Implicit Motor Learning in Parkinson's Disease.

Objective: This study examined whether disruption of performance is moderated in Parkinson's disease (PD) patients who acquire their motor behaviors in an implicit manner. Method: Twenty-seven patients with PD learned a hammering task in errorless (implicit) or errorful (explicit) conditions and were tested for robustness of motor performance under a secondary task load, which required them to continuously count backward as they performed the hammering task. Results: Patients in the errorless (implicit) motor learning condition exhibited robustness to secondary task loading, whereas patients in the errorful (explicit) motor learning condition did not. Conclusions: Implicit motor learning techniques should be considered by PD rehabilitation specialists in cases in which existing disruption to movements is exacerbated by conscious control. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

Evolution and structure of drying material bridges of pharmaceutical excipients: studies on a microscope slide

An experimental procedure was developed to study directly the process by which liquid bridges between small particles in a granule form and solidify. The evolution of saturated solutions of such pharmaceutical excipients as lactose and mannitol in a liquid bridge was studied on a system situated on a microscope slide. Solidification and crystallization kinetics and phase composition during and immediately following bridge formation were observed directly. It was shown that bridges on the microscope slide and in the granule behave very much the same regardless of the different length and diffusion-scales of the two systems.We found that solid bridge formation takes place in several consecutive but distinct steps. In the case of lactose, considerable shrinkage of the initial liquid bridge takes place prior to the onset of crystallization. Further bridge solidification at ambient conditions occurs via simultaneous crystallization and vitrification within minutes. As a result, a “solid” bridge usually contains both a crystalline and a non-crystalline phase, the crystalline phase being predominately α-lactose monohydrate. Most of the non-crystalline phase eventually converts to crystalline β-lactose but the process may take many hours or even days. Results for this process are compared for samples obtained from different manufacturers of commercially available lactose. In the case of mannitol, different polymorphic forms crystallize as the drying/crystallization process progresses. A formed “solid” bridge usually contains several polymorphs of mannitol. The relevance of the behavior of the two model systems (pure lactose and pure mannitol) to a real granulation and tabletting process is discussed.     

Mining constrained gradients in large databases

Many data analysis tasks can be viewed as search or mining in a multidimensional space (MDS). In such MDSs, dimensions capture potentially important factors for given applications, and cells represent combinations of values for the factors. To systematically analyze data in MDS, an interesting notion, called "cubegrade" was recently introduced by Imielinski et al. [2002], which focuses on the notable changes in measures in MDS by comparing a cell (which we refer to as probe cell) with its gradient cells, namely, its ancestors, descendants, and siblings. We call such queries gradient analysis queries (GQs). Since an MDS can contain billions of cells, it is important to answer GQs efficiently. We focus on developing efficient methods for mining GQs constrained by certain (weakly) antimonotone constraints. Instead of conducting an independent gradient-cell search once per probe cell, which is inefficient due to much repeated work, we propose an efficient algorithm, LiveSet-Driven. This algorithm finds all good gradient-probe cell pairs in one search pass. It utilizes measure-value analysis and dimension-match analysis in a set-oriented manner, to achieve bidirectional pruning between the sets of hopeful probe cells and of hopeful gradient cells. Moreover, it adopts a hypertree structure and an H-cubing method to compress data and to maximize sharing of computation. Our performance study shows that this algorithm is efficient and scalable. In addition to data cubes, we extend our study to another important scenario: mining constrained gradients in transactional databases where each item is associated with some measures such as price. Such transactional databases can be viewed as sparse MDSs where items represent dimensions, although they have significantly different characteristics than data cubes. We outline efficient mining methods for this problem.     

A Multilayer Optical Packet Switching Network Based on the Kautz Graph and Optical Passive Star Couplers

The multihop optical network is the most appropriate solution to satisfy the increasing applications of Internet services. This paper extends the regular Kautz graph to one with multiple layers in order to produce more architectural variations. The connectivity between adjacent layers utilizes the systematic connection patterns of a regular Kautz graph. A routing algorithm based on its property is presented. Optical passive star (OPS) couplers are adopted to implement our new topologies. Three scheduling criteria that can solve the contention problem in the intermediate nodes are evaluated and compared in terms of their capability to improve the accessibility.     

High dynamic range InP HBT delta-sigma analog-to-digital converters

To date, the development of multifunction multicarrier digital receivers for cellular base station and military communications applications has been limited by the demanding dynamic range requirements for the analog-to-digital converter (ADC). The use of oversampling delta-sigma modulators provides a promising approach to overcoming the dynamic range barriers Nyquist-rate converters face in the same applications. This paper discusses issues involved in the design of high-speed high dynamic range wide-band delta-sigma ADCs for such communications applications. Test results of prototype designs are also presented. The delta-sigma modulators described in this paper operate at sampling frequencies ranging from 1 to 2.5 GHz with center frequencies ranging from dc to 100 MHz, providing between 74 and 84.2 dB signal-to-noise ratio (12 and 13.7 bits) for bandwidths of 25 and 12.5 MHz, respectively. The loop filters are continuous-time low-pass and bandpass implementations of order 6 and 10, and were fabricated in an InP heterojunction bipolar (HBT) technology. A typical tenth-order design consumes 6 W of power and occupies a die area of 23.5 mm/sup 2/.     

Static energy reduction techniques for microprocessor caches

Microprocessor performance has been improved by increasing the capacity of on-chip caches. However, the performance gain comes at the price of static energy consumption due to subthreshold leakage current in cache memory arrays. This paper compares three techniques for reducing static energy consumption in on-chip level-1 and level-2 caches. One technique employs low-leakage transistors in the memory cell. Another technique, power supply switching, can be used to turn off memory cells and discard their contents. A third alternative is dynamic threshold modulation, which places memory cells in a standby state that preserves cell contents. In our experiments, we explore the energy and performance tradeoffs of these techniques. We also investigate the sensitivity of microprocessor performance and energy consumption to additional cache latency caused by leakage-reduction techniques.     

Fringing in tubular permanent-magnet machines: Part I. Magnetic field distribution, flux linkage, and thrust force

This paper extends an analysis developed for tubular permanent-magnet machines to account for the effect of fringing associated with the finite length of the ferromagnetic armature core. The magnetic field distribution, established by using an analytical technique formulated in the cylindrical coordinate system, provides an accurate means of evaluating the effect of the fringing flux on the thrust force and the back-electromotive force. Finite-element calculations confirm the analytically derived results. In Part II of the paper, the analysis is used to predict the cogging force that results from end effects and to facilitate minimization of the force.     

Optimised anaerobic treatment of house-sorted biodegradable waste and slaughterhouse waste in a high loaded half technical scale digester.

Anaerobic co-digestion of organic wastes from households, slaughterhouses and meat processing industries was optimised in a half technical scale plant. The plant was operated for 130 days using two different substrates under organic loading rates of 10 and 12 kgCOD.m(-3).d(-1). Since the substrates were rich in fat and protein components (TKN: 12 g.kg(-1) the treatment was challenging. The process was monitored on-line and in the laboratory. It was demonstrated that an intensive and stable co-digestion of partly hydrolysed organic waste and protein rich slaughterhouse waste can be achieved in the balance of inconsistent pH and buffering NH4-N. In the first experimental period the reduction of the substrate COD was almost complete in an overall stable process (COD reduction >82%). In the second period methane productivity increased, but certain intermediate products accumulated constantly. Process design options for a second digestion phase for advanced degradation were investigated. Potential causes for slow and reduced propionic and valeric acid degradation were assessed. Recommendations for full-scale process implementation can be made from the experimental results reported. The highly loaded and stable codigestion of these substrates may be a good technical and economic treatment alternative.     

InGaN microring light-emitting diodes

The fabrication and performance of an InGaN light-emitting diode (LED) array based on a microring device geometry is reported. This design has been adopted in order to increase the surface area for light extraction and to minimize losses due to internal reflections and reabsorption. Electrical characteristics of these devices are similar to those of a conventional large-area LED, while the directed light extraction proves to be superior. In fact, these devices are found to be more efficient when operated at higher currents. This may be attributed to improved heat sinking due to the large surface area to volume ratio. The potential applications of these devices are also discussed.