Transcritical CO2 Heat Pump Dryer: Part 2. Validation and Simulation Results

The simulation model of a transcritical CO₂ heat pump dryer presented in Part 1 has been first validated with available experimental data in this part and then used to simulate the heat pump dryer to study the variation of performance parameters such as heating COP, moisture extraction rate, and specific moisture extraction rate. The validation with experimental data shows that the model slightly over predicts the system performance. The possible reasons for the difference between experimental and numerical results are explained. Simulation results show the effect of key operating parameters such as bypass air ratio, re-circulation air ratio, dryer efficiency, ambient condition (temperature and relative humidity), and air mass flow rate. Results show that unlike bypass air ratio and ambient relative humidity, the effect of dryer efficiency, recirculation air ratio, ambient temperature, and air mass flow rate are very significant as far as the system performance is concerned.     

Electrical,rheological and electromagnetic interference shielding properties of thermoplastic polyurethane/carbon nanotube composites

Electrically conducting rubbery composites based on thermoplastic polyurethane (TPU) and carbon nanotubes (CNTs) were prepared through melt blending using a torque rheometer equipped with a mixing chamber. The electrical conductivity, morphology, rheological properties and electromagnetic interference shielding effectiveness (EMI SE) of the TPU/CNT composites were evaluated and also compared with those of carbon black (CB)‐filled TPU composites prepared under the same processing conditions. For both polymer systems, the insulator–conductor transition was very sharp and the electrical percolation threshold at room temperature was at CNT and CB contents of about 1.0 and 1.7 wt%, respectively. The EMI SE over the X‐band frequency range (8–12 GHz) for TPU/CNT and TPU/CB composites was investigated as a function of filler content. EMI SE and electrical conductivity increased with increasing amount of conductive filler, due to the formation of conductive pathways in the TPU matrix. TPU/CNT composites displayed higher electrical conductivity and EMI SE than TPU/CB composites with similar conductive filler content. EMI SE values found for TPU/CNT and TPU/CB composites containing 10 and 15 wt% conductive fillers, respectively, were in the range ?22 to ?20 dB, indicating that these composites are promising candidates for shielding applications. © 2013 Society of Chemical Industry     

Effect of Temperature on C3S and C3S + Nanosilica Hydration and C–S–H Structure

This study aimed to monitor the effect of temperature and the addition of nanosilica on the nanostructure of the C–S–H gel forming during tricalcium silicate (C₃S) hydration. Two types of paste were prepared from a synthesized T₁ C₃S. The first consisted of a blend of deionized water and C₃S at a water/solid ratio of 0.425. In the second, a 90 wt% C₃S + 10 wt% of nanosilica blend was mixed with water at a water/solid ratio of 0.7. The pastes were stored in closed containers at 100% RH and 25°C, 40°C, or 65°C. The hydration reaction was detained after 1, 14, 28, or 62 d with acetone, and then pastes were studied by ²⁹Si magic angle spinning nuclear magnetic resonance (²⁹Si MAS NMR).The main conclusion was that adding nSA expedites C₃S hydration at any age or temperature and modifies the structure of the C–S–H gel formed, two types of C–S–H gel appear. At 25°C and 40°C, more orderly, longer chain gels are initially (1 d) obtained as a result of the pozzolanic reaction between nSA and portlandite (CH) (C–S–H_II gel formation). Subsequently, ongoing C₃S hydration and the concomitant flow of dimers shorten the mean chain length in the gel.     

Effects of Tm3+ Additions on the Crystallization of LaF3 Nanocrystals in Oxyfluoride Glasses: Optical Characterization and Up‐Conversion

The influence of the addition of 1 mol% Tm₂O₃ on the nanocrystallization of LaF₃ in a glass of composition 55SiO₂–20Al₂O₃–15Na₂O–10LaF₃ (mol%) has been studied. Tm₂O₃ affects the phase separation in the glass and delays the onset of crystallization with respect to the undoped glass. Additionally, the maximum LaF₃ crystal size is slightly greater than that in the undoped glass–ceramics. The microstructural and compositional changes in the glass matrix have been studied using several techniques, including viscosity, dilatometry, X‐ray and neutron diffraction (XRD, ND), quantitative Rietveld refinement, transmission electron microscopy (TEM), differential scanning calorimetry (DSC), and Raman spectroscopy. Photoluminescence measurements indicate that the Tm³⁺ ions are distributed between the glassy matrix and LaF₃ crystals. Eu₂O₃ has been used as structure probe and part of the Eu³⁺ ions are reduced to Eu²⁺ when incorporated in the LaF₃ nano‐crystals. Up‐conversion spectra under IR‐excitation show a higher intensity of the blue emission in the Tm‐doped glass–ceramic compared with that in the glass.     

Evolution of Mineralogical Phases by 27Al and 29Si NMR in MK‐Ca(OH)2 System Cured at 60°C

The evolution of the metastable phases in metakaolin/Ca(OH)₂ systems cured at high temperatures, remains mostly unknown, newer techniques may now help to establish both the kinetic mechanism of the pozzolanic reaction and the thermodynamic stability of the main hydrated hexagonal phases: Stratlingite (C₂ASH₈) and tetra calcium aluminate hydrate (C₄AH₁₃). For this reason this work examines the kinetics of the pozzolanic reaction in the MK/Ca(OH)₂ system over 123 d at 60°C using nuclear magnetic resonance spectroscopy (²⁷Al and ²⁹Si NMR). The results obtained by ²⁷Al and ²⁹Si NMR show that during the first 30 h, the metastable phases C₂ASH₈ and C₄AH₁₃, coexist with the cubic phase (C₃ASH₆) obtained directly from the pozzolanic reaction. The gel C–S–H is clearly identified after 21 h of reaction, whereas at shorter times the C–S–H bands overlap those with the unreacted metakaolin ones. After 123 d of pozzolanic reaction, the first signs of the cubic phase are detected, a consequence of the conversion reaction of the metastable phases, and a phenomenon not previously identified.     

Influence of the chestnuts drying temperature on the rheological properties of their doughs

Chestnut flour doughs were prepared using chestnut air-dried at 45, 65, and 85 °C with constant load density (8.0 ± 0.6 kg/m²). Mixing curves of doughs using Mixolab^® device showed that chestnut flour doughs dried at 85 °C needed more water absorption to reach the target consistency, (1.1 ± 0.07 Nm). Thermorheological properties were evaluated by means of a controlled stress rheometer. All tested doughs showed shear-thinning behaviour in the steady-shear tests (0.001–1 s^?1). Oscillatory (1–100 rad s^?1 at 0.1% strain), temperature sweep (30–90 °C) and creep-recovery (loading 50 Pa for 60 s) tests showed that flour doughs from chestnuts dried at 85 °C provide interesting properties, particularly remarkable elasticity that is associated with starch gelatinisation. Experimental data were described using various rheological models.     

Electrochemical oxidation of methyl orange azo dye at pilot flow plant using BDD technology

Solutions of methyl orange azo dye were degraded by electrochemical oxidation using a 3 L flow plant with a boron-doped diamond (BDD)/stainless steel cell operating at constant current density, ambient temperature and liquid flow rate of 12 L min^?1. A 2³ factorial design considering the applied current density, azo dye concentration and electrolysis time as variable independents was used to analyze the process by response surface methodology. LC–MS analysis revealed the formation of seven oxidation products from the cleavage of the NN group of the dye, followed by deamination, formation of a nitro group and/or desulfonation of the resulting aromatics.     

Production of Methyl Oleate in Reactive‐Separation Systems

The esterification of oleic acid and methanol using sulfuric acid as a homogeneous catalyst is studied in reactive‐separation systems. The conversion of the free fatty acid was investigated in two different experiments with the molar ratio of methanol/oleic acid, amount of catalyst, temperature, and reaction time as variables. The conversion of the free fatty acid was found to depend strongly on the molar ratio of methanol/oleic acid. The reaction time had a direct effect on the conversion of the free fatty acid, and this conversion decreased with higher temperature. These results were valuable for a preliminary study on biodiesel production, using an acid homogeneous catalyst in a reactive dividing‐wall distillation column.     

gef Gene Expression in MCF-7 Breast Cancer Cells is Associated with a Better Prognosis and Induction of Apoptosis by p53-Mediated Signaling Pathway

Breast cancer research has developed rapidly in the past few decades, leading to longer survival times for patients and opening up the possibility of developing curative treatments for advanced breast cancer. Our increasing knowledge of the biological pathways associated with the progression and development of breast cancer, alongside the failure of conventional treatments, has prompted us to explore gene therapy as an alternative therapeutic strategy. We previously reported that gef gene from E. coli has shown considerable cytotoxic effects in breast cancer cells. However, its action mechanism has not been elucidated. Indirect immunofluorescence technique using flow cytometry and immunocytochemical analysis were used to detect breast cancer markers: estrogen (ER) and progesterone (PR) hormonal receptors, human epidermal growth factor receptor-2 proto-oncogene (c-erbB-2), ki-67 antigen and p53 protein. gef gene induces an increase in ER and PR expressions and a decrease in ki-67 and c-erbB-2 gene expressions, indicating a better prognosis and response to treatment and a longer disease-free interval and survival. It also increased p53 expression, suggesting that gef-induced apoptosis is regulated by a p53-mediated signaling pathway. These findings support the hypothesis that the gef gene offers a new approach to gene therapy in breast cancer.