Dissolution of phase-separated domains after a jump to a temperature in the single-phase region

Phase-separated domains prepared in the two-phase region were dissolved at a temperature in the single-phase region, and their dissolution dynamics was studied by using the time-resolved light scattering (TRLS) technique and a scanning electron microscope (SEM). The time t_ps of preparation of domains was chosen to be long enough for phase separation to proceed into the late stage. The scattered light intensity at small wavenumbers increased before it attenuated. As t_ps increased, the increase at smaller wavenumbers became more significant and the peak intensity decreased only slightly with dissolution time. The characteristic wavenumber q_m evaluated from TRLS and SEM followed the power-law relation q_mt^−0.3.     

Sensorless control of synchronous reluctance motors using on‐line parameter identification method not affected by position estimation accuracy

This paper presents a novel on‐line parameter identification method for sensorless control of Synchronous Reluctance Motors (SynRMs). Although conventional sensorless control methods based on mathematical models usually need some complex measurements of motor parameters in advance, the proposed identification method does not require them and can be realized on‐line. The proposed method identifies motor parameters under sensorless control, so rotor position and velocity cannot be used to identify these parameters. However, the proposed method does not need rotor position and velocity, and identified parameters are not affected by these estimation errors. The sensorless control using identified motor parameters is realized, and the effectiveness of the proposed method is verified by experimental results. © 2006 Wiley Periodicals, Inc. Electr Eng Jpn, 155(3): 62–69, 2006; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.20258     

Furnace grown gate oxynitride using nitric oxide (NO)

Gate oxynitride was grown in NO for the first time. This approach can provide a tight N accumulation near the Si/SiO₂ interface. Much lower thermal budget is required for an NO process than for an N₂O process to produce an oxynitride with useful properties. Submicron MOSFET's with NO oxynitride showed superior current drive characteristics and comparable hot carrier immunity to those with N₂O oxynitride     

Improvements of the T-Ω method for 3-D eddy currentanalysis

An improved T-Ω method that can analyze magnetic fields produced not only by eddy currents but also by magnetizing currents is proposed. The method is applied to the analysis of 3-D eddy-current models with holes. The usefulness of the method is investigated by comparing calculated results with measured results and with results obtained by the A-Φ method. The T-Ω method has the advantage that the CPU time can be considerably reduced when most of the analyzed region is current-free and the eddy current flows two-dimensionally. The method is especially effective when the shape of the winding is simple and the distribution of magnetizing current is known beforehand. It is not effective when most of the analyzed region is current-carrying     

Optical bistability and set-reset operation of a Fabry-Perotsemiconductor laser amplifier with two detuned light injections

Optical bistability in a Fabry-Perot semiconductor laser amplifier when two optical inputs detuned from the resonant wavelength of a semiconductor laser amplifier are injected is discussed. A split branch is found in the optical output versus input characteristics in addition to conventional optical bistability behavior. It is shown analytically and experimentally that set and reset can be achieved in the optical output of the semiconductor laser amplifier for each wavelength by applying two detuned optical pulses and using the split branch     

A 64-Mb DRAM with meshed power line

A 64-Mb dynamic RAM (DRAM) has been developed with a meshed power line (MPL) and a quasi-distributed sense-amplifier driver (qDSAD) scheme. It realizes high speed, t_RAS=50 ns (typical) at V_cc=3.3 V, and 16-b input/output (I/O). This MPL+qDSAD scheme can reduce sensing delay caused by the metal layer resistance. Furthermore, to suppress crosstalk noise, a V_SS shield peripheral layout scheme has been introduced, which also widens power line widths. This 64-Mb DRAM was fabricated with 0.4-μm CMOS technology using KrF excimer laser lithography. A newly developed memory cell structure, the tunnel-shaped stacked-capacitor cell (TSSC), was adapted to this 64-Mb DRAM     

A 10 bit 20 MS/s 3 V supply CMOS A/D converter

A 10 bit CMOS A/D converter with 3 V power supply has been developed for being integrated into system VLSI's. In this A/D converter, redundant binary encoders named “twin encoders” enhance tolerance to substrate noise, together with employing differential amplifiers in comparators. The bias circuit using a replica of the amplifier is developed for biasing differential comparators with 3 V power supply. Subranging architecture along with a multilevel tree decoding structure improves dynamic performance of the ADC at 3 V power supply. The A/D converter is fabricated in double-polysilicon, double-metal, 0.8 μm CMOS technology. The experimental results show that the ADC operates at 20 MS/s and the twin encoders suppress the influence of substrate noise effectively. This ADC has a single power supply of 3 V, and dissipates 135 mW at 20 MS/s operation     

Disaccharide analysis of human skin glycosaminoglycans in sun-exposed and sun-protected skin of aged people

The negative conduction effect of quinidine on each of the successive phases of the ventricular depolarization was investigated using an original noninvasive method: the spatial velocity electrocardiogram of the QRS complex (SVECG-QRS). We performed a randomized placebo-controlled trial in 10 healthy subjects with a single oral dose of quinidine (330 mg) or placebo. Electrocardiographic acquisition and processing (220 recordings for the complete trial) were performed using the Lyon vectorcardiographic program. For each SVECG-QRS curve, the position of seven specific points from A (onset of QRS) to G (end of QRS) were determined precisely. The six successive time intervals between these points (AB-FG) and five velocity values (B-F) were then calculated. The QRS complex was longer under quinidine than placebo (102.4 +/- 1.6 vs. 100.3 +/- 1.5 ms). The difference was at the periphery of statistical significance (p = 0.05), and this lack of statistical difference may be mainly due to the low serum levels of quinidine obtained at the peak of the concentration (1.46 +/- 0.4 mg/1). All six QRS time intervals were longer under quinidine, but only the BC interval was significantly different (9.3 +/- 1.1 vs. 18.8 +/- 1.1 ms; p < 0.05) suggesting a more pronounced negative conduction effect at the onset of ventricular depolarization. No significant modifications were observed for the velocity values. We conclude that (1) the negative conduction effect of quinidine is heterogeneous, but a further study with a higher dose of quinidine (concentration-dependent effect) is required to confirm this hypothesis and (2) the spatial velocity electrocardiogram of the QRS complex allows a detailed analysis of the ventricular conduction phases. The results of the measurement were found to be reproducible. This noninvasive tool could be used in clinical practice to assess effects of antiarrhythmic drugs on successive ventricular depolarization phases.     

Combining natural language with direct manipulation: the conceptual framework for a hybrid human-computer interface

This paper describes the development of a conceptual model of an interaction system for future human-computer interaction. It is suggested that an integrated system is the most promising solution for diverse users and tasks. A ' hybrid interaction system' is considered, which tries to efficiently direct manipulation, menu selection, and natural language. The mechanism of the natural language interface module is described in more detail. Finally, the allocation of functionalities for generalized tasks on the conceptual model is considered from the taxonomic approach.