of gate overlapped polycrystalline silicon thin-film transistors (TFTs) is presented. Low-frequency noise measurements were carried out on n- and p-type samples fabricated by excimer laser crystallization. It is shown that the carrier number fluctuation model applies not only to n-type but also to p-type devices. The density of oxide traps was extracted from the noise measurements and was of the order of 10¹⁸-10¹⁹ eV^-1 cm^-3     

A 3.3-mW /spl Sigma//spl Delta/ modulator for UMTS in 0.18-/spl mu/m CMOS with 70-dB dynamic range in 2-MHz bandwidth

A quadrature fourth-order, continuous-time, /spl Sigma//spl Delta/ modulator with 1.5-b quantizer and feedback digital-to-analog converter (DAC) for a universal mobile telecommunication system (UMTS) receiver chain is presented. It achieves a dynamic range of 70 dB in a 2-MHz bandwidth and the total harmonic distortion is -74 dB at full-scale input. When used in an integrated receiver for UMTS, the dynamic range of the modulator substantially reduces the need for analog automatic gain control and its tolerance of large out-of-band interference also permits the use of only first-order prefiltering. An IC including an I and Q /spl Sigma//spl Delta/ modulator, phase-locked loop, oscillator, and bandgap dissipates 11.5 mW at 1.8 V. The active area is 0.41 mm/sup 2/ in a 0.18-/spl mu/m 1-poly 5-metal CMOS technology.     

GaN and AlGaN high-voltage rectifiers grown by metal-organic chemical-vapor deposition

In this paper, we report the study of the electrical characteristics of GaN and AlGaN vertical p-i-n junctions and Schottky rectifiers grown on both sapphire and SiC substrates by metal-organic chemical-vapor deposition. For GaN p-i-n rectifiers grown on SiC with a relatively thin “i” region of 2 μm, a breakdown voltage over 400 V, and forward voltage as low as 4.5 V at 100 A/cm² are exhibited for a 60-μm-diameter device. A GaN Schottky diode with a 2-μm-thick undoped layer exhibits a blocking voltage in excess of ∼230 V at a reverse-leakage current density below 1 mA/cm², and a forward-voltage drop of 3.5 V at a current density of 100 A/cm². It has been found that with the same device structure and process approach, the leakage current of a device grown on a SiC substrate is much lower than a device grown on a sapphire substrate. The use of Mg ion implantation for p-guard rings as planar-edge terminations in mesageometry GaN Schottky rectifiers has also been studied.     

Accuracy of approximations in MOSFET charge models

This paper analyzes the results of common approximations made in MOSFET charge modeling. The basis for the comparison is a charge-sheet model that is valid in all regions of operation. We show that proper modeling of surface potential as a function of position along the channel is more important for capacitance coefficient modeling accuracy than partitioning of inversion charge between source and drain. In addition, we show that there is a numerical error in previous charge-sheet formulations, and provide a solution for this problem     

An easy-to-use mismatch model for the MOS transistor

In this paper, a physics-based mismatch model is presented. It is demonstrated on a 0.18-/spl mu/m technology that a simple mismatch model can still be used to characterize deep-submicron technologies. The accuracy of the model is examined and found to be within 20% in the strong inversion region. Bulk bias dependence is modeled in a physical way. To extract the mismatch parameters, a weighted fit is introduced. It is shown that the width and length dependence of the mismatch parameters is given by the Pelgrom model.     

50 years of the IEEE Microwave Theory and Techniques Society

The early history of the IEEE Microwave Theory and Techniques Society (IEEE MTT-S) is summarized since its founding in 1952, and all administrative committee members and presidents are listed. Some of the more recent changes resulting from growth and multinational participation are described. Publications are discussed with editors listed for this Transactions, the IEEE Microwave and Wireless Components Letters, the IEEE Microwave Newsletter, and IEEE Microwave Magazine. The chronological evolution of the IEEE MTT-S's awards is presented, including a listing of all award winners. Distinguished lecturers and microwave symposia sites and chairpersons are also discussed. Early technology trends are described