石油污染土壤异位修复生物堆建造关键技术研究

石油污染土壤生物修复技术是未来最具前景的低成本环保治理技术.结合异位生物堆修复关键控制指标,基于土壤多孔介质特性,建立了生物堆通风及灌溉数学模型,数值模拟了强制通风及灌溉过程生物堆内氧气和水的分布规律,给出了通风筛管及注水筛管最优布置方案,分析了通风速度及注水时间对生物堆温度的影响.结果表明:在生物堆建造尺寸确定的情况下,存在最佳的通风筛管及注水筛管布置方案,短时间歇通风对生物堆内温度影响较小,注水灌溉对生物堆内温度有一定影响,堆内温度变化前缘滞后于水相流动前缘.     

先进控制技术在波浪发电系统中的应用

由于波浪储量丰富,具有随机性,如何控制波能转换系统捕获最大波能和控制并网电能质量成为波浪发电的核心问题。简述了波能转换装置实现最大波能捕获的方法,综述了滑模变结构控制、自适应控制、最优控制、智能算法、模糊控制、无源控制在控制最大波能捕获以及改善电能质量方面的研究成果。并提出未来的控制算法应是多种先进控制算法相结合。     

氟化磷酸钒钠在钠离子电池中的应用进展

钠离子电池具有安全性高、钠资源丰富、成本低等独特优势,引起了人们的广泛关注.构建具有良好电化学性能的钠离子电池的关键之一就是正极材料的选取,氟化磷酸钒钠[Na3V2(PO4)2F3]因其结构稳定性好、离子输运快、工作电位高等特点被认为是一种很有前途的正极材料.但电导率较低,使其电化学性能较差;制备成本较高,阻碍了其大规模应用的发展.综述了在提升Na3 V2(PO4)2 F3电化学性能方面的措施,主要包括改进制备方法、离子掺杂、表面包覆等.为今后高性能Na3 V2(PO4)2 F3的合理设计提供了很好的参考.     

主变方向过流保护拒动原因分析

针对某变电站主变10 kV方向过流保护拒动情况,从保护原理、现场接线、定值设置等方面,分析电流互感器的极性选择及方向元件控制字的设置对短路功率方向的影响,提出规范二次接线、合理设置控制字等防止保护拒动和误动的相关措施,确保方向过流保护动作的正确性.     

有机硅原子氧防护涂层的喷涂工艺

以工件表面的涂层分布作为研究对象,对单点喷涂和平面喷涂过程进行微观分析,得出影响空气喷涂过程的工艺变量有喷涂距离、雾化压力、供胶压力、喷枪移动速率和搭接宽度,其中前3个参数决定了喷涂过程的微观基础单元──单点喷涂的质量,而后2个参数决定了涂层的厚度和连续性.试验表明,当喷涂距离为160～180 mm,雾化压力为400～500 kPa,供胶压力为240～400 kPa时,有机硅高聚物溶液的雾化效果较好,具有良好的单点喷涂效果.调整喷枪移动速率为120 mm/s和搭接率为1/2时,获得了厚度一致性较好的合格涂层.分析了喷涂过程中常见缺陷的产生原因,并提出了相应的控制措施,为原子氧防护涂层的喷涂提供参考.     

Effects of Edible Insect Tenebrio molitor Larva Fermentation Extract as a Substitute Protein on Hepatosteatogenesis and Proteomic Changes in Obese Mice Induced by High-Fat Diet

Mealworms (Tenebrio molitor larva) are an edible insect and a protein-rich food; however, research on mealworms as a substitute protein is insufficient. In this study, mealworm fermentation extract (TMP) was assessed as a replacement for soy protein (SP) in a control diet (CON) or a high-fat diet (HFD) of mice for 12 weeks. TMP substitution reduced body weight, body weight gain, body fat mass (perirenal and mesenteric), fat size, glucose intolerance, and insulin resistance compared to the HFD-SP group. TMP alleviated hepatic steatosis (lipid contents and lipid droplets) in high-fat-fed mice and down-regulated the PPARγ, CD36, and DGAT2 gene levels. Proteomic analysis showed that a HFD for 12 weeks up-regulated 20 proteins and down-regulated 17 proteins in mice fed SP. On the other hand, TMP reversed the protein profiles. TMP significantly down-regulated KHK, GLO1, ATP5H, SOD, and DDAH1 and up-regulated DLD, Mup1, CPS1, Ces3b, PDI, and HYOU1 compared to the HFD-SP group. These proteins are involved in the glucose, lipid, and amino acid metabolism, as well as in oxidative stress and endoplasmic reticulum stress. Thus, substituting SP for TMP helped improve HFD-induced obesity, steatosis, and insulin resistance in mice. These results suggest that TMP is a potential substitute for commonly used protein sources.     

Importance of Low-Temperature Melt-Mixing on the Construction of Stereocomplex Crystallites with Superior Nucleation Efficiency in Asymmetric Poly(l-lactide)/Poly(d-lactide) Blends

The nucleation efficiency (NE) of stereocomplex crystallites (SCs) formed in asymmetric poly(L-lactide)/poly(D-lactide) (PLLA/PDLA) blends is generally unsatisfactory because the competition between stereocomplexation and chain mixing involved in the melt-mixing process can cause low formation efficiency and even severe aggregation of SCs. Herein, it is attempted to achieve high-efficient formation of finely dispersed SCs particles by designing a unique melt-mixing procedure, where the mixing of PLLA with 0.75 wt% PDLA is first performed at elevated temperatures (far above the melting temperature of SCs) to allow the homogeneous mixing of PLLA/PDLA chains and then at a low temperature (slightly above that of homocrystallites) to permit the full stereocomplexation of the premixed chains. It is found that the SCs formed in the blends exhibit unexpectedly low NEs (e.g., 54.5%), much inferior to that (73.6%) in the counterpart without undergoing premixing. This is because the introduction of premixing leads to a remarkable deterioration in the amount of SCs particles formed, despite decreased particle size, highlighting that the direct mixing at low temperatures of 170–180 °C (about 20–30 °C lower than that used in common melt-processing of PLA) is more effective for the construction of SCs with superior NE. The mechanisms for these striking findings are discussed.     

含硫氰酸盐、硫化物固体废物中总氰化合物测定方法

实验建立了含硫氰酸盐、硫化物固体废物中总氰化合物的测定方法,采用硝酸银滴定法、异烟酸-吡唑啉酮分光光度法分别测定总氰化合物含量高、低的样品。通过条件实验优化了前处理方式、称样量和干扰去除方法。该方法测定结果的相对标准偏差为0.43%～1.33%,加入标准物质回收率为91.5%～101.5%,精密度和准确度良好,符合测定要求。     

氧化铝超浓相输送系统计量新装置的研究开发

本文介绍了我国首例铝电解大组氧化铝超浓相输送管路上安装电子秤进行氧化铝静态称量连续下料自动计量新方法、新装置及其使用精度的有关基本情况。