Building blocks for a two-frequency laser lidar-radar: a preliminary study

A new principle of lidar-radar is theoretically and experimentally investigated. The proposed architecture is based on the use of an rf modulation of the emitted light beam and a direct detection of the backscattered intensity. Use of a radar-processing chain allows one to obtain range and Doppler measurements with the advantages of lidar spatial resolution. We calculate the maximum range of this device, taking into account different possible improvements. In particular, we show that use of a pulsed two-frequency laser and a spatially multimode optical preamplification of the backscattered light leads to calculated ranges larger than 20 km, including the possibility of both range and Doppler measurements. The building blocks of this lidar-radar are tested experimentally: The radar processing of an rf-modulated backscattered cw laser beam is demonstrated at 532 nm, illustrating the Doppler and identification capabilities of the system. In addition, signal-to-noise ratio improvement by optical pre-amplification is demonstrated at 1.06 microm. Finally, a two-frequency passively Q-switched Nd:YAG laser is developed. This laser then permits two-frequency pulses with tunable pulse duration (from 18 to 240 ns) and beat frequency (from 0 to 2.65 GHz) to be obtained.     

Off-axis measurements of atmospheric trace gases by use of an airborne ultraviolet-visible spectrometer

An airborne UV-visible spectrometer, the Gas Analyzer Spectrometer Correlating Optical Differences, airborne version (GASCOD/A4pi) was successfully operated during the Airborne Polar Experiment, Geophysica Aircraft in Antarctica airborne campaign from Ushuaia (54 degrees 49' S, 68 degrees 18' W), Argentina in southern spring 1999. The instrument measured scattered solar radiation through three optical windows with a narrow field of view (FOV), one from the zenith, two from the horizontal, as well as actinic fluxes through 2pi FOV radiometric heads. Only a few airborne measurements of scattered solar radiation at different angles from the zenith are available in the literature. With our configuration we attempted to obtain the average line-of-sight concentrations of detectable trace gases. The retrieval method, based on differential optical absorption spectroscopy, is described and results for ozone are shown and compared with measurements from an in situ instrument as the first method of validation.     

Amplitude and phase recovery of rotationally symmetric beams

Two methods are presented for the amplitude and phase recovery of optical beams with rotational symmetry. These are the tomographic method based on the ambiguity function and the one-step wavefront recovery based on the measurement of a phase-space distribution closely related to the Wigner distribution function. The results obtained from these two methods are compared, and the appropriateness of using either one of them for specific situations is discussed.     

Effect of suspended particulate-size distribution on the backscattering ratio in the remote sensing of seawater

Mie theory is used to study the influence of the particle-size distribution (PSD) on the backscattering ratio for case 1 and 2 waters. Several in situ measured PSDs from coastal water and the open ocean, representing typical case 2 and 1 waters, were used in this investigation. Calculation of the backscattering ratio requires integration of the PSD over a much broader size range than is usually measured. Consequently extrapolation from fitted data is necessary. To that purpose the measured data are fitted with hyperbolic (Junge) and the two-component model of the PSD. It is shown that the result of extrapolation, hence the backscattering ratio, critically depends on the chosen PSD model. For a particular PSD model the role of submicrometer particles and the applied integration limits on the backscattering ratio is discussed. The use of the hyperbolic PSD model largely overestimates the number of small (submicrometer) particles that significantly contribute to backscattering and consequently leads to an erroneously high backscattering ratio. The two-component model proves to be an adequate PSD model for use in backscattering/scattering calculations providing satisfactory results complying with experimental data. The results are relevant for the inversion of remotely sensed data and the prediction of optical properties and the concentration of phytoplankton pigments, suspended sediment, and yellow substance.     

Relaxed alignment tolerance of monolithic ring lasers

An investigation of relaxed alignment tolerance in monolithic ring lasers is presented. It was found that the relaxed alignment tolerance is strongly dependent on the out-of-plane angle. A preferred region for the out-of-plane angle is proposed. In this region the resonator has greatly relaxed alignment tolerances, and the unidirectional operation can be obtained under a much-lower magnetic field. Two lasers have been constructed in the region, and satisfactory performance was found, in good agreement with the theoretical analysis.     

Tunable green laser source based on frequency mixing of pump and laser radiation from a Nd:YVO4 crystal operating at 1342 nm with an intracavity KTP crystal

We report on cw tunable green laser light generation from a Nd:YVO4 laser operating at 1342 nm. Visible radiation was produced by a frequency mixing of pump and laser radiation inside an intracavity KTP crystal. When Nd:YVO4 was diode pumped, green laser was tunable from 503 to 505 nm. The green tuning range increases up to 22 nm when a Ti:sapphire laser is used as the pump source. In nonoptimal conditions, and for a pump power of 650 mW, green power was above 3 mW and close to 0.1 mW for Ti:sapphire and diode pumping, respectively.     

Resolution improvement in two-photon fluorescence microscopy with a single-mode fiber

The dependence of spectral broadening of an ultrashort-pulsed laser beam on the fiber length and the illumination power is experimentally characterized in order to deliver the laser for two-photon fluorescence microscopy. It is found that not only the spectral width but also the spectral blue shift increases with the fiber length and illumination power, owing to the nonlinear response in the fiber. For an illumination power of 400 mW in a 3-m-long single-mode fiber, the spectral blue shift is as large as 15 nm. Such a spectral blue shift enhances the contribution from the short-wavelength components within the pulsed beam and leads to an improvement in resolution under two-photon excitation, whereas the efficiency of two-photon excitation is slightly reduced because of the temporal broadening of the pulsed beam. The experimental measurement of the axial response to a two-photon fluorescence polymer block confirms this feature.     

Application of the Tauc-Lorentz formulation to the interband absorption of optical coating materials

Recent progress in ellipsometry instrumentation permits precise measurement and characterization of optical coating materials in the deep-UV wavelength range. Dielectric coating materials exhibit their first electronic interband transition in this spectral range. The Tauc-Lorentz model is a powerful tool with which to parameterize interband absorption above the band edge. The application of this model for the parameterization of the optical absorption of TiO2, Ta2O5, HfO2, Al2O3, and LaF3 thin-film materials is described.     

Evaluation of crystallinity in TiO2 films with mixed structures grown on MgO (001) substrates by argon-ion beam sputtering based on infrared reflection-absorption spectra

TiO2 films with thicknesses (d) above 15 nm were grown on optically polished surfaces of MgO (001) substrates held at 400 degrees C by sputtering a Ti target with an argon-ion beam when the partial pressure of O2 was kept at 1.1 x 10(-2) Pa. X-ray diffraction patterns show that TiO2 films with d < 56 nm are composed of an a-axis anatase-type structure, whereas those with d > 56 nm are composed of a mixture of phases with the c-axis parallel to the film surface. The thickness dependence of the infrared reflection-absorption spectra shows that TiO2 films with d < 56 nm are composed of both anatase and amorphous phases, whereas those with d > 56 nm are composed of anatase, rutile, and amorphous phases. The crystallinity in TiO2 films is also evaluated from the infrared reflection-absorption spectra by comparison of the observed and the calculated results determined from the dielectric function of anisotropic TiO2 bulk single crystal.     

Tuneable Heterodyne Infrared Spectrometer for atmospheric and astronomical studies

The transportable setup of the Cologne Tuneable Heterodyne Infrared Spectrometer (THIS) is presented. Frequency tuneability over a wide range provided by the use of tuneable diode lasers as local oscillators (LO) allows a variety of molecules in the mid-infrared to be observed. Longtime integration, which is essential for astronomical observations, is possible owing to tight frequency control of the LO with optical feedback from an external cavity. THIS is developed to fly on the Stratospheric Observatory for Infrared Astronomy beginning in 2006 but can also be used on different types of ground-based telescopes.