电子束光刻中的辐照损伤

本文研究了电子束光刻中电子能量(10—30keV)和电荷剂量(10~(-6)—10~(-3)C·cm~(-2))对铝栅MOS电容器的损伤和低温退火(<500℃)的影响。研究电子束光刻中高能量(30keV)和高剂量(10~(-3)C·cm~(-2))电子束引起的损伤,对电子束汽相显影光刻和电子束无显影光刻是有实际意义的。实验表明,平带电压的损伤可高达十几伏,界面态密度可高达10~(12)cm~(-2)eV~(-1)以上。在一定电荷剂量下,平带电压的损伤对电子能量的变化(在一定范围内)不敏感。在一定电子能量下,界面态密度的损伤对电荷剂量的变化(在一定范围内)不敏感。低温(<500℃)退火能完全消除平带电压的损伤,但不能完全消除界面态密度的损伤。     

定量确定纤维织构轴密度分布的矢量法

本文将大幅度减少衍射极图测试数目的织构分析矢量法应用于定量确定纤维织构材料的晶粒取向分布;采用蒙特卡罗方法计算系数矩阵σ_(pn)(hkl)。对立方晶系的研究结果表明,由一张极图甚至一张不完整极图即可准确地构建纤维轴密度分布图。     

油气井射孔器用炸药及其安全性

介绍了中国和美国射孔器所用的单质和混合炸药43种.根据耐热性,射孔器可分为普通型、高温型和超高温型三类.射孔器和炸药的耐热性与其受热时间有关,最后文中叙述了射孔器的安全性能.     

水分对高碱值硫化烷基酚钙结构和清净性的影响

采用傅立叶红外光谱仪，分析了水分对清净剂高碱值硫化烷基酚钙结构组成的影响；采用热管氧化试验法和曲轴箱模拟试验法，考察了高碱值硫化烷基酚钙在加水前后清净性能的变化；采用四球试验机和高频往复试验机，分析了水分对高碱值硫化烷基酚钙润滑性能的影响。结果表明，油中的水含量对高碱值硫化烷基酚钙的水解安定性能影响较大，并且随着水含量的增加，油品的清净性能和抗磨性能变差。     

三相异步电动机运行指标的分析

利用电机学理论分析了影响电机起动转矩、起动电流、最大转矩和最小转矩的因素。     

Study on Adsorption Behavior of Rare Earth Complexes on Nanometer-Size Titanium Dioxide with ICP-AES

Inrecentyears ,rareearthelements (REEs)havebeenwidelyusedinfunctionalmaterials ,cata lystsandotherproductsinindustry ,diagnosisreagentsofmagneticresonanceimaging (MRI)inmedicineandsomefertilizersinagricultureespeciallyinChina .However,asaresultoftheirusage ,moreandmoreREEsaregettingintotheenvironment,andalsointohumanbodyviafoodchain[1,2 ] .Itisnotclearwhetherrareearthelementsareessentialforman ,soitisveryurgenttostudythebiologicaleffectofrareearthelementsinhumanhealthandenvironment .Inthes…     

含钡合金的生产及其对钢液脱氧行为的研究

介绍了含钡合金的生产状况。在MoSi2炉上对钢管钢进行了含钡合金脱氧行为的研究，然后在150tLF／VD精炼设备上进行了使用含钡合金的工业试验。研究中主要选取SiAlBa、SiCaBa、SiAlBaCa、SiAlBaCaSr及用于钙处理的SiCa包芯线，并选用Al和FeSiAl作为对比脱氧剂，分别考察了实验室条件下和实际生产过程中，采用钡系合金对钢液脱氧的全氧含量，脱氧产物的分布、尺寸和形貌，探讨了钡系合金脱氧和对夹杂物的变质作用的机理。     

吉林闹枝金矿床黄铁矿的标型特征研究

从成因矿物学及找矿矿物学的观点出发，系统地研究了闹枝金矿床黄铁矿的形态、粒度、化学成分、热电性、硫同位素方面的标型特征，为矿床的成因研究和深部远景评价提供了矿物学依据。     

A novel optical burst switching scheme—logical cascaded private subnet with start wavelength assignment policy

Many recent studies have convincingly demonstrated that network traffic exhibits a noticeable self-similar nature, which has a considerable impact on network performance, and most studies of optical burst switching (OBS) networks are under a fundamental assumption that full wavelength conversion is available throughout the network. In practice, however, economic and technical considerations are likely to dictate a more limited and sparse deployment of wavelength converters in the optical network. Therefore, we present a novel scheme for OBS networks, called logical cascaded private subnet (LCPN) with start wavelength assignment policy. We define the concept of canoe relative to cluster in self-similar traffic, and introduce a new device named payload segregator at the edge node as a gateway to the core node in OBS Networks. According to the changes in the edge node framework, we put forward the concept of cluster private subnet and canoe private subnet in the core node correspondingly. A new start wavelength assignment policy is proposed for the absence of (full) wavelength conversion capabilities in the core node of OBS Networks. The performance study indicates that, our new scheme is robust under self-similar traffic and wavelength continuity constraint.     

First Harmonic (2f) Characterisation of Resonant Frequency and Q-Factor of Micromechanical Transducers

In this paper, the response to the first harmonic component (2f) of the electrostatic force in single terminal driven electrostatic comb-drive and parallel-plate drive was used as a signal to extract device parameters, namely, the Q-factor and resonant frequency instead of the fundamental (1f) resonance response. It is shown that the difficulty in motional measurement due to electrical cross-talk (parasitics) using 1f measurement can be overcome with a higher signal-to-noise ratio of the 2f signal. Both atmospheric (low-Q) and reduced pressure environment were investigated using off-chip electronics and lock-in amplifier. The measurements were done on the electrostatic comb-drive and capacitive parallel plate sensing plates that form the two core modules of a yaw rate sensor (dual-axis resonator). The effects of AC and DC bias voltages on the measured response have been investigated. Experimental amplitude and phase response data have been analysed using the Lorentzian curve-fit, Resonance Curve Area (RCA) method, the half-power bandwidth method (3 dB) and the Nyquist plot for data fitting and determination of the Q-factor and resonance frequency.