Spectral characterisation and frame synchronisation of optical fibre digital PPM

The discrete time decoding of data in pulse position modulation calls for accurate timing synchronisation, particularly at the frame rate. The spectral properties of optical fibre digital PPM are considered. An original expression is presented for predicting the spectrum and it is shown that, unlike satellite PPM, a component exists at the frame rate which may be used for timing extraction purposes. Further, it is illustrated that the modulation index can be used to enhance this component by up to 19 dB. This has been verified practically, with the results agreeing to within 1 dB of those predicted from the original expression presented.<>     

Fourier-transform-limited pulses from gain-switched distributed-Bragg-reflector lasers using simultaneous modulation of gain and phase sections

Fourier-transform-limited pulses ( Delta tau . Delta nu approximately=0.35) have been obtained from a microwave-modulated DBR laser at 1.56 mu m. The chirp of the gain-switched pulse is compensated for by applying a fraction of the microwave signal to the phase section, thereby creating an instantaneous frequency shift of opposite sign. The generation of short coherent pulses from such a monolithic source can be of great interest for long haul soliton transmission.<>     

Analysis of slots in nonradiating dielectric waveguide using the modal expansion method

A modal expansion method is used with the reciprocity and Poynting theorems to derive the admittance of inclined slots cut in the metal wall of a nonradiating dielectric (NRD) waveguide. Theoretical values of normalised conductance and susceptance are compared with previously reported experimental results and are found to be in good agreement.<>     

A hybrid wafer-dicing process for GaAs MMIC production

A dicing process for GaAs MMIC (monolithic microwave integrated circuit) wafers using spin-on wax for wafer mounting and a hybrid process of wet chemical etching/mechanical sawing for chip dicing is described. This process minimizes ragged chip edges and reduces generation of microcracks in addition to the elimination of the plated gold burrs on the backside of the diced MMIC chips. This process gives a uniformity of -3 μm across a 2-in wafer following the completion of the whole backside process. This GaAs chip dicing technique is amenable to production because it exhibits both a very high chip yield (>90%) and nearly flawless edges     

Adaptive nonlinear cancellation for high-speed fiber-optic systems

The authors propose techniques for adaptive nonlinear cancellation of intersymbol interference (ISI) in the electrical signal at the receiver in Gb/s lightwave systems and describe several demonstrations of these techniques. Techniques for adjustable nonlinear cancellations are discussed and demonstrations of these techniques using commercially available integrated circuits (ICs) at data rates as high as 1.7 Gb/s are described. Techniques for automatic adjustment are discussed, and a demonstration of adaptive nonlinear cancellation at 450 Mb/s is described. The authors discuss how these techniques can be integrated onto the detector IC for operations at 2.5 Gb/s and higher data rates. These techniques allow a single IC detector with adaptive nonlinear cancellation to be used in long-haul and undersea lightwave systems to optimize the detector threshold and compensate for the ISI     

Performance of 1700 m2 solar pond operation in arid zone

A 1700 m² solar pond was constructed in the desert of Kuwait where severe weather conditions prevail in all seasons. The paper describes in detail a diffuser design for the gradient establishment, gradient stability, and thermal performance of the pond. The main problem encountered in operating the pond was mixing between the upper zone and the gradient zone, even when the wind speed was as low as 5 m/s. No mixing between the gradient and the lower connective zone was observed. The wind effect was severe in causing mixing even when the upper convective zone increased to 0.90 m.     

Expert system “assistent” for bayes' intellectual measurements of probability characteristics

Translated from Izmeritel'naya Tekhnika, No. 8, pp. 11–14, August, 1992.     

Optical properties of Bi2Te2Se thin films

Some optical parameters of Bi₂Te₂Se thin films, determined from the measured absorbance and transmittance at normal incidence in the visible spectral range, were studied as functions of film thickness and annealing temperature. These parameters were found to be sensitive to both film thickness and microstructure change caused by annealing in a film. The effect of thickness and temperature of annealing on the optical gap was interpreted in terms of elimination of defects and change of disordering in the amorphous matrix.     

New possibilities of chemical beneficiation of synnirites

Institute of Geology Siberian Branch, Academy of Sciences of the USSR, Novosibirsk. Translated from Fiziko-Tekhnicheskie Problemy Razrabotki Poleznykh Iskopaemykh, No. 1, pp. 106–109, January-February, 1992.     

Equalization of a hard-limited slowly-fading multipath signal usinga phase equalizer with time-reversal structure

Describes a low-complexity equalization technique for improving the reliability of portable radio links in the presence of multipath time delay spread. A technique that operates on hard-limited received signals, with only the phase information available, is presented. Suboptimum receivers based on a maximum likelihood estimation criterion are discussed, including a sequence estimator and a decision feedback phase detector. A low-complexity adaptive phase equalizer structure using decision-directed phase tracking is proposed. The equalizer does not require the multiplication operations required in most conventional equalization algorithms. The author also proposes a receiver that includes a time-reversal structure and a joint estimator for optimum timing recovery and equalizer training. The time-reversal structure plays a crucial role in maximizing the compensation capability of the phase equalizer. The combined use of phase equalization and diversity reception is also considered