Ionothermal synthesis of a three-dimensional zinc phosphate with DFT topology using unstable deep-eutectic solvent as template-delivery agent

A three-dimensional zinc phosphate compound with DFT topology, designated as ZnPO₄-EU1, has been synthesized by an ionothermal approach from the system HF-ZnO–P₂O₅-choline chloride-imidazolidone. Ethylenediamine, derived from decomposition of the imidazolidone component of the deep-eutectic solvent (DES) itself, is delivered to the synthesis and serves as an appropriate template for ZnPO₄-EU1. Experiments in which the synthesis conditions were varied showed that ZnPO₄-EU1 may be prepared over a wide molar ratio of P/Zn = 0.55–13.0. Powder X-ray diffraction patterns have been obtained at intervals to track the crystallization process of this material. The experimental data show that Zn₃(PO₄)₂ · 4H₂O (a dense phase) was first isolated from the DES after reaction for 1 h. Subsequently, the pure phase of ZnPO₄-EU1 was obtained with increasing crystallization time from 12 h to 72 h. The experimental results show that the nucleation and crystallization take place with relatively low levels of solvent degradation, demonstrating that zinc phosphate with a three-dimensional framework can be synthesized by in situ generation of an appropriate template using an unstable DES at high temperatures (150–200 °C).     

Polyetherimide substrates for future high density optical data storage

Polyetherimide (PEI) substrate for next‐generation high density optical data storage is fabricated and characterized. Cover‐layer incident or first‐surface recording configurations do not require optical properties of the substrate, which are the prerequisite conditions for the conventional material of polycarbonate (PC). Instead of the optical properties, good mechanical properties with a sufficient transcribability are required. Even though PEI has higher glass transition temperature than that of PC, a microscopic transcribability of PEI is comparable with PC by laminating a thermal insulation layer on the backside of a stamper to retard the heat flow. A macroscopic warpage of PEI substrate is smaller than that of PC substrates, which reduces tilt and servo burden. The lowest critical speed coupled with the flutter of PEI substrate is larger than that of PC substrate because of the mechanical properties of PEI. POLYM. ENG. SCI., 48:97–101, 2008. © 2007 Society of Plastics Engineers     

风管摩擦阻力的直接计算方法

提出用高精度的反映密度、黏度和温度关系的经验公式和Colebrook公式计算风管摩擦阻力系数的方法。分析和算例表明，用该方法计算，计算结果比采用常用工程设计方法更为准确，为应用计算机进行风道设计提供了直接、简便的方法。     

Novel tiO2 nanocatalysts for wastewater purification: tapping energy from the sun.

Water treatment using TiO2 semiconductor as a durable heterogeneous photocatalyst has been the focus of environmentalists in recent years. Currently, we developed an inexpensive and highly efficient approach for synthesizing nitrogen-doped TiO2 with lower band-gap energy that can respond to visible light. Doping on the molecular scale led to an enhanced nitrogen concentration of up to 21.8%. Reflectance measurements showed the synthesized N-doped TiO2 nanoparticles are catalytically active with the absorbance that extends into the visible region up to 600 nm. The water purification potential of this new class of compound was evaluated by studying the photodegradation of Acid Orange 7 (AO7) and E. coli. Experiments were conducted to compare the photocatalytic activities of N-doped TiO2 nanocatalysts and commercially available Degussa P25 power under identical solar light exposure. N-doped TiO2 demonstrated superior photocatalytic activities in both chemical compound degradation and bactericidal reactions. The result of this study shows the potential of applying new generations of catalyst for wastewater purification and disinfection.     

Modeling wireless fading channels via stochastic differential equations: identification and estimation based on noisy measurements

This paper is concerned with modeling and identification of wireless channels using noisy measurements. The models employed are governed by stochastic differential equations (SDEs) in state space form, while the identification method is based on the expectation-maximization (EM) algorithm and Kalman filtering. The algorithm is tested against real channel measurements. The results presented include state space models for the channels, estimates of inphase and quadrature components, and estimates of the corresponding Doppler power spectral densities (DPSDs), from sample noisy measurements. Based on the available measurements, it is concluded that state space models of order two are sufficient for wireless flat fading channel characterization.     

One-to-Many and Many-to-One Optical Chaos Communications Using Semiconductor Lasers

A theoretical construction of one-to-many (OTM) and many-to-one (MTO) chaos synchronization communications using semiconductor lasers is presented. One center laser provides strong injections (strong link) to other side lasers, and the side lasers also provide weak injections (weak link) to the center one. Simulation results show that the side lasers synchronize with the center laser through injection-locking. In addition, messages transmitted via the strong links or the weak links experience strong chaos pass filtering, enabling us to realize OTM and MTO communications.     

基于MoCA标准的家庭网络研究

本文描述了一种基于MOCA标准的家庭网络,并对该网络及设备进行了基本性能的测试.本文首先介绍了家庭网络的发展现状,对目前的各种家庭网络标准进行了比较.在此基础上详细描述了基于MOCA标准的家庭网络,并对该网络的设计,实现、网络性能进行了详述.然后对该网络进行了测试并得出了相关的测试结论.最后指出该网络的不足及改进之处.     

基于m法线性有限元分析在桩基计算中的应用

针对目前各类有限元软件在工程设计中的应用已相当普遍,提出了通过有限元模型解决桩基的强度验算和水平位移的计算,不仅使桩的设计变得简单,而且还可在相当的精度内考虑桩基和上部结构的共同作用。     

农村通自来水工程若干技术问题初探

根据在农村通自来水工程实践中积累的经验,提出并较好地解决了农村供水工程的评价标准,设计供水时间的确定,输配水管网设计中的优化等问题,对建好、管好和用好农村自来水工程具有一定的帮助作用.