Natural fiber composites of high‐temperature thermoplastic polymers: Effects of coupling agents

Our earlier paper (Jana, S.C.; Prieto, A. J Appl Polym Sci 2002, 86, 2159) on the development of natural fiber composites of high‐performance thermoplastic polymers described a new methodology for the manufacturing of composite materials of a high‐temperature thermoplastic polymer, poly(phenylene ether) (PPE) and wood flour, a cellulosic natural filler. A thermosetting epoxy, used as a reactive solvent, reduced the processing temperature of PPE/epoxy blends to well below the decomposition temperature of natural fillers. In addition, the epoxy component, upon polymerization, formed coating layers around the filler particles to provide resistance against moisture diffusion and attacks by acids and alkali. This article describes the results of an investigation on two outstanding issues: (1) the influence of cellulosic wood particles and coupling agents on the speed of epoxy curing and reaction‐induced phase separation and (2) the effects of coupling agents on the morphology of crosslinked epoxy at the surfaces of natural fillers and mechanical properties of the composites. It was found that wood particles expedited epoxy curing in the composites; the extent of epoxy curing, however, was reduced in the presence of coupling agents. Also, the coupling agents promoted complete coverage of wood flour particles by polymerized epoxy, although the mechanical properties deteriorated over systems without coupling agents. © 2002 Wiley Periodicals, Inc. J Appl Polym Sci 86: 2168–2173, 2002     

Effect of low‐temperature plasma and chitosan treatment on wool dyeing with Acid Red 27

This study examines in detail the influence of low‐temperature plasma and biopolymer chitosan treatments on wool dyeability. Wool knitted fabrics were treated and characterized by whiteness and shrink‐resistance measurements. Surface modification was assessed by contact‐angle measurements of human hair fibers, which were used as a model to study the wetting properties of the treated wool knitted fabrics. The dyeing behavior was assessed from the diffusion mechanism point of view. The dyeing kinetics were measured at two different pHs (4.2 and 6.5) and three different temperatures (60, 85, and 100°C) to gain information about the contribution of the surface modification treatment to the dyeing mechanism. The exhaustion and reflectance data were compared, and the apparent diffusion coefficients were calculated. On the basis of the obtained results, a model for the dyeing mechanism of the chitosan treated wool was proposed. When treated with chitosan, the polymer sheath spread on the surface of the fibers acted as a predominant dyeing site in very short dyeing times, thus interacting with the dye and in later stages imparting the dye to the wool fiber. © 2005 Wiley Periodicals, Inc. J Appl Polym Sci 97: 2204–2214, 2005     

Mechanical improvement of concrete by irradiated polypropylene fibers

Fiber reinforced concrete (FRC) contains fibers physically mixed with gravel, sand, cement, and water. So far, adequate mechanical performance of FRC has been obtained at high cost and using complex technologies; important here is the geometry and surface characteristics of the polymers. We have modified polymeric‐fiber surfaces by using gamma radiation. Irradiated polypropylene (PP) fibers were submitted to 0, 5, 10, 50, and 100 kGy of gamma irradiation dosages. First, tensile strength of PP fibers was evaluated, and then fibers blended at 0, 1.0, 1.5, and 2.0% in volume with Portland cement, gravel, sand, and water. The highest values of compressive strength were obtained with irradiated‐fibers at 10 kGy and 1.5% in volume of fiber. The result is 101 MPa, as compared to 35 MPa for simple concrete without fibers. POLYM. ENG. SCI., 45:1426–1431, 2005. © 2005 Society of Plastics Engineers     

A rapid method for evaluation of the oxidation stability of castor oil FAME: influence of antioxidant type and concentration

The oxidation stability of castor oil fatty methyl ester (FAME), doped with four different phenolic antioxidants, was evaluated using a rapid method of thermal and air-contact degradation. The methodology is based on the induction times observed when the samples are contacted with pure oxygen at elevated pressures and temperatures. The results indicate different performances of the antioxidants as well as synergisms between antioxidants and biodiesel. In general, the addition of antioxidants increased from 6-15 times the stability of castor oil FAME., with BHA (butylated hydroxyanisol) showing the best results for improving antioxidation in castor oil biodiesel.     

Catalytic behavior of hybrid Co/SiO2-(medium-pore) zeolite catalysts during the one-stage conversion of syngas to gasoline

The catalytic properties of 10-MR (membered ring) zeolites (ZSM-5, MCM-22, IM-5, ITQ-2, all with a similar Si/Al ratio of ca. 15) in hybrid Co/SiO₂-zeolite catalysts for the direct conversion of syngas to mainly high-octane gasoline-range hydrocarbons has been studied under typical Fischer-Tropsch (FT) conditions: 250 °C, 2.0 MPa, and H₂/CO = 2. Special emphasis has been given to the deactivation behavior and the characterization of the amount and nature of the carbonaceous deposits formed by a combination of techniques (elemental analysis, TGA (thermogravimetric analyses), GC–MS, and DR (diffuse reflectance) UV–vis spectroscopy). The presence of the medium-pore zeolite increases the gasoline yield by about 20–50%, depending on the particular zeolite, and enhances the formation of branched products with respect to the base Co/SiO₂ catalyst, which is explained by the promotion of isomerization and cracking of long-chain (C₁₃₊) n-paraffins formed on the FT component. The initial zeolite activity is mostly determined by the surface acidity rather than by the total amount of Brønsted acid sites, pointing out to the existence of limitations for the diffusion of the long-chain n-paraffins through the 10-MR channels under FT conditions. Thus, ITQ-2 bearing the largest surface area presents the highest initial yield of branched gasoline-range products, followed by ZSM-5, IM-5, and MCM-22. All zeolites experience a loss of activity with TOS, particularly during the initial reaction stages. This deactivation is governed by the morphological and structural properties of the zeolite, which finally determine the amount and location of the coke species, and not by the acidity.     

Trans-10 18:1 in ruminant meats: A review

Trans (t) fatty acids (TFA) from partially hydrogenated vegetable oils (i.e., industrial trans) have been phased out of foods in many countries due to their promotion of cardiovascular disease. This leaves ruminant-derived foods as the main source of TFA. Unlike industrial TFA where catalytic hydrogenation yields a broad distribution of isomers, ruminant TFA are enzymatically derived and can result in enrichment of specific isomers. Comparisons between industrial and ruminant TFA have often exonerated ruminant TFA due to their lack or at times positive effects on health. At extremes, however, ruminant-sourced foods can have either high levels of t10- or t11-18:1, and when considering enriched sources, t10-18:1 has properties similar to industrial TFA, whereas t11-18:1 can be converted to an isomer of conjugated linoleic acid (cis(c)9,t11-conjugated linoleic acid), both of which have potential positive health effects. Increased t10-18:1 in meat-producing ruminants has not been associated with negative effects on live animal production or meat quality. As such, reducing t10-18:1 has not been of immediate concern to ruminant meat producers, as there have been no economic consequences for its enrichment; nevertheless at high levels, it can compromise the nutritional quality of beef and lamb. In anticipation that regulations regarding TFA may focus more on t10-18:1 in beef and lamb, the present review will cover its production, analysis, biological effects, strategies for manipulation, and regulatory policy.     

Qualitative and Quantitative Comparison of Plasma Exosomes from Neonates and Adults

Exosomes are extracellular vesicles that contain nucleic acids, lipids and metabolites, and play a critical role in health and disease as mediators of intercellular communication. The majority of extracellular vesicles in the blood are platelet-derived. Compared to adults, neonatal platelets are hyporeactive and show impaired granule release, associated with defects in Soluble N-ethylmaleimide-sensitive fusion Attachment protein REceptor (SNARE) proteins. Since these proteins participate in biogenesis of exosomes, we investigated the potential differences between newborn and adult plasma-derived exosomes. Plasma-derived exosomes were isolated by ultracentrifugation of umbilical cord blood from full-term neonates or peripheral blood from adults. Exosome characterization included size determination by transmission electron microscopy and quantitative proteomic analysis. Plasma-derived exosomes from neonates were significantly smaller and contained 65% less protein than those from adults. Remarkably, 131 proteins were found to be differentially expressed, 83 overexpressed and 48 underexpressed in neonatal (vs. adult) exosomes. Whereas the upregulated proteins in plasma exosomes from neonates are associated with platelet activation, coagulation and granule secretion, most of the underexpressed proteins are immunoglobulins. This is the first study showing that exosome size and content change with age. Our findings may contribute to elucidating the potential “developmental hemostatic mismatch risk” associated with transfusions containing plasma exosomes from adults.     

P16 and HPV Genotype Significance in HPV-Associated Cervical Cancer—A Large Cohort of Two Tertiary Referral Centers

The expression of p16 is a good surrogate of human papillomavirus (HPV) infection in HPV-associated cancers. The significance of p16 expression, HPV genotype and genera in the outcome of patients with HPV-associated cervical cancer (CC) is unclear. Our aim is to ascertain the prognostic significance of these factors. Data from 348 patients (median age: 47.5 years old) with CC, diagnosed in two referral centers, were retrospectively collected. Advanced disease (FIGO2018 IB2-IV) was present in 68% of patients. A single HPV genotype was identified in 82.8% of patients. The most common HPVs were HPV16 (69%) and HPV18 (14%). HPV genera reflected this distribution. HPV16 tumors presented at an earlier stage. P16 was negative in 18 cases (5.2%), 83.3% of which were squamous cell carcinomas. These cases occurred in older patients who tended to have advanced disease. In the univariate analysis, HPV16 (HR: 0.58; p = 0.0198), α-9 genera (HR: 0.37; p = 0.0106) and p16 overexpression (HR: 0.54; p = 0.032) were associated with better survival. HPV16 (HR: 0.63; p = 0.0174) and α-9 genera (HR: 0.57; p = 0.0286) were associated with less relapse. In the multivariate analysis, only the International Federation of Gynecology and Obstetrics (FIGO) stage retained an independent prognostic value. HPV16, α-9 genera and p16 overexpression were associated with better survival, although not as independent prognostic factors. Patients with p16-negative HPV-associated CC were older, presented with advanced disease and had worse prognosis.