烧结工艺对β-氮化硅陶瓷的影响

以β-Si3N4粉末为原料,以YAG（钇铝石榴石）为烧结助剂,通过气氛压力烧结（GPS）制备出致密的β-氮化硅陶瓷材料,形成大小均匀的柱状颗粒和小球状颗粒复合显微结构,研究了烧结助剂质量分数、烧结温度以及保温时间对β-氮化硅陶瓷致密化程度及力学性能的影响.     

精炼岗位再生气回收工艺的改进

通过对再生气回收工艺的改进,提高稀氨水的浓度,便于碳化岗位吸收利用,降低二次净氨塔的压力,达到工艺指标。     

The mechanical property and phase structures of wheat proteins/polyvinyl alcohol blends studied by high-resolution solid-state NMR

The phase structures of thermally processed wheat proteins (WP) and polyvinyl alcohol (PVOH) blends were studied by solid-state high-resolution NMR spectroscopy. The intermolecular interactions among the multi-component systems and the behavior of each component in the blends on scales of nanometers were examined. The mechanical properties of the blends were also measured and related to the phase structure studies. The results indicated that the polymer chains of WP could be homogeneously mobilized when thermally processed with glycerol and water as plasticisers, but the glycerol predominately associated with WP rather than PVOH in the blends. The intermolecular hydrogen bonding interactions between WP and PVOH caused some extent of miscibility in the system on scales of nanometers especially when the PVOH content was low. The tensile strength and modulus of the blends were improved as compared to WP. However, the intermolecular interactions were relatively weak and could not be further enhanced by increasing PVOH component in the blends. The particle miscible WP/PVOH blends contained plasticised WP and PVOH phases in conjunction with the miscible WP/PVOH phase. Increasing the PVOH content in the blends did not result in an increase of the percentage of the miscible phase and the blends tented to be immiscible while the elongation of the blends was reduced when increasing the PVOH content in the blends.     

甲基丙烯酸甲酯（MMA）生产中水解和酯化反应特性的研究

用间歇式搅拌反应器，对丙酮氰醇（ＨＣＮ）法甲基丙烯酸甲酯生产中水解和酯化反应的特性进行了研究。研究表明：（１）甲基丙烯酰胺硫酸盐的水解反应有较高的平衡转化率，其动力学方程为ｋ１＝６．５２×１０＾６ｅｘｐ（－６９．８／ＲＴ）；（２）甲基丙烯酸与甲醇间酯化反应的平衡转化率较低，故生产中必须加以提高。测得的液相和汽－液相酯化反应的活化能分别为４９．４ｋＪ／ｍｏｌ和５４．４ｋＪ／ｍｏｌ。     

硅基纳米b-SiC量子点列阵的制备

报道了用两步自组装法制备硅基纳米碳化硅量子点列阵. 先将两种硅烷偶联剂均匀有序地偶联到洁净的单晶硅片上，其中一种偶联剂能打破C60上的碳碳双键而使C60通过偶联剂均匀有序地分布在硅片的表面上. 然后用夹心法或覆盖法将样品在900℃的氮气氛中退火20 min，使C60分解成活性碳，与周围的硅原子结合生成碳化硅，碳化硅分子的自组装形成了碳化硅纳米晶粒(量子点)，C60在硅表面的有序排列导致了纳米碳化硅量子点列阵形成.     

基于一次投影子空间追踪的压缩感知信号重构

为了降低信号重构算法的复杂度,实现对稀疏度未知信号的重构,提出了一种基于一次投影子空间追踪(OPSP)的信号重构方法。首先根据约束等距性质确定信号稀疏度的上下界,并将最接近上下界中值的整数作为稀疏度的估计值;然后在子空间追踪(SP)算法的框架下,去掉了迭代中观测向量在支撑集上的投影过程,降低了算法的复杂度。为了更准确地衡量算法的重构性能,提出用完整信号的重构概率作为衡量算法重构性能的指标。与传统的SP算法相比,所提算法可以重构稀疏度未知的信号,且重构时间短,重构概率高。仿真结果验证了该算法的有效性。     

聚甲基丙烯酸甲酯／纳米SiO2复合粒子的制备与表征

采用甲基丙烯酸-3-甲氧基硅丙酯（MPs）对分散于甲基丙烯酸甲酯（MMA）中的纳米SiO2粒子进行偶联改性，得到了表面改性的纳米SiO2单体分散液，用原位悬浮聚合方法制备了不同SiO2含量的PMMA／纳米SiO2复合粒子。通过红外光谱、透射电镜、差示扫描量热分析和热重分析等方法对制备的纳米复合粒子进行了表征，结果表明，纳米SiO2粒子在PMMA中分散良好；MMA可通过与MPS的共聚而有效地接枝到SiO2粒子表面，当SiO2含量为6．6％（质量分数，下同）、MPS用量为0．06g／gSiO2时，其接枝率可达73．8％；同时，纳米SiO2的引入可提高PMMA的耐热性能，当Si02含量为14.7％时，其玻璃化转变温度和最大热分解速率时的温度分别提高了11．8℃和18．8℃。     

水煤浆加压气化炉用高铬耐火材料的显微结构及损毁机理

采用扫描电镜和能谱分析方法 ,分析了水煤浆加压气化炉用高铬砖渣蚀前后的显微结构和相组成 ,探讨了主要损毁机理。结果表明 :煤熔渣与砖反应和渗透引起砖组成的改变 ,从而导致砖的结构剥落和强度弱化是砖损毁的主要原因 ;LIRR -HK90砖的显微结构呈网络状镶嵌结构 ,直接结合程度高 ,与渣反应可生成 (Mg ,Fe) (Al,Cr,Fe) 2 O4 复合尖晶石致密带 ,阻止了渣的进一步渗透 ,减缓渣蚀速度和结构剥落 ,其使用效果优于进口的同类产品     

反相高效液相色谱法测定meso-四苯基卟啉钴的纯度

采用反相高效液相色谱法测定合成meso-四苯基卟啉钴的纯度;以甲醇乙腈二氯甲烷(体积比为55∶35∶10)为流动相,ShimpackCLCODS柱(150mm×6.0mmi.d,5μm)为分离柱,流速为1.5mL/min,检测波长420nm;meso四苯基卟啉钴的测定在1.0～10μg/mL时线性关系良好(相关系数r=0.9993),加标回收率为97.03%～101.42%,重复进样的相对标准偏差RSD为0.64%～2.92%(n=5)。方法的准确度高,精密度好,实际应用效果好。