薄板坯连铸连轧流程Ti微合金化高强钢开发与应用

在薄板坯连铸连轧流程上，经过对Ti微合金化技术研究，有效解决了Ti微合金化强度性能波动大的问题，开发出屈服强度450～700MPa高强钢。对试制钢组织性能和工业应用分析研究，表明该产品通板性能良好，通板强度差30MPa左右；成形性能良好，d=0时冷弯测试全部合格；同时还具有良好焊接性能，焊接后，强度波动较小，均在母材部位断开；试制钢显微组织为珠光体和铁素体，晶粒均匀细小，平均尺寸为4～8／μm；实物质量满足集装箱和汽车制造行业要求，具有广阔市场前景。     

Frequency shift keyed narrowband interference rejection: optimal exponential weighting factor for the RLS algorithm

Cochannel narrowband interference can limit the performance of direct sequence spread spectrum (DSSS) and high frequency (HF) systems. Narrowband interference (NBI) can be single tone, chirped or frequency shift keyed (FSK) in nature and numerous techniques for its removal have been proposed. Linear adaptive prediction filters based on autoregressive modelling have been suggested owing to their ability to perform in a non-stationary environment. In the FSK narrowband interference case, adaptive filters are susceptible to excess residual errors owing to instantaneous frequency step changes and the finite convergence time required for the filter to adapt to a new interference frequency. The signal degradation owing to this type of interference becomes greater in high SNR regimes and has been found to be a function of the frequency parameters of the FSK interference signal. The paper discusses the convergence and frequency tracking properties of the recursive least squares (RLS) adaptive lattice filter using a posteriori estimation errors in the presence of FSK narrowband interference. An optimal exponential weighting factor that balances convergence time and steady state error is derived for this case of NBI. Results are compared to those of a previously proposed fast converging minimum frequency error (FCMFE) RLS lattice filter.     

一种新的基于PARC技术的MIMO系统

MIMO (Multiple-Input Multiple-Output)的显著优点就是在不增加带宽的情况下,能够成倍地提高通信系统容量和频谱利用率,是未来移动通信与个人通信系统实现高速率数据传输,提高高传输质量的重要途径,也是未来移动通信系统广泛采用的关键技术.文中简要介绍了MIMO系统及其一种新的MIMO系统中的应用技术,即PARC(Per-antenna Rate Control)技术.     

Effect of Wall Surface Properties at Different Drying Kinetics on the Deposition Problem in Spray Drying

Current methods in alleviating the wall deposition problem in spray drying emphasize mainly controlling the stickiness of the drying particles and less attention is placed on the properties of the dryer wall. In this experimental study, the effect of wall surface properties on the deposition mechanism has been investigated. Properties considered in classifying different wall materials were surface energy, roughness, and dielectric properties. The model solution contained sucrose, representing low-molecular-weight sugars commonly encountered in spray drying of fruit and vegetable juices. The effect of wall properties on deposition was explored at different drying rates producing particles of different surface rigidity. Larger surface roughness produced higher deposition fluxes for particles with high impact velocity and moisture. Surface energy and surface roughness were found to have no significant effect for dry rigid particles at the middle and bottom elevation of the drying chamber. However, material with lower surface energy (Teflon) exhibited less deposition for rubbery particles at such elevations. Analysis shows that dielectric wall material (Teflon) tends to enhance deposition of dry particles because of attrition at the surface. Higher wall temperature was found to produce slightly more deposition. The results of this work give a general indication of the effect of wall material on the deposition problem and provide the fundamental understanding for further studies along this line. Proper selection of dryer wall material will provide potential alternatives for reducing the deposition problem.     

桐梓河园满贯水电站工程泄洪消能设计

针对桐梓河园满贯水电站工程洪峰流量大、河床狭窄的不利条件,采用坝顶表孔泄洪,溢洪道尾部设置为不对称宽尾墩 连续挑坎型式,使水舌横向扩散、纵向拉开、空间碰撞,减轻对下游河床的冲刷。     

基于遗传算法的土钉支护结构优化设计研究

通过建立三维有限元模型,对土钉支护的变形和受力性能进行分析,得出土钉力的合理分布。在此基础上,考虑土钉支护的水平位移,采用遗传算法,对土钉支护的结构优化设计进行研究,建立了土钉支护结构的优化设计数学模型,并编制了相应的计算程序。通过算例分析,并与基于极限平衡分析的优化结果相比较,得出合理的土钉支护结构设计的参考结论。     

One-to-Many and Many-to-One Optical Chaos Communications Using Semiconductor Lasers

A theoretical construction of one-to-many (OTM) and many-to-one (MTO) chaos synchronization communications using semiconductor lasers is presented. One center laser provides strong injections (strong link) to other side lasers, and the side lasers also provide weak injections (weak link) to the center one. Simulation results show that the side lasers synchronize with the center laser through injection-locking. In addition, messages transmitted via the strong links or the weak links experience strong chaos pass filtering, enabling us to realize OTM and MTO communications.     

维拉诺瓦巴奎因城市公园

维拉诺瓦巴奎因城市公园坐落在里斯本市区，倚靠葡萄牙最长的河流——塔古斯河的右岸。在塔古斯河谷的大型综合项目中，包含了对这片10hm^2土地的改造，以重新评估它的城市和景观价值。