A biochar from casein and its properties

A biochar was prepared by pyrolysis of casein. A helium and mercury porosimeter were used to measure the true and apparent densities of the chars respectively, elemental and IR analysis were used to characterize the chemical composition of char. A SEM was used to observe the char surfaces in order to verify the presence of porosity. The biochar has 9.02% of nitrogen, content of porosity is 20%. The experimental results show that it is possible to prepare chars with relatively high porosity from casein for the further preparation of activated carbon.     

Monte Carlo simulation of gas phase polymerization of 1,3‐butadiene. Part II: Kinetics optimization and confirmation

Studies on the deactivations and initiations of gas phase polymerizations of 1,3‐butadiene have been achieved by Monte Carlo simulation. Initiation and deactivation control the reaction before and after the peak of the polymerization rate, respectively. The influence of polymerization temperature has been studied. Monte Carlo modeling of polymerization kinetics and mechanism was confirmed by the agreement of experimental data and simulation results of polymerizations run with a temporary evacuation of monomer. The balance of catalysts and active chains is established by both initiation and chain transfer reactions with cocatalyst, which causes a ‘pseudo‐stability’ stage. © 2003 Society of Chemical Industry     

基于网格技术的下一代电信网络架构与运作模式

首先详细介绍了基于网格技术的下一代电信网络架构及其应用．然后探讨了在此基础上的新运营模式．并讨论了引入网格技术对电信运营模式的影响。     

斜拉索-磁流变阻尼器系统半主动控制的神经网络法

磁流变阻尼器具有良好的可变阻尼特性，能用于结构的半主动控制。针对斜拉桥拉索-磁流变阻尼器系统，本文提出了利用神经控制器进行半主动控制的神经网络法，该神经控制器根据过去时刻的加速度响应和控制信号预测下一时间步的控制信号，并给出了训练方法及开展了数值仿真研究。仿真结果显示，采用神经网络半主动控制能取得很好的减振效果，证明该方法是可行的。     

燕皮传统加工工艺中碱液对肉糜特性的影响

燕皮是以猪肉和甘薯粉为原料,手工制成的薄如纸且经煮不烂的传统食品。在传统制作燕皮过程中添加山榉灰配制的碱液是影响肉糜品质的关键步骤。通过测定制作燕皮过程中各工序样品的氮溶解指数、持水性、乳化稳定性、pH值和粘度,利用SDS-PAGE分析样品中的蛋白质组分、利用光学显微镜观察它们的结构变化,证实植物碱液能够提高样品的氮溶解指数、持水性和乳化稳定性并且延迟了肉糜硬化。同时实验证明碳酸碱(Na2CO3或K2CO3)可替代传统工艺中的植物碱,为后续标准化、工业化生产提供可行条件。     

高分子表面活性剂对超声辐照下苯乙烯乳液聚合的影响

在超声辐照引发苯乙烯乳液聚合中加入一种新型的以羧甲基纤维素为基础的高分子表面活性剂(CMC—A9)，讨论了高分子表面活性剂对反应动力学的影响。实验表明，超声辐照下初级自由基并非由通常认为的高分子表面活性剂产生，而是十二烷基硫酸钠在超声辐照下断裂，产生自由基。通过对反应动力学的研究，发现超声辐照下乳液聚合机理不同于常规乳液聚合，聚合反应过程只有两个阶段，即加速期和减速期，不存在恒速期。加入CMC—A9高分子表面活性剂，可以在较短的时间内和较低的超声功率下达到较高的单体转化率。     

Increasing the service properties of weld joints by electrohydroimpulse treatment

Known examples of the positive influence of electrohydroimpulse treatment on the quality of weld joints of various steels, particularly including an increase in their long-term and cyclic strength and also corrosion resistance, are analyzed. It is shown that in this case there is a reduction in residual macro- and micro-stresses and also a change in the parameters of the dislocation structure of the joint metal in the direction of stabilization of it.Translated from Problemy Prochnosti, No. 4, pp. 119–123, April, 1996.     

Influence of the quality of the heterointerface on the cyclotron resonance spectra of InAs/(AlGa)Sb heterostructures

Cyclotron resonance is measured in solitary type-II InAs-AlGaSb quantum wells grown by molecular-beam epitaxy under various growth conditions. Quantum oscillations observed in the cyclotron resonance spectra in InAs-GaSb samples are attributed to scattering by a short-range potential due to roughness of the heterointerface. A new method based on measurement of the cyclotron resonance spectra is proposed for assessing the quality of the heterointerface. Fiz. Tekh. Poluprovodn. 31, 1246–1248 (October 1997)     

Unicast-based multicast communication in wormhole-routed networks

Multicast communication, in which the same message is delivered from a source node to an arbitrary number of destination nodes, is being increasingly demanded in parallel computing. System supported multicast services can potentially offer improved performance, increased functionality, and simplified programming, and may in turn be used to support various higher-level operations for data movement and global process control. This paper presents efficient algorithms to implement multicast communication in wormhole-routed direct networks, in the absence of hardware multicast support, by exploiting the properties of the switching technology. Minimum-time multicast algorithms are presented for n-dimensional meshes and hypercubes that use deterministic, dimension-ordered routing of unicast messages. Both algorithms can deliver a multicast message to m-1 destinations in [log ₂ m] message passing steps, while avoiding contention among the constituent unicast messages. Performance results of implementations on a 64-node nCUBE-2 hypercube and a 168-node Symult 2010 2-D mesh are given     

液相颗粒包裹法制备PbNb2O6微粉的研究

本文介绍了一种采用液相颗粒包裹技术制备功能陶瓷微粉的新方法.这种方法有如下特点:(1)方法简便,不需要特殊的设备,便于扩大应用于工业生产;(2)粉体颗粒尺寸小而均匀;(3)粉体化学组成偏离小、且均匀;(4)适应性强,从双组分至十多组分的材料微粉制备均可采用;(5)特别适用于一些含有难溶组分、用液相法无法制备的材料.本工作采用这一方法,成功地制备出 PbNb_2O_6微粉,其平均腰粒尺寸<0.5μm,分散性及化学均匀性好,烧结活性高,烧结温度可以降低近100℃,瓷坯密度可达理论密度的96%以上.