Al,Ga取代Bi：DyIG薄膜的磁和磁光特性的研究

本文报道用热分解法在玻璃衬底上制备了Ａｌ和Ｇａ取代的Ｂｉ：ＤＹＩＧ薄膜，对其磁和磁光特性做了详细研究．Ａｌ和Ｇａ取代的薄膜均可获得好的矩形比和高的矫顽力．对于Ｂｉ１．２Ｄｙ１．８Ｆｅ５－ｘＭＸＯ１２（Ｍ＝Ａ１，ＧＺ）薄膜，Ａ１和Ｇ２的最佳替代成份分别为１．０和Ｇ．７；最佳晶化温度分别为７００ｏ℃和６７５℃．在波长５１０ｎｍ附近，法拉第旋转角可达８°／ｕｍ左右．光学吸收和品质因子的研究结果表明，Ａｌ和Ｇａ取代能够影响光学吸收和品质因子，其中Ｇａ取代对光学吸收和品质因子的影响较大．     

高温超导研究的新进展

本文简要回顾了一年来高温超导的新进展，特别介绍和讨论了新型高温超导体系和线材、带材、块材及薄膜应用的发展情况。     

Si_（1－x）Ge_x／Si定向耦合器的研制

在运用ＳｉＧｅ脊形波导单模条件和有效折射率法分析ＳｉＧｅ／Ｓｉ定向耦合器结构参数的基础上，采用分子束外延和各向异性腐蚀技术制备出Ｓｉ１－ｘＧｅｘ／Ｓｉ（ｘ＝０．０５）单模定向耦合器．在波长为１．３μｍ时，平均串音小于－１８．１ｄＢ，输出功率耦合效率达到９８．１％     

红外加热胶接技术

提出了红外加热胶接的思想，并对红外加热胶接技术作了简单阐述。介绍了一种红外加热胶接矿用阻燃、防腐、橡塑风筒布的装置。     

Air bearing design, optimization, stability analysis andverification for sub-25 nm flying

Three sub-25 nm fly height sliders are presented for near contact recording. The designs are geared towards the goal of achieving 10 Gb/in ² areal density. The optimization procedure presented shows promise for facilitating achievement of this goal. The dynamic simulations show the stability of these designs when disturbed from their steady state conditions     

矩形件排样的一种优化算法

排样问题是一种总体资源分配问题，这里根据矩形件排样的工艺要求，提出了矩形件排样的一种近似算法，将一块板材分成三部分，每部分排一种零件，使得减料方便，提高了劳动生产率。     

港口起重机金属结构裂纹的诊断与维修

起重机金属结构常见的故障有裂纹、变形、严重锈蚀、刚度不够等。其中裂纹是门机最为常见的故障，占金属机构故障的80％以上。虽然金属结构的设计都符合常规设计的强度要求，但往往还是不可避免有裂纹产生。这是因为材料内部总难免在夹渣、气孔，加工的过程中可能有毛刺、划伤，焊接过程中存在未焊透等。在变应力的作用下，存在缺陷的部位或者应力最大部位往往最先出现疲劳裂纹，随着应力循环次数的增加，裂纹缓慢扩展直至达到临界尺寸而破坏。     

A Novel Athermal 40-Channel DWDM Multi/Demultiplexer Based on the Combination of AWGs and Interleaver

An athermal 40-channel dense wavelength-division-multiplexing multi/demultiplexer using a novel combination technology is proposed. It consists of one 1times4 100- to 400-GHz spacing interleaver filter and four sub-arrayed-waveguide gratings (AWGs). The temperature-dependent wavelength shift of the combined device is successfully suppressed to 0.058 nm in the -20degC to 70degC temperature range. Moreover, the combined device's adjacent crosstalk (typically -35 dB) is much better than conventional AWGs (typically -25 dB).     

论王光祈的“少年中国”理想

王光祈的“少年中国”理想，是以“少年意大利”为基础，汲取五四时期社会主义思潮的积极成分而形成的。创造“少年中国”在“人”的方面，是从改造中国少年入手，同时注重青年学生与平民的改造，注重劳动阶级、智识阶级与资产阶级的改造与联合；在“事”的方面，积极开展社会事业和社会活动，且必须经过社会分工与国际分工。可见，他的这种理想是典型的社会改革主张，在早期带有无政府主义色彩，自始至终具有强烈的民族主义情感。     

Nutrient removal performance of an anaerobic–anoxic–aerobic process as a function of influent C/P ratio

The laboratory scale anaerobic–anoxic–aerobic (A²O) process fed with synthetic brewage wastewater was designed to investigate the effects of changing feed C/P ratio on the performance of biological nutrient removal (BNR) processes. In the experiment, the influent chemical oxygen demand (COD) concentration was kept at approximately 300 mg L^?1 while the total phosphorus concentration was varied to obtain the desired C/P ratio. Results showed that when the C/P ratio was lower than 32, phosphorus removal efficiency increased as C/P ratio increased linearly, while when the C/P ratio was higher than 32, the P removal efficiency was maintained at 90–98%, and effluent P concentration was lower than 0.5 mg L^?1. However, regardless of the C/P ratio, excellent COD removal (90% or higher) and good total nitrogen removal (75–84%) were maintained throughout the experiments. It was also found that very good linear correlation was obtained between COD uptake per unit P released in the anaerobic zone and C/P ratio. In addition, the P content in the wasted activated sludge increased with the decrease in the C/P ratio. Based on the results, it was recommended that the wastewater C/P ratio and its effects be incorporated into BNR design and operational procedures, appropriate C/P ratios were used to achieve the effluent treatment goals. Copyright © 2005 Society of Chemical Industry