Performance of Efficient Signal Detection for LED-ID Systems

In this paper, effects of reader-to-reader interference are investigated for LED identification (LED-ID) system in a multi-reader environment. The LED-ID readers typically use different channels to avoid collision between readers. However, in-channel collision usually happens in terms of interrogation range. A reader-to-reader interference scenario is proposed, and nominal interrogation range of a desired reader is derived from this model. In order to evaluate the LED-ID reader-to-reader interference quantitatively, an efficient detection scheme is proposed and simulated by employing spreading sequence. The spreading sequence is inserted between each user’s frame formats. In the receiver, the desired signal is detected by using correlation among inserted spreading sequences. From simulation results, it is confirmed that the proposed scheme is very effective to enhance reliability of LED-ID communication systems.     

Rheological Characteristics of Fibrinogen-Thrombin Solution and Its Effects on Surimi Gels

Gel enhancing effects of fibrinogen-thrombin on surimi were investigated using failure stress and analyzed by mixture design. Gelation time of fibrinogen-thrombin mixture (20:1) gradually decreased as temperature increased from 5 to 40°C, whereas the G′ and G″ values continued to decrease up to 30°C and then increased at >30°C. Low quality surimi produced higher textural values (stress and strain) when fibrinogen and thrombin mixture (3–5%) had been added. Nonlinear stepwise regression model showed no significant interaction effects between surimi and fibrinogen-thrombin mixture. However, the response trace plot showed that failure stress value of surimi gel was increased by the concentration of fibrinogen-thrombin, but decreased by water content.     

A Rigorous 2D Approximation Technique for 3D Waveguide Structures for BPM Calculations

We propose a rigorous 2D approximation technique for the 3D waveguide structures; it can minimize the well‐known approximation errors of the commonly used effective index method. The main concept of the proposed technique is to compensate for the effective cladding index in the equivalent slab model of the original channel waveguide from the modal effective index calculated by the nonuniform 2D finite difference method. With simulations, we used the proposed technique to calculate the coupling characteristics of a directional coupler by the 2D beam propagation method, and the results were almost exactly the same as the results calculated by the 3D beam propagation method.     

使用集成式负载开关和降压转换器组合 实现更可靠的USB调制解调器设计

在便携电子产品市场,无线网络的出现让人们能够随时随地进行高效的无线通信,而这正是设计便携式电子产品时的首要考虑因素之一。无线调制解调器是一种与无线网络而非电话系统连接的调制解调器。当用户连接无线调制解调器时,实际上就直接连接了无线互联网服务提供商。全球移动通信系统（GlobalSystemforMobile,GSM）和通用分包无线服务（GeneralPacketRadioService,GPRS）无线调制解调器均由uSB的VBUS线供电,提供了一种实现通用式便携设备环境的好方法。不过,这种调制解调器设计也带来了功率管理问题,因为GSM和GPRS发送器需要高达2A的峰值电流,而这却超过了USB电源的最大电流容量。     

Virus‐Templated Self‐Mineralization of Ligand‐Free Colloidal Palladium Nanostructures for High Surface Activity and Stability

In solution‐based synthesis of colloidal nanostructures, additions of ligands, stabilizers, and redox reagents are generally required to obtain desirable structures, though ligands and stabilizers on the surface of nanostructures can substantially affect the surface‐related activity. Accordingly, an extensive rinsing process is usually required to remove residual reagents and stabilizers. This study reports a spontaneous self‐biomineralization of palladium (Pd) ions on a filamentous virus to form ligand‐free Pd nanowires under ambient conditions. No reducing reagents or additional surface stabilizers are used; the genetically modified virus alone supports the polycrystalline Pd nanowires within the nanostructure, maintaining the clean surface even without a rinsing process. The advantage of the ligand‐free Pd nanowires is found in the Suzuki‐coupling reaction, in which the nanowire catalytic activity is maintained after repeated reactions, while conventional Pd colloids undergo surface contamination by the stabilizer and lose their catalytic activity during repeated uses. The ligand‐free surface, high electronic connectivity, and structural stability of the Pd nanowires also allow high sensitivity and selectivity in hydrogen gas sensing analysis. This work emphasizes the importance of the ligand‐free surface of biotemplated nanostructures in maintaining functionalities without surface contamination.     

Effects of Interfacial Dielectric Layers on the Electrical Performance of Top‐Gate In‐Ga‐Zn‐Oxide Thin‐Film Transistors

We investigate the effects of interfacial dielectric layers (IDLs) on the electrical properties of top‐gate In‐Ga‐Zn‐oxide (IGZO) thin film transistors (TFTs) fabricated at low temperatures below 200°C, using a target composition of In:Ga:Zn = 2:1:2 (atomic ratio). Using four types of TFT structures combined with such dielectric materials as Si₃N₄ and Al₂O₃, the electrical properties are analyzed. After post‐annealing at 200°C for 1 hour in an O₂ ambient, the sub‐threshold swing is improved in all TFT types, which indicates a reduction of the interfacial trap sites. During negative‐bias stress tests on TFTs with a Si3N4 IDL, the degradation sources are closely related to unstable bond states, such as Si‐based broken bonds and hydrogen‐based bonds. From constant‐current stress tests of Id = 3 µA, an IGZO‐TFT with heat‐treated Si₃N₄ IDL shows a good stability performance, which is attributed to the compensation effect of the original charge‐injection and electron‐trapping behavior.     

An improved sensorless driving method for SRM using a phase-shift circuit technique

This paper presents an improved sensorless driving method for switched reluctance motor (SRM) using a phase-shift circuit technique. The conventional method consists of impressing short voltage pulses during unenergized phases, measuring the phase current pulses, and finding the correlation between the filtered current signals and rotor position. However, the filtering process causes a signal phase delay which varies with motor speed. This delay must be compensated for in providing the sensorless signal which is proper to the rotor position. A solution for this phase delay compensation, based on a simple analog and digital circuit, is proposed in this paper.     

Soluble pentacene thin-film transistor using a high solvent and heat resistive polymeric dielectric with low-temperature processability and its long-term stability

Solution processable organic thin-film transistors (OTFTs) were fabricated using 6,13-bis(triisopropyl-silylethynyl) pentacene (TIPS-pentacene) and low-temperature processable polyimide gate dielectric. The TIPS-pentacene OTFT with the dielectric was found to have a field-effect mobility of 0.15 cm²/Vs, which is comparable to that of OTFT with an inorganic dielectric. The OTFTs with the polyimide dielectric did not show any significant performance degradation as time passed. A field-effect mobility of the OTFTs in 60 days was found to be almost identical to that of pristine OTFT. The combination of TIPS-pentacene and our polyimide gate dielectric can be one of the potential candidates for the fabrication of stable OTFTs for large-area flexible electronics.     

Precious‐Metal‐Free Electrocatalysts for Activation of Hydrogen Evolution with Nonmetallic Electron Donor: Chemical Composition Controllable Phosphorous Doped Vanadium Carbide MXene

The insufficient strategies to improve electronic transport, the poor intrinsic chemical activities, and limited active site densities are all factors inhibiting MXenes from their electrocatalytic applications in terms of hydrogen production. Herein, these limitations are overcome by tunable interfacial chemical doping with a nonmetallic electron donor, i.e., phosphorization through simple heat‐treatment with triphenyl phosphine (TPP) as a phosphorous source in 2D vanadium carbide MXene. Through this process, substitution, and/or doping of phosphorous occurs at the basal plane with controllable chemical compositions (3.83–4.84 at%). Density functional theory (DFT) calculations demonstrate that the P? C bonding shows the lowest surface formation energy (ΔG_Surf) of 0.027 eV Å^?2 and Gibbs free energy (ΔG_H) of –0.02 eV, whereas others such as P‐oxide and P? V (phosphide) show highly positive ΔG_H. The P3–V₂CT_x treated at 500 °C shows the highest concentration of P? C bonds, and exhibits the lowest onset overpotential of –28 mV, Tafel slope of 74 mV dec^?1, and the smallest overpotential of ‐163 mV at 10 mA cm^?2 in 0.5 m H₂SO₄. The first strategy for electrocatalytically accelerating hydrogen evolution activity of V₂CT_x MXene by simple interfacial doping will open the possibility of manipulating the catalytic performance of various MXenes.