A Computational Investigation on the Control of Cavity-Induced Pressure Oscillations Using Sub-Cavity

A computational investigation has been conducted to determine the effectiveness of a passive control technique ofattenuating cavity-induced pressure oscillations in a confined two-dimensional supersonic flow.The passivecontrol technique is achieved by fitting two flat plates near the front wall of a square cavity at Mach number 1.83at the cavity entrance.The results showed that the flat plates attached near the front wall of the cavity,discouraged the formation of feedback loop which is widely believed to be the reason of cavity resonance.Theresultant amount of attenuation of pressure oscillations was also dependent on the length of the fiat plate used asan oscillation suppressor.     

正反转双转轮水轮机水力性能研究

研究用于低水头的反转双转轮、双转子小型水力发电设备,探讨反转双转轮的基本原理与水轮机转轮的水力特性,确认了在流量一定的运转工况时反转前转轮转速与正转后转轮转速相等条件下可以得到最高效率、且出力为两转轮之和(单转轮的2倍)。通过模型实验,确认了正反转两转轮的水力性能基本满足一般的相似准则,可以进行实际转轮设计时的换算。     

Effect of Non-Equilibrium Condensation of Moist Air on Flow Field in Ludwieg Tube

The time-dependent behavior of non-equilibrium condensation of moist air through a Ludwieg tube with a diaphragm downstream is investigated by using a computational fluid dynamics work. The two-dimensional, compressible, Navier-Stokes equations, fully coupled with the condensate droplet growth equations, are numerically solved by a third-order MUSCL type TVD finite-difference scheme with a second-order fractional time step. Baldwin-Lomax turbulence model is employed to close the governing equations. The present computations represent the experimental flows well. The results obtained show that for an initial relative humidity over 40 %, the periodic excursions of the condensation shock occurs in the Ludwieg tube, and the frequency increases with the initial relative humidity. It is also found that total pressure loss due to non-equilibrium condensation in the Ludwieg tube should not be ignored even for a very low initial relative humidity. Furthermore, the variations of condensation properties are also di     

Pulse Combustors - Performance and Control

~nonEmphasising time characterishcs and contIDI, onlyfew workll'v is av'ailable among the numerous reports onPulse combustors. Rare work deals with tWin Pulsecombustorsls] or combined pulse combustor-"dinesystemsl']. Kenffield15] obtained with a combinedconvenhonal Pulse combustor-tulbine system acombushon Pressals gain of 3-7% and a totalPerformance Of the combustor-"dine system for Pulsecombushon 40% higher than that of steady'combushonwhat aught also be due tO the brine characteristics.…     

Numerical study of radiation‐convection heat transfer

In this study, the authors attempted to introduce a simulation technique for radiation‐convection heat transfer in the high‐temperature fields of industrial furnaces, boilers, and gas turbine combustors. The convection effect was analyzed by a differential equation, but the radiation effect was analyzed by an integral equation. Thus, it was not easy to arrange both effects using the same type of equations. Then, the authors introduced the zone method and Monte Carlo method for the integral equation of the radiation effect and the finite difference method for the differential equation of the convection effect. A three‐dimensional analysis of the high‐temperature furnace was performed by this simulation technique to obtain its temperature distribution. Furthermore, another radiation‐convection heat transfer analysis in the low‐temperature living room was performed by the same technique. Finally, the authors tried to develop a computer software for radiation‐convection heat transfer and described their idea of software construction for the above. © 2002 Wiley Periodicals, Inc. Heat Trans Asian Res, 31(5): 391–407, 2002; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/htj.10042     

Three Dimensional Separation with Spiral—Focus in a Decelerating Duct Flow （Effect of Asymmetric Inlet Boundary Layer Thickness）

An experimental apparatus was developed to study the three dimensional separated flow with spiral-foci. The internal decelerating flow was generated by the air suction from a side wall to produce the separation on an opposite-side wall. The relation between the upstream boundary layer and the generation of spiral-foci in the separation region was observed by a tuft method. As a result, it was clarified that the spiral-focus type separation could be produced on the side wall and its behavior was closely related to the vortices supplied into the separation region from the boundary layer developing along top wall or bottom one.     

Numerical Investigation of Kinetic Energy and Surface Energy of Wavy Falling Liquid Film

Numerical simulations have been carried out for two-dimensional wavy falling liquid film in order to investigatekinetic energy and surface energy of that liquid film.Governing equations,which are continuity equation,Na-vier-Stokes equation,and equations of interfacial boundary conditions including surface movement and effect ofsurface tension,have been solved directly by means of a numerical scheme based on the finite difference method.In most cases,periodic disturbances superimposed at inflow boundary grow to fully developed waves which re-tain the given periodic behavior.In some cases,however,random waves appear after the fully developed waves.Variations of kinetic energy and surface energy of the periodically developed waves and the random waves havebeen discussed.     

Assimilative and co-metabolic degradation of chloral hydrate by bacteria and their bioremediation potential

Although the bacterial degradation of chloral hydrate (CH) has been recognized for several decades, its degradation pathway by assimilation has not been demonstrated. In this paper, we report the isolation of the LF54 bacterial strain, which utilizes CH as its sole carbon and energy source. LF54 converted CH into trichloroethanol (TCAol), which was dehalogenated to dichloroethanol (DCAol), and CO(2) was detected as the end product. Another strain that we isolated, RS20, co-metabolized CH into TCAol. Our 16S rRNA gene sequencing and taxonomic analyses revealed that the LF54 and RS20 strains belong to the Pseudomonas and Arthrobacter genera, respectively. When the two strains were inoculated into soil microcosms, both degraded 0.3mM CH to undetectable levels (<0.01mM) within 5days. These results suggest that LF54 and RS20 could be used in the bioremediation of CH-contaminated environments.     

Environmental ecological modeling of human blood lead levels in East Asia

Environmental ecological modeling (EEM), which unifies models simulating transport of chemicals and exposure of humans to chemicals, was used to simulate long-term trends of female adult human blood lead levels (BLLs) and historical exposure to the atmospheric lead in four East Asian countries: Japan, Korea, China, and Vietnam. Anthropogenic lead emissions to the atmosphere in Vietnam were estimated from energy statistics to be 1931 t yr(-1). Calculated BLLs generally agreed with those observed in samples collected in these countries as the error factors were less than 2. The model results revealed that BLLs decreased significantly in Tokyo (by 58%) and Seoul (by 45%) in recent decades and confirmed the effects of efforts to reduce environmental lead in Japan and Korea. The model results also revealed that BLLs in Beijing did not decrease in this decade as much as in Tokyo and Seoul, despite the phasing out of leaded gasoline, and that the contribution from the atmospheric component was increasing (43% in 2009). Finally, we applied EEM to simulate BLLs of children in Hanoi. The probability of children having BLLs greater than 50 μg L(-1) was 7.5%, which was greater than those observed in developed countries.     

Study on the compressible viscous flows through a straight pipe

When sonic nozzles of significantly smaller diameter are used as standard flow meters, the critical backpressure ratio is affected by the boundary layer at the nozzle throat. It is known that, as the flow pathway is complicated in actual valves, the critical pressure ratio differs from the ideal value. However, the effect of the boundary layer thickness on choking criteria is still controversial. Choking phenomenon in a sonic nozzle fitted with a straight circular pipe of variable length is investigated numerically and the results are compared with experimental and theoretical ones. The results show that the actual critical pressure ratio is less than the ideal value and it decreases with increase in pipe length. The effect of boundary layer thickness on main flow Mach number is also made clear in this work. In addition, sonic conductance and pressure loss in actual viscous flows computed are compared with the ISO 6358 standard.