Modeling of solid—liquid adsorption: Effects of adsorbent loads on model parameters

The adsorption of cobalt phthalocyanine dye onto activated carbon in a continuous stirred tank adsorber was studied. The variables investigated were: adsorbent mass, adsorbent particle size and fluid flowrate. Several models based on film, pore and surface diffusion were constructed and fitted to the experimental data. Experimental results showed: (i) the increasing importance of the film mass transfer resistance for increasing adsorbent loads; (ii) the increasing importance of the surface diffusion mechanism for increasing adsorbent loads; and (iii) the better discrimination among different models for higher adsorbent loads and lower flowrate.     

Nutrient balance of shifting cultivation by burning or mulching in the Eastern Amazon – evidence for subsoil nutrient accumulation

For over a hundred years shifting cultivation with slash-and-burn land preparation has been the predominant type of land use by smallholders in the Bragantina region of the Brazilian Eastern Amazon. This study contrasts the nutrient balance of slash-and-burn agriculture with a fire-free cultivation. Therefore, one half of a 3.5-year-old (28.7 t DM ha^–1) and a 7-year-old woody fallow vegetation (46.5 t DM ha^–1) was burnt and the other half mulched, leaving the biomass as a surface residue. Subsequently, a sequence of maize, beans and cassava was cropped for 1.5 year. Burning the 3.5- and 7-year-old fallow removed 97 and 94% of the C, 98 and 96% of the N, 90 and 63% of the P-stocks, and between 45 and 70% of the cations K, Mg and Ca of the aboveground biomass by volatilization or ash-particle transfer. These losses were avoided with the slash-and-mulch land preparation. Mulching did not increase the losses of nutrients by leaching, despite the high amount of rapidly decomposing surface mulch. Also the length of preceding fallow had no significant influence on leaching losses. At a depth of 3 m, leached nutrients were quantitatively negligible in both treatments. Comparing the nutrient fluxes at soil depths of 0.9 m, 1.8 m and 3 m, the amounts of all mobile nutrients, and also of chloride and sodium were markedly reduced during percolation and must have been retained. It is likely that nutrient retention in the subsoil layer is only temporary, emphasizing the need for a rapid re-establishment of the naturally deep-rooting secondary vegetation after abandonment of sites to enable uptake of these nutrients. The overall nutrient balance was highly negative for slash-and-burn. 291 and 403 kg N ha^–1, 21 and 18 kg P ha^–1, and 70 and 132 kg K ha^–1 were removed from the burnt plots with a preceding fallow of 3.5 and 7 years, respectively. A reduced fallow period (3.5 years), which is a common trend in the region, resulted in a higher mean annual rate of nutrient loss averaged over the duration of the cycle than a fallow period of 7 years. Eliminating the burning losses by mulching brought the agricultural system back to an equilibrated or even slightly positive nutrient balance, even after a reduced fallow period. Thus, slash-and-mulch is a viable alternative to maintain agricultural productivity and ecosystem functioning.     

Hydrophobic polymers for liquid cleaning formulations

A patented method to provide acrylic acid:styrene (AA:Sty) copolymers with a variety of AA:Sty mole ratios is described. This method allows the polymer to be provided as a solution in water with up to 50 mol% styrene. The addition of significant amounts of styrene provides increased polymer solubility in liquid laundry detergents without sacrificing the traditional benefits of typical polycarboxylates. Studies were run in a Tergotometer and full-scale U.S. washing machine, showing particulate soil antiredeposition performance equivalent to poly(acrylic acid) with a molecular weight of 4500 and improved oily soil antiredeposition. The dry polymer is soluble in several glycols, a behavior not typically seen with polycarboxylates.     

Use of Repetitive Sequences for Molecular and Cytogenetic Characterization of Avena Species from Portugal

Genomic diversity of Portuguese accessions of Avena species—diploid A. strigosa and hexaploids A. sativa and A. sterilis—was evaluated through molecular and cytological analysis of 45S rDNA, and other repetitive sequences previously studied in cereal species—rye subtelomeric sequence (pSc200) and cereal centromeric sequence (CCS1). Additionally, retrotransposons and microsatellites targeting methodologies—IRAP (inter-retrotransposon amplified polymorphism) and REMAP (retrotransposon-microsatellite amplified polymorphism)—were performed. A very high homology was detected for ribosomal internal transcribed sequences (ITS1 and ITS2) between the species analyzed, although nucleolar organizing regions (NOR) fluorescent in situ hybridization (FISH) analysis revealed distinct number of Nor loci between diploid and hexaploid species. Moreover, morphological diversity, evidenced by FISH signals with different sizes, was observed between distinct accessions within each species. pSc200 sequences were for the first time isolated from Avena species but proven to be highly similar in all genotypes analyzed. The use of primers designed for CCS1 unraveled a sequence homologous to the Ty3/gypsy retrotransposon Cereba, that was mapped to centromeric regions of diploid and hexaploid species, being however restricted to the more related A and D haplomes. Retrotransposon-based methodologies disclosed species- and accessions-specific bands essential for the accurate discrimination of all genotypes studied. Centromeric, IRAP and REMAP profiles therefore allowed accurate assessment of inter and intraspecific variability, demonstrating the potential of these molecular markers on future oat breeding programs.     

Low temperature thermal degradation of cellulosic insulating paper in air and transformer oil

The thermal degradation of cellulose in the form of Kraft insulating paper has been studied in air for up to 140 h and in transformer oil for up to 3500 h in the temperature range 60–120 °C using measurements of the degree of polymerization (DP) and (in oil) analysis of furanic degradation products. Degradation was faster in air than in oil. The DP decreased from the original value of 1.2 × 10³ to a limiting value in the range of 300–900 depending on temperature and degradation conditions. The variation of the DP with degradation time was consistent with two mechanisms, one in which the first‐order rate constant decreased exponentially with time, and another in which only a limited number of chain bonds were scissionable. The degradation rate was first order in scissionable bonds. The major furanic degradation products were 2‐furaldehyde, 5‐hydroxymethyl‐2‐furaldehyde and furfuryl alcohol. Their concentrations continually increased over the timescale of the experiments. © 2001 Society of Chemical Industry     

FAME Production and Fatty Acid Profiles from Moist Chlorella sp. and Nannochloropsis oculata Biomass

In the present study, we investigated the production of fatty acid methyl esters (FAME) from moist Chlorella sp. and Nannochloropsis oculata biomass using a hydrolysis–esterification process. Additionally, we evaluated for the first time the fatty acid profile before and after this process. Hydrolysis of the lipid fraction was performed on a moist biomass in the presence of differing amounts of an acid catalyst in both 50 and 100 % w/w water relative to the biomass. The esterification of the crude extracts of the free fatty acids (FFA) was then investigated. The experiments show that in the presence of 50 % w/w water relative to the biomass, the hydrolysis–esterification process results in higher FFA and FAME yields. The analysis of the fatty ester profiles did not reveal any degradation of the FFA from the microalgae biomass under the hydrolysis–esterification conditions. The results were compared with both extraction–transesterification and direct transesterification processes using dry biomass. The extraction–transesterification and hydrolysis–esterification processes resulted in similar FAME yields and similar profiles of the fatty esters from dry and moist biomass materials, respectively.     

New Hybrid Nanomaterial Based on Self-Assembly of Cyclodextrins and Cobalt Prussian Blue Analogue Nanocubes

Supramolecular self-assembly has been demonstrated to be a useful approach to developing new functional nanomaterials. In this work, we used a cobalt Prussian blue analogue (PBA, Co₃[Co(CN)₆]₂) compound and a β-cyclodextrin (CD) macrocycle to develop a novel host-guest PBA-CD nanomaterial. The preparation of the functional magnetic material involved the self-assembly of CD molecules onto a PBA surface by a co-precipitation method. According to transmission electronic microscopy results, PBA-CD exhibited a polydisperse structure composed of 3D nanocubes with a mean edge length of 85 nm, which became shorter after CD incorporation. The supramolecular arrangement and structural, crystalline and thermal properties of the hybrid material were studied in detail by vibrational and electronic spectroscopies and X-ray diffraction. The cyclic voltammogram of the hybrid material in a 0.1 mol·L⁻¹ NaCl supporting electrolyte exhibited a quasi-reversible redox process, attributed to Co²⁺/Co³⁺ conversion, with an E_1/2 value of 0.46 V (vs. SCE), with higher reversibility observed for the system in the presence of CD. The standard rate constants for PBA and PBA-CD were determined to be 0.07 and 0.13 s⁻¹, respectively, which suggests that the interaction between the nanocubes and CD at the supramolecular level improves electron transfer. We expect that the properties observed for the hybrid material make it a potential candidate for (bio)sensing designs with a desirable capability for drug delivery.     

Modeling and simulation of an industrial‐scale parex process

The Parex unit for industrial‐scale purification of p‐xylene was studied through detailed simulation and the accuracy of the developed model tested against real industrial data. Starting from a comprehensive analysis of the construction and operation of the industrial unit, a simulation model was developed that incorporates the existing three major types of dead volumes: bed lines, which connect the beds to the rotary valve, circulation lines, which connect adjacent adsorbent chambers, and bed‐head dead volumes, which are located upstream of each bed due to the existence of internals. By gathering operation data and surveys in the pumparound line and in the extract stream, three case studies were defined and compared with simulation results. The model is capable of predicting the performance of the industrial unit. Further simulations were made and compared with plant data to assess the effect of adsorbent capacity loss on the long‐term performance of the unit. © 2015 American Institute of Chemical Engineers AIChE J, 61: 1345–1363, 2015     

Adventitial Tertiary Lymphoid Organs as Potential Source of MicroRNA Biomarkers for Abdominal Aortic Aneurysm

Abdominal aortic aneurysm (AAA) is an inflammatory disease associated with marked changes in the cellular composition of the aortic wall. This study aims to identify microRNA (miRNA) expression in aneurysmal inflammatory cells isolated by laser microdissection from human tissue samples. The distribution of inflammatory cells (neutrophils, B and T lymphocytes, mast cells) was evaluated in human AAA biopsies. We observed in half of the samples that adventitial tertiary lymphoid organs (ATLOs) with a thickness from 0.5 to 2 mm were located exclusively in the adventitia. Out of the 850 miRNA that were screened by microarray in isolated ATLOs (n = 2), 164 miRNAs were detected in ATLOs. The three miRNAs (miR-15a-3p, miR-30a-5p and miR-489-3p) with the highest expression levels were chosen and their expression quantified by RT-PCR in isolated ATLOs (n = 4), M1 (n = 2) and M2 macrophages (n = 2) and entire aneurysmal biopsies (n = 3). Except for the miR-30a-5p, a similar modulation was found in ATLOs and the two subtypes of macrophages. The modulated miRNAs were then evaluated in the plasma of AAA patients for their potential as AAA biomarkers. Our data emphasize the potential of miR-15a-3p and miR-30a-5p as biomarkers of AAA but also as triggers of ATLO evolution. Further investigations will be required to evaluate their targets in order to better understand AAA pathophysiology.