Consolidation of sand formation using freon'll gas hydrate

Freon 11 gas hydrate was used to block the pores of four size ranges of sand from 24 mesh to 60 mesh. A 50.8 mm deep bed of sand when thus “frozen” with hydrate could sustain a dfferential water pressure of at least 6895 kPa. A subcooling of about 5 to 6°C below its thermodynamic formation temperature was required to cause the hydrate to form such a plug. Once formed, the hydrate remained stable at temperatures up to its decomposition temperature. The time required for the hydrate crystal to grow to a size large enough to block the pores of the bed was about two hours. The amount of hydrate forming agent required to block the sand pores was found to be approximately that calculated from the ideal composition of the hydrate.     

高效防腐中温磷化液LC-1的制备及性能

制备了一种含Zn2+、Mn2+、N i2+三系离子的LC-1磷化液,通过硫酸铜点滴、氯化钠浸蚀、SEM等手段对磷化膜进行了测试,测定了磷化温度、磷化时间对膜层耐蚀性的影响。结果表明,在磷化温度大于65℃,磷化时间大于10 m in的条件下,所形成的磷化膜结晶均匀、致密、黑褐色,耐蚀性良好。LC-1三系磷化液可适用于大批量钢铁工件的磷化生产。     

乙环唑的合成研究

介绍了以2,4-二氯苯乙酮为原料通过催化溴化、缩合反应、与三氮唑钠反应制得原药,原药含量达到92%以上.并对合成条件进行了研究,取得了较为满意的结果.     

庙宇平坝防洪治理方案研究

庙宇平坝地处大溪河右岸支流庙宇沟上游山间盆地内,仅靠一条人工开凿的排洪洞和天然消坑排泄洪水,过流能力不足致使每年都遭受洪涝灾害。根据庙宇平坝地形条件及防洪现状,复核现有排洪设施泄流能力,分析存在的问题,结合庙宇平坝地形条件及区内实际情况,采取整个消水洞的扩建及进口前100 m的河道支护,从而提高泄洪能力,降低庙宇平坝水位,有效减少洪水淹没历时及淹没深度。     

电石渣在环氧丙烷生产中的循环利用

总结了电石渣生产环氧丙烷工艺中的设计与应用。运行情况表明，该工艺具有明显的经济效益和社会效益。     

Phase Assemblages of Pr α-sialon Derived from SHS-ed Powders and TEM Study on the Nucleation of Pr α-sialon

The Pr α-sialon powders prepared by self-propagating high-temperature synthesis (SHS), consisting of 55 wt% Pr α-sialon and 45 wt% of β-sialon (abbreviated as α' and β'), were hot-pressed at 1800°C for 1 h. The results showed that Pr α' phase would transfer to β' with the appearance of JEM phase (Pr(Si_{6− z} Al _z )(N_{10− z} O _z )) after sintering, thus resulting in the increase of β' phase to 86 wt%. The addition of Y₂O₃ into SHS-ed Pr α' powders as the starting materials restrains the transformation of α' to β' and prevents the formation of JEM phase as well. The nucleation mechanism of Pr α' grain during hot-pressing was investigated in terms of transmission electron microscope and energy-dispersive spectrometer analysis. Two nucleation modes of Pr α' grains were found, i.e., nucleating on the undissolved Pr α' grains and on the nuclei of (Pr, Y) α' grains precipitated from liquid phase.     

粉末材料合成金刚石中工艺参数的选取

合理地选取工艺参数,有利于合成优质金刚石.文章综述了粉末材料合成金刚石中工艺参数对合成效果的影响以及粉末材料合成金刚石中工艺参数的选取原则.     

以人为本的儿童医院候诊设施及服务系统的构建原则初探——以无锡儿童医院输液候诊区为例

旅游发展既促进了江南水乡传统建筑景观的保护,又对其产生了消极影响。旅游的消极影响表现在旅游容量对水乡建筑环境的压力,旅游的商业化、低俗化对建文章从以人为本(HCD)的设计理念出发,结合服务设计中接触点的分析方法,以无锡儿童医院输液候诊区为例,进行服务流程失败点的分析。提出以设计介入儿童医院候诊设施及服务系统构建的四大原则,旨在提升国内儿童医院候诊效率和服务水平,为新医疗服务模式提供案例参考。     

试谈计算机软件测试管理的应用

计算机的软件测试是软件工程构成部分之一,同时软件测试也是检验软件开发人员及软件产品是否合格的重要凭据。就软件测试管理系统活动及应用两个方面的内容进行研究,并对管理工具的存在进行简单的介绍。     

Integrated size and topology optimization of skeletal structures with exact frequency constraints

The present paper studies the integrated size and topology optimization of skeletal structures under natural frequency constraints. It is found that, unlike the conventional compliance-oriented topology optimization problems, the considered problem may be strongly singular in the sense that the corresponding feasible domain may be disconnected and the global optimal solutions are often located at the tips of some separated low dimensional sub-domains when the cross-sectional areas of the structural components are used as design variables. As in the case of stress-constrained topology optimization, this unpleasant behavior may prevent the gradient-based numerical optimization algorithms from finding the true optimal topologies. To overcome the difficulties posed by the strongly singular optima, some particular forms of area/moment of inertia-density interpolation schemes, which can restore the connectedness of the feasible domain, are proposed. Based on the proposed optimization model, the probability of finding the strongly singular optimum with gradient-based algorithms can be increased. Numerical examples demonstrate the effectiveness of the proposed approach.