变频调速技术在济钢焦化厂高压氨水泵上的应用

济钢焦化厂高压氨水泵变频调速系统采用变频器和PLC相结合的方式 ,具有调速精度高、节能等多种功能 ,保证氨水泵正常工作。全年可增加经济效益 77.3万元。     

离子束混合工艺对材料抗蚀性能的影响

本文介绍了离子束混合工艺方法。与直接注入相比较,离子束混合所使用的设备造价低1/4—1/2,而生产效率可提高1—2个数量级,因而使生产成本大幅度降低,这无疑对离子束工艺的实际应用将产生巨大的促进作用。 通过对轴承材料(GCr15和Cr4Mo4V)经Cr、N、Ta不同元素的混合处理后,在0.5M H_2SO_4和0.1M NaCl的缓冲溶液中的阳极极化曲线表明经混合处理后的两种材料试样,其抗蚀能力和抗点蚀能力均大大提高,这与直接注入的试样效果是一致的。 通过俄歇谱仪和透射电镜的分析结果表明混合是成功的,且在一定的条件下,形成非晶组织。 本文的结论是,无论是离子的直接注入还是离子束混合,对提高轴承材料的抗腐蚀性能都是有效的方法,特别是离子束混合技术具有更大的应用前景。     

低发射率材料红外法向发射率谱测量方法的研究

采用热管技术研制了材料发射率谱的专用测量附件;利用双温测量技术,在P-E983型红外分光光度计及3600型数据站上进行了较低温度下低发射率材料红外法向发射率谱测量方法的研究.实测了几种材料的发射率谱;讨论了影响测量误差的诸因素.     

Effect of Preparation Methods and Condition of Precursors on the Phase Composition of Yttria-Stabilized Zirconia Powders

An yttria-stabilized zirconia powder, free of monoclinic phase, may be prepared by an oxalate method in an ethanol solution at strong acidity. This study demonstrates that the control of pH in the preparation of precursors has a significant effect on the ability of precursors to crystallize and hence plays an important role in determining the formation and fraction of various crystalline phases in the resulting yttria-stabilized zirconia powder. With the increase of pH, a precursor with a certain crystalline form may be transformed into an amorphous precursor, and a monoclinic phase appers in the phase composition of the resulting powder. The results of XRD analysis and Raman spectroscopy are discussed.     

Probabilistic analysis of uncertainties in seismic hazard assessment

Sources and current methods of analysis of uncertainty from randomness, fuzziness and ignorance or incomplete knowledge in seismic hazard assessment problem are briefly discussed at beginning; understandings of the authors are then presented in the following order. All three types of uncertainty come from incomplete knowledge. Probabilistic method can be applied to all of them, objective probability for random factors and subjective probability for the other two types of uncertain factors. Discrete subjective probability mass functions for incomplete and fuzzy factors can be obtained from logic-tree and membership functions respectively. Fractile curves may be used to show the scattering of any uncertainty factor, but a unified probabilistic treatment may be applied to any combination of all three types of uncertainty.     

山西铝厂锅炉水冷壁膨胀异常原因分析及对策

针对山西铝厂160t／h锅炉在实际运行中膨胀异常的问题，对不同的施工方法下，水冷壁膨胀量是否正常这一问题进行分析，找出了水冷壁膨胀异常的原因，并提出了解决对策。     

Effect of precyclic loading on stress-corrosion-cracking initiation in an X-65 pipeline steel exposed to near-neutral pH soil environment

A study was carried out to understand the effect of precyclic loading on stress-corrosion-crack initiation in an X-65 pipeline steel exposed to a near-neutral-pH soil environment. The test specimens were precyclically loaded before corrosion exposure to represent a service history of up to about 20 years, depending on the severity of pressure fluctuation. Microcracks had initiated on the polished surface of the X-65 pipeline steel after long-time exposure at open-circuit potential (OCP) in a near-neutral-pH synthetic soil solution. These microcracks were mostly initiated from pits at metallurgical discontinuities such as grain boundaries, pearlitic colonies, and banded phases in the steel. Strong preferential dissolution was observed along planes of the banded structures in the steel. The selective corrosion attack at these metallurgical discontinuities is attributed to the galvanic nature of those areas to their neighbors. Cyclic loading prior to corrosion exposure had significant effects on microcrack initiation and propagation during subsequent corrosion exposure. Cyclic loading prior to corrosion exposure either reduced or increased the probability of crack initiation and the rate of crack propagation, depending upon the magnitude of the stress cycles. The largest reduction was seen at a peak cyclic stress of about 0.8 of the yield strength. This cyclic-loading-dependent cracking behavior might be related to the alteration of the substructures and the residual stress in the steel as a result of precyclic loading.     

松辽南部早白垩世断陷期沉积相与成岩相

松辽南部早白垩世断陷期地层地震相分析显示,该时期冲积扇、三角洲、水下扇及扇三角洲沉积体系十分发育,是深部油(气)聚集的有利场所。登娄库组可分出:浅埋弱压实成岩相、晚表生溶蚀成岩相、深埋溶蚀成岩相、深埋压溶成岩相,以前二者为油气聚集的有利成岩相。     

某地下室深井渗漏的治理

分析了上海兰心影剧院地下室深井修建后出现渗漏的原因，介绍了堵漏工程采用的防水材料和施工方法。     

降低精炼钢中氢氧含量的探索

主要介绍通过优化炼钢生产工艺,使产品满足新的技术要求:S≤0.010％,P≤0.015％.[H]≤0.0002％,[O]≤0.0045％,[N]≤0.0055％。