Hydrothermal Synthesis of Acicular Lead Titanate Fine Powders

A pure, acicular lead titanate (PbTiO₃) fine powder with a white color has been prepared by hydrothermal synthesis. It is a new phase of PbTiO₃ with I 4 symmetry, cell parameters of a = 12.358 Å and b = 14.541 Å, and a density of 6.80 g.cm⁻³. The influences of pH (12.5 to 14.4), Pb/Ti ratio (1.0 to 1.6) in the feedstock, reaction temperature (130° to 230°C), time (0.25 to 4 h), starting materials, and additives on the formation of acicular PbTiO₃ under hydrothermal conditions have been investigated. The acicular PbTiO₃ with I 4 symmetry, referred to as the PX phase, can be converted to the perovskite-type (PE phase) of PbTiO₃ at about 605°C while its acicular morphology is essentially unchanged. The preferable conditions for preparing pure acicular PX-phase PbTiO₃ are that the pH is 13.0 to 14.0, Pb/Ti ratio is >1.3, reaction temperature is 170° to 200°C, time is 0.5 to 1.0 h, titanium butoxide (Ti[O(CH₂)₃CH₃]₄) is the starting material, and poly(vinyl alcohol) is an additive. The acicular grain of the PX phase is usually less than 100 nm in diameter and more than 1000 nm in length.     

单相电焊机计量异常分析

针对单相电焊机采用单相感应式电能表进行计量中出现的圆盘反转现象 ,从理论和试验 2个方面分析和验证了 :由于单相电焊机本身的特点 ,无论它在负载还是空载状态 ,总会有 1块电能表出现圆盘反转 ,这是正常的     

Dipole radiation in the proximity of a chiral slab

Radiation of an electric dipole located along an arbitrary direction in the presence of a chiral slab is formulated using matrix analysis in conjunction with Fourier transform techniques. Moreover, dyadic Green's function of such a structure may be determined for further investigation porpose.     

济钢中板厂加快技术创新的对策

本文通过对中板厂近年来技术改造后工艺装置和技术水平的分析，并结合中国加入WTO后对中国钢铁企业面临全球化市场竞争严峻性的认识，提出了中板厂在实现高产生产模式后，应加快技术创新的步伐，尽快完成由高产向优质、多品种、低消耗的高效化生产模式转化的主导思想、措施及建议。     

我国小水电技术发展路线的探讨

根据国际小水电技术发展新动向以及国内政治、政策和市场化经济新发展等情况，讨论确定小水电技术发展路线的原则，提出技术路线的框架和重点，供决策部门参考。表1个。     

Patient thermal comfort requirement for hospital environments in Taiwan

This study examines the comfort criteria of ASHRAE Standard 55-2004 for their applicability in hospital environments. Through an extensive field survey conducted in a university hospital in Taiwan, 927 sets of data have been collected. Above half of the measured samples failed to meet the specifications of Standard 55 comfort zone due to improper humidity control. Acceptability votes by patients exceeded the Standard's 80% criterion, regardless of whether the physical conditions were in or out of the comfort zone. Thermal neutrality, preference and comfort range are compared with other studies conducted in office environments and Standard 55 criteria. Results of chi-square tests revealed that patients’ physical strength significantly effected their thermal requirements. The net effect of health yields a marked difference in thermal neutrality and preference, and also in the comfortable temperature range.     

Highly active lanthanum doped nickel anode for solid oxide fuel cells directly fuelled with methane

Lanthanum doped nickel and YSZ composite anode (LaNi–YSZ) exhibited a greatly reduced polarization resistance and high performance for electrochemical oxidation of hydrogen and methane, which resulted from a fine anode structure with a high dispersion of nickel catalyst and a high catalytic activity towards methane.     

SNCP环带链的组网与维护

在实际传输网络结构中,有些站点由于条件限制不能与其它站点连接成环.过去采用通道保护(PP)环带链组网,环链网元间业务在环上没有保护;随着技术的发展,提出了子网连接保护(SNCP)环带链组网方式,确保环链网元间业务在环上得到保护,使网络的稳定性和可靠性大大提高.     

Ni-Mo-O催化剂中协同作用对丙烷氧化脱氢的影响

在 Ni-Mo-O体系中 ,加入 Mo O3 能极大地提高丙烷氧化脱氢制丙烯的反应活性。选用固混法、沉淀法、柠檬酸法制备了 Mo O3 过量 1 5 % (摩尔分数 )的α -Ni Mo O4催化剂 ,其中用沉淀法制得催化剂在 5 0 0℃ ,V( C3 H8) /V ( O2 ) /V ( N2 ) =1 0 /1 0 /5 0 ,反应气流量为 70 m L/min的条件下丙烷转化率可达 38.7% ,丙烯选择性达 70 .1 4 %。经 XRD,XPS,TPR表征说明 ,在含有过量 Mo O3 的催化剂中 ,α -Ni Mo O4与 Mo O3 两种晶体之间可产生微小的相互吸引 ;从而发挥协同作用 ,是提高催化剂活性     

油田放射性作业人员外周血淋巴细胞染色体畸变的观察

本文调查了油田212例受γ射线和中子混合辐射照射的作业人员和30例正常人的外周血淋巴细胞染色体畸变。作业人员受γ射线照射的人均年受照剂量为1.28mGy。调查结果表明,放射性测井人员与正常人相比染色体畸变率有显著差异。