Production of maraging steel grades and the influence of specified and nonspecified elements for special applications

The material properties of maraging steels are greatly affected by the alloy and inclusion content and hence by the production route. This paper describes various past and current production routes at Böhler Edelstahl GmbH and the effect of these routes on the specified element (alloy) and non-specified element (inclusion) contents. Non-metallic inclusions were investigated by EDX analysis. The effects of various alloying and tramp elements on the material properties are presented as a statistical evaluation of previous melts. Nitrogen solubility was calculated with Thermo–Calc for maraging steel Mat.-No. 1.6354 and the precipitation of nitrides is discussed. A proposal is made for the production of melts with improved properties.     

Negative thermal expansion of laminates

Measurements have been carried out on the in-plane and through the thickness thermal expansion coefficients of glass polypropylene fibre composites of 50% volume fraction between room temperature and 120°C. Only in the temperature range 20° to 75°C are reproducible results obtained. It is confirmed that in-plane negative values may be obtained in specific directions. The physical reason for this and its connection with the necessary appearance of a large Poisson ratio is pointed out. The expansivity of the matrix material depends strongly on temperature. Very good agreement between the experimental values and those predicted from the properties of the two constituents is found provided that the value for the expansivity of the polyoropylene is that within the temperature range considered. It is shown that the polypropylene matrix does not provide a matrix which is stable enough in its properties to enable the system to yield consistent negative values of expansivity. An alternative system is proposed and a single experiment confirms that a negative value of the thermal expansivity of as large as –50 × 10^–6 K^–1 may be obtained.     

Preparation and Properties of Er- and Yb-Activated TeO2–WO3 Glasses

TeO₂–WO₃ glasses coactivated with Er³⁺ and Yb³⁺ are prepared. The effect of Yb content on the efficiency of Er photoluminescence (PL) in the visible and IR spectral regions is studied. The highest PL efficiency is achieved at an Er : Yb atomic ratio of 1 : 1. The PL lifetime for the Er^{3+ 4} I _13/2 level is determined to be 7–9 ms.     

Thermodynamic Properties of Alloys and Phase Equilibria in the In–Sb System

New thermodynamic data for the In–Sb system are obtained and compared with calculation results available in the literature. An isothermal vacuum cell and a procedure for electrolyte preparation are described which ensure high measurement accuracy.     

Textural Transitions in a Rotating Slab of 3He-A

The operation of a torsional oscillator for detection, of flow-driven textural transitions in, ³He-A is described. The detection technique, tracking the shift of the resonant frequency of the torsional oscillator, allows us to observe textural changes and the presence of vortices in zero magnetic field. It relies on. the anisotropic superfluid density of ³He-A and its change due to reorientation of the Î-texture caused by counterflow.     

Optical properties of strain-compensated InAs/InGaAsN/GaAsN superlattices

The optical properties of heterostructures comprising InAs/InGaAsN quantum wells in strain-compensated GaAsN/InGaAsN superlattices have been studied. It is demonstrated that, using such superlattices of various design and thickness and with additional InAs monolayer spacers, it is possible to control the wavelength of room-temperature emission from InGaAsN quantum wells within 1.3–1.6 μm without deteriorating the output radiation characteristics, which opens additional prospects for the development of lasers on GaAs substrates for telecommunication applications.