Emission of trace toxic metals during pulverized fuel combustion of Czech coals

A study of the trace elements emission (As, Se, Cd, Co, Cr, Cu, Zn, Hg, Tl, Pb, Ni, Sn, Sb, V, Mn and Fe) from pulverized coal combustion has been made at six heating and power stations situated in the Czech Republic. The amount of chlorine in coal has considerable influence on volatilization of some elements such as Zn, Cu, Pb, Hg and Tl, which is explained by the formation of thermodynamically stable compounds of these elements with chlorine. Generally, the affinities for Cl follows the order Tl > Cu > Zn > Pb > Co > Mn > Sn > Hg. The experimental data indicates enrichment of some of the trace toxic elements in the emissions (Cu, Zn, As, Se, Cd, Sn, Sb, Hg and Pb) and good agreement was obtained by thermodynamic equilibrium calculations with a few exceptions. In the case of Fe, Mn, Co, Cr and Sn calculated values are overestimated in the bottom ash and there are zero predicted amounts of these elements in the fly ash. In comparison, the results from experiments show up to 80% of these elements retained in fly ash. This implies that there exist additional steps leading to the enrichment by Fe, Mn, Co, Cr and Sn of small particles. Such mechanisms could include the ejection during devolatilization of small inorganic particles from the coal of bottom ash particles, or disintegration of the char containing these metals to small particles of fly ash. On the other hand, there are slightly overestimated or similar values of relative enrichment factors for As, V, Cu, Cd, Sb, Tl and Pb in the fly ashes and zero predicted values for bottom ashes. Our experimental results show about 5% or less of these elements are retained in bottom ashes, so they probably remain in the bottom ash inside unburned parts of coal. Copyright © 2003 John Wiley & Sons, Ltd.     

Influence of aminophylline and 8-(p-sulfophenyl)theophylline on the anticonvulsive action of diphenylhydantoin, phenobarbital, and valproate against maximal electroshock-induced convulsions in mice

Time variation of drinking is substantial and has an effect on aggregate estimates of consumption. In this article it is shown that because of a considerable seasonal variation in consumption (+/- 20%) a serious bias in annual consumption estimates can be expected in surveys with a limited time frame. The present study analyzes drinking data collected in the general population of the Netherlands from March 1985 through December 1985 (including Christmas and New Year's Eve). Since it was expected that sensitivity to temporal fluctuations might not be equal for different methods of measurement, several indices of consumption were compared. Although the assessed seasonal effect varies indeed across types of measurement, across male and female subsample and across types of alcoholic beverage, the general tendency is for consumption to be highest in the spring season and lowest in the autumn. Sales figures fluctuate accordingly. It is evident that the risk of biased estimates is larger the shorter the time frame of the survey. Seasonal variation was highest in the frequency domain. Furthermore, exclusion from the time frame of collective holidays, during which people drink more often and more per occasion (viz., Christmas), increases the risk of biased estimates. Even estimates of abstention, but also regular heavy drinking among women, appear to vary considerably over the three seasons in this study. The main conclusion is that results of comparisons of survey data on drinking, particularly those over time, are more or less invalid if the respective time frames of the surveys do not correspond.     

Regional chemotherapy of liver tumors

In the absence of adequate autogenous vein for tibial artery bypass in limb salvage surgery, the use of prosthetic grafts with a distal anastomotic vein cuff or patch has shown promising results. Here, we describe how the Florester Internal Vessel Occluder (Meadox UK, Bedfordshire, UK) can facilitate the construction of a distal anastomotic vein cuff.     

Oxygen absorption kinetics in YBa2Cu3Ox

The oxygen absorption process in highly aligned YBa₂Cu₃O_x samples in air and in pure oxygen was studied at several constant temperatures. The process can be expressed in two steps, a chemical reaction controlled step and a diffusion controlled step. The kinetic equations are as follows respectively:

(1 − a_t) ln(1 − a_t) + a_t = k_Dt

The activation energy was calculated using an Arrhenius equation. The technical conditions of heat treatment for oxygen absorption of highly aligned YBa₂Cu₃O_x crystals are discussed.     

An expert system with temporal reasoning for alarm processing inpower system control centers

The alarm lists presented to control center operators are usually difficult to interpret. The authors present an expert system that processes the alarm lists in Portuguese control centers. This system makes an intelligent synthesis of the available information and presents it in a flexible and structured way. It uses an original approach to deal with temporal reasoning and real-time constraints. The system incorporates an explanation module that enables its use as a tutor for novice operators     

High fibre bread containing brewer's spent grains and its effect on lipid metabolism in rats

Bread samples containing milled brewer's spent grain (BSG) at levels of 10–25% were prepared. The protein content of the bread ws found to be 15.4, 16.3 and 18.8%, when BSG was added at levels of 10, 20 and 25%, respectively. Fibre content however was 4.9, 6.4 and 7.5%, repectively. Amino acid pattern of the bread samples revealed that most of the essential amino acids were found in considerable amounts compared to the FAO provisional pattern with exception to lysine, threonine and tryptophan which showed deficiencies. The bread samples were fed to rats for 28 days, after which total lipids and cholesterol were measured. The results indicated impaired growth weight (7.1–10.0%) compared with the control. Total lipids as well as total cholesterol were also reduced by 5.7–8.0% and 6.0–8.3%, respectively. Sensory evaluations of prepared bread showed high score acceptance for fino bread, rolls and baton salie amounted to 70.0, 63.0 and 62.7%, respectively.     

Comparison of Displacement and Mixing Diffusers

In order to cumpare the peformance of different supply diffuers of ventilation air, the airflow passern, temperature stratifiation and contaminant dispersion in a furnitured office ventilated by three kinds of air diffuer were numerically investigated. The air diffuers studied in this paper are a quarter-cylinder displacement diffuer on the floor and mixing diffuers (linear and vortex diffuers) on the ceiling. The heat sources in the of-fice are considered to be 50% convective and 50% radiative. The k-? two-equatwn model of turbulence is employed to predict the turbulent diffusion. The results show that the displacement diffuser provides a rather uniform flow field with low velocify in most areas, and the vertical temperature difference from floor to ceiling is as high as 6 K. With the linear diffuser, the air velociry is high, and the temperature is uniform both horizontally and vertically. The air velocity generated by the vortex diffuser is moderate. The distributions of the temperature and the contaminant are rather uniform.     

Analysis of a resonant-cavity enhanced GaAs/AlGaAs MSMphotodetector

The authors have developed a 2-D device simulator for heterostructure metal-semiconductor-metal (MSM) photodetectors. They have incorporated a model of multilayer optics into the simulator and used it to analyze the temporal response of a resonant-cavity enhanced heterostructure with a confining buffer layer and a distributed Bragg reflector (DBR). The authors show that through fine tuning the layer thicknesses, optical resonance enhancement of the light absorption can be obtained     

Improving power factor in the presence of harmonics usinglow-voltage tuned filters

The development of a simplified approach for sizing and placement of tuned filters for power factor correction of nonlinear loads is outlined. This approach has been successfully applied to industrial power distribution systems ranging in size from 550 to 10000 kVA. Six case studies that illustrate different aspects of the approach are presented. In all instances, power factor was improved to meet the goal, and in many cases, harmonic distortion was significantly reduced