全文获取类型
收费全文 | 532篇 |
免费 | 68篇 |
国内免费 | 13篇 |
专业分类
电工技术 | 53篇 |
综合类 | 31篇 |
化学工业 | 49篇 |
金属工艺 | 31篇 |
机械仪表 | 46篇 |
建筑科学 | 57篇 |
矿业工程 | 34篇 |
能源动力 | 13篇 |
轻工业 | 47篇 |
水利工程 | 29篇 |
石油天然气 | 29篇 |
武器工业 | 8篇 |
无线电 | 35篇 |
一般工业技术 | 36篇 |
冶金工业 | 50篇 |
原子能技术 | 1篇 |
自动化技术 | 64篇 |
出版年
2024年 | 11篇 |
2023年 | 33篇 |
2022年 | 34篇 |
2021年 | 34篇 |
2020年 | 29篇 |
2019年 | 39篇 |
2018年 | 36篇 |
2017年 | 17篇 |
2016年 | 24篇 |
2015年 | 33篇 |
2014年 | 42篇 |
2013年 | 30篇 |
2012年 | 39篇 |
2011年 | 29篇 |
2010年 | 29篇 |
2009年 | 32篇 |
2008年 | 23篇 |
2007年 | 16篇 |
2006年 | 19篇 |
2005年 | 11篇 |
2004年 | 7篇 |
2003年 | 12篇 |
2002年 | 7篇 |
2001年 | 7篇 |
2000年 | 10篇 |
1999年 | 5篇 |
1998年 | 1篇 |
1995年 | 1篇 |
1994年 | 1篇 |
1991年 | 1篇 |
1983年 | 1篇 |
排序方式: 共有613条查询结果,搜索用时 15 毫秒
71.
72.
73.
线性调频信号主瓣不展宽旁瓣抑制方法 总被引:1,自引:0,他引:1
以汉明窗为代表的加权方法在抑制线性调频信号的匹配滤波输出峰值旁瓣的同时展宽主瓣,致使距离分辨力下降。为兼顾旁瓣抑制和高距离分辨力的需求,该文提出一种新的主瓣不展宽旁瓣抑制方法。该方法首先将匹配滤波和加权处理的输出幅度进行归一化处理,然后逐点进行比较,再取各点对应的最小值作为最终的输出数据。该方法兼取了匹配滤波和加权处理的优点,其-3 dB主瓣展宽系数与匹配滤波相比仅为1,而旁瓣抑制性能和对应的加权处理相当。仿真结果和湖上试验验证了该方法的有效性。 相似文献
74.
针对双层管柱损伤检测方向识别能力差的问题,提出了基于偏心阵列的油气井双层管柱损伤检测方法.在井下瞬变电磁信号模型基础上,推导了偏心探头在双层管柱结构中的瞬变电磁响应.此外,结合双层管柱无损检测原理,利用Comsol仿真分析了基于偏心探头的双层管柱损伤检测方法.仿真结果表明偏心探头可以获得更多偏心方向上的敏感信息,使用多... 相似文献
75.
正A fully integrated multi-mode multi-band directed-conversion radio frequency(RF) receiver front-end for a TD-SCDMA/LTE/LTE-advanced is presented.The front-end employs direct-conversion design,and consists of two differential tunable low noise amplifiers(LNA),a quadrature mixer,and two intermediate frequency(IF) amplifiers.The two independent tunable LNAs are used to cover all the four frequency bands,achieving sufficient low noise and high gain performance with low power consumption.Switched capacitor arrays perform a resonant frequency point calibration for the LNAs.The two LNAs are combined at the driver stage of the mixer,which employs a folded double balanced Gilbert structure,and utilizes PMOS transistors as local oscillator(LO) switches to reduce flicker noise.The front-end has three gain modes to obtain a higher dynamic range.Frequency band selection and mode of configuration is realized by an on-chip serial peripheral interface(SPI) module.The frontend is fabricated in a TSMC 0.18-μm RF CMOS process and occupies an area of 1.3 mm~2.The measured doublesideband (DSB) noise figure is below 3.5 dB and the conversion gain is over 43 dB at all of the frequency bands. The total current consumption is 31 mA from a 1.8-V supply. 相似文献
76.
正A radio frequency(RF) receiver frontend for single-carrier ultra-wideband(SC-UWB) is presented. The front end employs direct-conversion architecture,and consists of a differential low noise amplifier(LNA),a quadrature mixer,and two intermediate frequency(IF) amplifiers.The proposed LNA employs source inductively degenerated topology.First,the expression of input impedance matching bandwidth in terms of gate-source capacitance, resonant frequency and target S_(11) is given.Then,a noise figure optimization strategy under gain and power constraints is proposed,with consideration of the integrated gate inductor,the bond-wire inductance,and its variation.The LNA utilizes two stages with different resonant frequencies to acquire flat gain over the 7.1-8.1 GHz frequency band,and has two gain modes to obtain a higher receiver dynamic range.The mixer uses a double balanced Gilbert structure.The front end is fabricated in a TSMC 0.18-/im RF CMOS process and occupies an area of 1.43 mm~2.In high and low gain modes,the measured maximum conversion gain are 42 dB and 22 dB,input 1 dB compression points are -40 dBm and -20 dBm,and S_(11) is better than -18 dB and -14.5 dB.The 3 dB IF bandwidth is more than 500 MHz.The double sideband noise figure is 4.7 dB in high gain mode.The total power consumption is 65 mW from a 1.8 V supply. 相似文献
78.
混凝土质量的好坏,既对结构物的安全,也对结构物的造价有很大影响,因此在施工中我们必须对混凝土的施工质量有足够的重视。 相似文献
79.
80.
AU6842芯片是一款数字音频soc芯片,其中集成了USB主机控制器,可以用单芯片实现USB数字音频模块.利用该芯片设计的USB数字音频模块通过标准串行口同音响主控制器通信,处理音响主控制器发出的操作命令,实现从USB存储设备中读取并播放MP3文件.本文将介绍USB数字音频模块的结构和各个子模块的功能:针对USB音频模块功能分析AU6842各个功能模块的技术参数,提供USB音频模块的硬件电路设计;描述该模块控制软件的通信协议和模 块的工作状态. 相似文献