Zero and first sound velocity and Fermi liquid parameterF 2 s in normal3He

A precise velocity measurement of zero and first sound in normal³He was performed over the pressure range of 0.5 bar and 10 bar at a frequency of 389.1 MHz using a phase detection technique. From these measurements, the Fermi liquid parameter F ₂ ^s was determined as a function of pressure. The new value of F ₂ ^s was positive and less than 0.25 at all pressures below 10 bar. It allows propagation of transverse zero sound mode for all pressures within the current theoretical picture.     

Environmental effect on room- temperature ductility of isothermally forged tial- base alloys

Isothermally forged TiAl-base alloys (Al-rich, Mn-containing, and Cr-containing TiAl) were heat-treated in various conditions, and equiaxed grain structures consisting of γ and α₂ or Β phases were obtained. The heat-treated alloys were tensile tested in vacuum and air at room temperature, and the environmental effect on tensile elongation was studied. The ductility of the alloys consisting of equiaxed γ grains and a large amount of α₂ grains was not largely affected by laboratory air, and a decrease in the amount of α₂ grains resulted in a large reduction of ductility in air. The Β phase in the Cr-containing alloy improved the ductility in vacuum, but it resulted in a large reduction of ductility in air. Formerly with Kougakuin University, Shinjyuku-ku, Tokyo, Formerly with National Research Institute for Metals, Meguro-ku, Tokyo,     

An over 2200-km coherent transmission experiment at 2.5 Gb/s usingerbium-doped-fiber in-line amplifiers

A 2223 km transmission distance was achieved with a 2.5-Gb/s heterodyne detection system that used erbium-doped-fiber in-line amplifiers and dispersion-shifted single-mode fibers. Twenty-five amplifiers, placed at approximately 80-km intervals, offered a total gain of more than 440 dB. Receiver sensitivity was -42.0 dBm, with only a 4.2-dB penalty from the initial sensitivity achieved by the back-to-back configuration     

Dependence of the efficiency-bandwidth product on electrical volumeof small dielectric loaded antennas

The efficiency fractional efficiency bandwidth product (EB) that is expressed as a ratio of the radiation resistance to the absolute value of an input reactance of an antenna is used as a performance measure for small dielectric-loaded monopole antennas (DLMAs). The dependence of the efficiency bandwidth (EB) on the permittivity of the dielectric loading (i.e., the electrical volume) is experimentally investigated for the first time after we succeeded in measuring the small radiation resistance of the DLMAs precisely on the basis of the Wheeler cap method. As a result, it was found that the EBs of some DLMAs were enhanced over a bare monopole antenna and an EB characteristic curve has a maximum point. This result suggests the presence of the optimum electrical volume for the dielectric loading in order to obtain the best EB performance. A calculation by the finite-difference time-domain (FDTD) method was also conducted to confirm the presence of the maximum EB value under a certain condition. A general reason for the existence of the peak value is also explained using a mathematical deduction     

Dynamic properties of an all solid-state frequency-shifted feedbacklaser

Frequency-shifted feedback (FSF) laser exhibits outstanding features in its oscillation spectrum. We analyze build-up dynamic properties of the FSF laser by means of rate equation and analyze steady-state dynamic properties of the FSF laser by means of Wigner-Ville distribution of intracavity electric field. Furthermore, we analyze instantaneous oscillation frequency at peak spectral intensity and oscillation bandwidth of its spectrum using the formula of instantaneous spectral intensity derived from Wigner-Ville distribution of intracavity electric field. These analytical results are in good agreement with the experimental ones which have been observed by a diode-pumped Nd:YVO₄ FSF laser. It becomes clear that the FSF laser supports many frequency components simultaneously even though the gain medium is homogeneously broadened and has a continuously chirped frequency components of comb in which the creation of chirped frequency components are strongly correlated in phase because of a replica of the preceding components. Also, the instantaneous oscillation frequency is closely related to the detuning frequency which depends on the total net gain in the cavity and the gain bandwidth of atomic transition. The oscillation bandwidth is defined as the product of the saturation-broadened bandwidth and the total resonant modes contributing to FSF operation     

Elevated levels of tumor necrosis factor-alpha (TNF-alpha) and interleukin-6 (IL-6) activities in the sera and milk of cows with naturally occurring coliform mastitis

The presence of tumor necrosis factor-alpha (TNF-alpha) and interleukin-6 (IL-6) activities was determined in milk and serum of cows with naturally occurring coliform mastitis (CFM). TNF-alpha was detected in the sera from 26 of 32 cows with CFM. TNF-alpha levels were higher in the sera than in the milk. IL-6 was high in the sera of surviving CFM animals, but was low in animals that died and in healthy controls. Furthermore, the mean level of IL-6 was 20-fold higher in the milk than in the sera of mastitic cows. The level of IL-6 in the serum was correlated to that in the milk in individual animals. The presence of IL-6 and TNF-alpha in the sera appears to relate to severe clinical condition of CFM, in the milk whereas they may play a role in generating inflammation of the mammary gland.     

Restoration of the red colour of photo-bleached carthamine in calcium-alginate gel membranes

The restoration of the red colour of carthamine (photo-bleached in polymeric heterosaccharide gels) was investigated using sodium salts, potassium salts, and alkali. Ca-alginate gel was stained with carthamine, and the red-dish membranes were exposed to fluorescent light for 2·5, 4·0 and 20 h (at 28°C). The resulting orange-yellow gel membranes were treated with Na- or K-citrate solution and the restoration of the red colouration was followed spectrophoto-metrically. The results indicate that the red colour of carthamine can be retained within the gel membranes, while yellow-coloured compounds were removed and/or transformed by the alkaline salt solutions.     

Perspective for clinical laboratory management and its systematization--effects of the systematization of clinical laboratory management

There are a large number of ideas concerning the systematization of clinical laboratory management. Therefore many types of laboratory systems have been constructed. As our hospital is not large, we adopted a small scale laboratory system. In introducing it, we expected not only an increase in value-added labor productivity by automating laboratory tests, but also an improvement in technologist's cost awareness. Consequently, new system equipment has itself performed the former in many sections, but not the latter. Improvement in cost awareness was caused by the technologist's routine work in managing reagent and material stocks. We found that this soft-type systematization has been more important than the advanced hard-type system.     

Pulsed KrF excimer laser annealing of silicon solar cell

The pulsed KrF excimer laser annealing of silicon films for solar cell with EBEP-CVD and LP-CVD was studied theoretically and experimentally. Three-dimensional thermal diffusion equation for microcrystalline and amorphous silicon was solved by using the finite difference methods. The results of our heat-flow simulation of laser re-crystallization in a laser irradiation with 50 ns pulse duration almost agree with the experimental results in re-crystallization depth of 0.7 μm for microcrystalline silicon (EBEP-CVD) and 0.4 μm for amorphous silicon (LP-CVD) in a single pulse excimer laser annealing.     

A load dispatch method using fractional programming and semidefinite programming

This paper describes a load dispatch method which minimizes power cost—[fuel cost]/[electric output]—for a power system with thermal plants and energy storage facilities. The proposed method employs fractional programming to convert a minimization problem with fractional objective function to a series of quadratic minimization problems, and semidefinite programming to solve converted problems. The method provides the optimum time‐dependent power output/input and storage level of energy storage facilities as well as time‐dependent power output of thermal plants. The method has been applied to a power system with five thermal plants, two energy storage facilities of various performances, and five load demands. The optimum load scheme of four time mesh points is obtained for the thermal plants and energy storage facilities. The fractional programming successfully converges the optimal scheme through a few iterations. The semidefinite programming deals with a variable matrix of 164 dimensions, and 185 inequality constraints. © 2001 Scripta Technica, Electr Eng Jpn, 138(2): 49–58, 2002