Deposition and Properties of Superconducting MgB2 Thin Films

The recently discovered superconductor MgB₂ with T _c at 39 K has great potential in superconducting electronics. In this paper, we review the deposition techniques used for MgB₂ thin films in the light of a thermodynamic study of the Mg-B system with the calculation of phase diagrams (CALPHAD) modeling technique. This thermodynamic study identifies a growth window in the pressure–temperature phase diagram, in which the magnesium pressure is very high for likely in situ growth temperatures. A Hybrid Physical–Chemical Vapor Deposition (HPCVD) technique that successfully achieves such a high Mg pressure is shown to produce in situ epitaxial MgB₂ thin films with bulk superconducting properties.     

Prediction of the energy dissipation rate in ductile crack propagation

In this paper, energy dissipation rate D vs. Δa curves in ductile fracture are predicted using a ‘conversion’ between loads, load‐point displacements and crack lengths predicted by NLEFM and those found in real ELPL propagation. The NLEFM/ELPL link was recently discovered for the DCB testpiece, and we believe it applies to other cracked geometries. The predictions for D agree with experimental results. The model permits a crack tip toughness R(Δa) which rises from J_c and saturates out when (if) steady state propagation is reached after a transient stage in which all tunnelling, crack tip necking and shear lip formation is established. J_R is always greater than the crack tip R(Δa) and continues to rise even after R(Δa) levels off. The analysis is capable of predicting the usual D vs. Δa curves in the literature which have high initial values and fall monotonically to a plateau at large Δa. It also predicts that D curves for CCT testpieces should be higher than those for SENB/CT, as found in practice. The possibility that D curves at some intermediate Δa may dip to a minimum below the levelled‐off value at large Δa is predicted and confirmed by experiment. Recently reported D curves that have smaller initial D than the D‐values after extensive propagation can also be predicted. The testpiece geometry and crack tip R(Δa) conditions required to produce these different‐shaped D vs. Δa curves are established and confirmed by comparison with experiment. The energy dissipation rate D vs. Δa is not a transferable property as it depends on geometry. The material characteristic R(Δa) may be the ‘transferable property’ for scaling problems in ELPL fracture. How it can be deduced from D vs. Δa curves (and by implication, J_R vs. Δa curves) is established.     

Power moves: Complementarity in dominant and submissive nonverbal behavior.

Two studies examine complementarity (vs. mimicry) of dominant and submissive nonverbal behaviors. In the first study, participants interacted with a confederate who displayed either dominance (through postural expansion) or submission (through postural constriction). On average, participants exposed to a dominant confederate decreased their postural stance, whereas participants exposed to a submissive confederate increased their stance. Further, participants with complementing responses (dominance in response to submission and submission in response to dominance) liked their partner more and were more comfortable than those who mimicked. In the second study, complementarity and mimicry were manipulated, and complementarity resulted in more liking and comfort than mimicry. The findings speak to the likelihood of hierarchical differentiation (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Calcium Phosphate Biomaterials: An Update

1Introduction Archaeologicalfindingsdatingbacktothe4thcentury BCshowedthatmissinghumanteethhavebeenreplaced bymaterialswhichincluded:animalteeth,coral,shells,ivory(elephanttusk),wood,andmetals[1].Inmodern times,autografts(boneobtainedfromanothersiteinthe …     

Effect of spinneret hole diameter on the spinning and properties of acetate fibre

Conclusions The effect of the number and diameter of spinneret holes on hole clogging and the properties of acetate yarns has been investigated under manufacturing conditions.On reducing spinneret hole diameter and increasing the number of holes, the strength and fatigue properties are raised, but the elongation of acetate yarn is reduced.Translated from Khimicheskie Volokna, No. 1, pp. 29–30, January–February, 1986.     

Low temperature and strain rate dependence of fracture stress and fracture toughness on thin Fe40Ni40B20 amorphous ribbon

The fracture stress and the critical stress intensity factor of the Fe₄₀Ni₄₀B₂₀ amorphous metallic ribbons 20 μm thick were measured in the temperature range 4.2–300 K and at deformation rates from 3.3×10⁻⁶ to 1.25×10⁻³ m⁻¹ with the aim to obtain more information on the condition for the onset and development of the inhomogeneous plastic deformation and fracture.     

On the relationship between parity space and approaches to fault detection

Parity space approach and H₂ approach are two important fault detection approaches. This paper studies the relationship between these two approaches, which reveals frequency domain characteristics of the optimal solution of the parity space approach on the one side and provides a numerical solution of the H₂-optimal design of residual generators on the other side.     

Vortex Dynamics in Bi2Sr2CaCu2O8 Single Crystal with Low Density Columnar Defects Studied by Magnetic Force Microscope

We have studied vortex dynamics in Bi₂Sr₂CaCu₂O₈ single crystal with low density columnar defects by using a magnetic force microscope. Single crystal Bi₂Sr₂CaCu₂O₈ sample was irradiated by 1.3 GeV uranium ion to form artificial pinning centers along the crystalline c-axis. The irradiation dose corresponded to a matching field of 20 gauss. The radius of an individual vortex is approximately 140 nm, which is close to the penetration depth of this material. Magnetic force microscope (MFM) images show that intrinsic crystalline defects such as stacking fault dislocations are very effective pinning centers for vortices in addition to the pinning centers due to ion bombardment. By counting the number of vortex, we found that the flux trapped at each pinning center is a single flux quantum. At higher magnetic field, the vortex structure showed an Abrikosov lattice disturbed only by immobile vortices located at pinning centers. When increasing or decreasing the external magnetic field, the spatial distribution of vortices showed a Bean model like behavior.