Inside Front Cover: Fabrication of Ideally Ordered Nanoporous Alumina Films and Integrated Alumina Nanotubule Arrays by High‐Field Anodization (Adv. Mater. 17/2005)

A simple, low‐cost approach to fabricating large‐area highly ordered nanoporous alumina films in sulfuric acid solutions through a single‐step high‐field anodization, without the assistance of any additional process, is reported on p. 2115 by Chu and co‐workers. The critical high anodizing potential in the adopted electrolyte system increases with the ageing of solutions after a long period of anodization. Correspondingly, the applicable current density for stable anodization rises significantly, thus leading to high‐speed film growth. Uniform porous anodic alumina films in sulfuric acid solutions under a high electric field of 40–70 V and 1600–2000 A m^–2 are achieved.     

The recovery and recrystallization of cold rolled V-W-Ti alloys

Several V-W-Ti alloys with about 50% reduction in thickness by cold rolling were isochronally annealed at temperatures from 100 to 1100 °C. Hardness was measured after the annealing. By comparison with V4Cr4Ti and V4Ti alloys, the V6WTi alloy was found to begin recovery at a temperature about 100 °C higher, while the full recrystallization temperature was around 900 °C for all of the alloys. Hardness decreased successively above 500 °C in V8W, as is the case in pure V. Impurity induced hardening was observed around 300 °C only in the alloys without Ti. Precipitation and the interaction between interstitial impurities and dislocations were supposed to be the main contributors to the different recovery and recrystallization behaviors of the alloys.     

Change of fuel-to-cladding gap width with the burn-up in FBR MOX fuel irradiated to high burn-up

In order to study the dependence of the gap width change on the burn-up, the fuel-to-cladding gap widths were investigated by ceramography in a large number of FBR MOX fuel pins irradiated to high burn-up. The dependence of gap widths on the burn-up was closely connected with the formations of JOG (joint oxyde-gaine) and rim structure. The gap widths decreased gradually due to the fuel swelling until ∼30 GWd/t, but beyond this burn-up the dependence showed two different tendencies. With the increase of burn-up, the gap widths decreased due to the increase of fuel swelling in the low fuel temperature region where the rim structure was observed, but they increased in the high fuel temperature region where the JOG rich in Cs and Mo formed in the gap.     

Preparation and Property of Acrylic Acid Rare Earth Complex and Its Hydrosilylation

Acrylic acid rare earth complex was prepared. Its chemical composition was determined by chemical and elemental analysis, and its structure as well as properties was characterized using IR, Fluorescence and UV spectrum, and its solubility was also investigated. Meanwhile a kind of elastic functional polymer with rare earth units in the side chains was produced. It is confirmed by IR spectrum that the Si-H bonds really react with acrylic acid rare earth.     

Fabrication of alumina films with laminated structures by ac anodization

Anodization techniques by alternating current (ac) are introduced in this review. By using ac anodization, laminated alumina films are fabricated. Different types of alumina films consisting of 50–200 nm layers were obtained by varying both the ac power supply and the electrolyte. The total film thickness increased with an increase in the total charge transferred. The thickness of the individual layers increased with the ac voltage; however, the anodization time had little effect on the film thickness. The laminated alumina films resembled the nacre structure of shells, and the different morphologies exhibited by bivalves and spiral shells could be replicated by controlling the rate of increase of the applied potentials.     

Complexes of Starch and its Related Materials with Organic Compounds. Part VIII. Measurement of the Heats of Complex Formation of Cyclodextrins in Aqueous Solutions by Microcalorimeter

Calorimetric studies have been made on the complex formation of cyclodextrins with triiodide ion or p-nitrophenolate anion in aqueous solutions by using microcalorimeter. The heats of complex formation of α-, β-, and γ-dextrin, respectively with both the guest compounds were obtained and marked differences in magnitude of the reaction heats were observed for the three dextrins. The association process of the dextrins with the guest compounds in aqueous solutions was briefly discussed with respect to the points of stoichiometry and thermodynamics.     

Decentralized PD control for non-uniform motion of a Hamiltonian hybrid system

In this paper, a decentralized proportional-derivative （PD） controller design for non-uniform motion of a Hamiltonian hybrid system is considered. A Hamiltonian hybrid system with the capability of producing a non-uniform motion is developed. The structural properties of the system are investigated by means of the theory of Hamiltonian systems. A relationship between the parameters of the system and the parameters of the proposed decentralized PD controller is shown to ensure local stability and tracking performance. Simulation results are included to show the obtained non-uniform motion.     

Uterine Deletion of Bmal1 Impairs Placental Vascularization and Induces Intrauterine Fetal Death in Mice

Recently, it was demonstrated that the expression of BMAL1 was decreased in the endometrium of women suffering from recurrent spontaneous abortion. To investigate the pathological roles of uterine clock genes during pregnancy, we produced conditional deletion of uterine Bmal1 (cKO) mice and found that cKO mice could receive embryo implantation but not sustain pregnancy. Gene ontology analysis of microarray suggested that uterine NK (uNK) cell function was suppressed in cKO mice. Histological examination revealed the poor formation of maternal vascular spaces in the placenta. In contrast to WT mice, uNK cells in the spongiotrophoblast layer, where maternal uNK cells are directly in contact with fetal trophoblast, hardly expressed an immunosuppressive NK marker, CD161, in cKO mice. By progesterone supplementation, pregnancy could be sustained until the end of pregnancy in some cKO mice. Although this treatment did not improve the structural abnormalities of the placenta, it recruited CD161-positive NK cells into the spongiotrophoblast layer in cKO mice. These findings indicate that the uterine clock system may be critical for pregnancy maintenance after embryo implantation.     

Synthesis of Heptakis (2-O-methyl)-β-cyclodextrin

The title compound was prepared by a reaction sequence comprising methylation of heptakis (6-bromo-6-deoxy)-β-cyclodextrin by the Kuhn procedure, regeneration of the primary hydroxyl groups from the resulting heptakis(2-O-methyl-6-bromo-6-deoxy)-β-dextrin via the 6-O-benzoate ester by benzoate exchange and subsequent deesterification. It was proved that the methyl groups in the tetradeca-O-methyl ether of β-dextrin are located 0–2 and 0–6 of the D-glucose residues.     

Chemical Modification of Maltotriose

Hot acetylation of maltotriose with acetic anhydride and sodium acetate led to the formation of an anomerically unsubstituted maltotriose decaacetate (2.8% yield) in amorphous form in addition to the principal product, β-maltotriose hendecaacetate (80% yield). The structure of the decaacetate was elucidated by chemical reactions and n.m.r. spectroscopy. α-Maltotriose hendecaacetate and deca-O-acetyl-α-maltotriosyl chloride were prepared to facilitate the structural assignment. From measurement of the optical rotation, it was assumed that the decaacetate is a mixture of both anomers in a constant proportion. The decaacetate was also obtained either by treatment of the β-hendecaacetate with hydrogen bromide in acetic acid followed by warm aqueous sodium acetate or by the reaction of the β-hendecaacetate with piperidine in tetrahydrofuran.