The oxidative coupling of methane on alkali- and alkaline earth-phosphate catalysts

The oxidative coupling of methane has been tested over alkali- and alkaline earth-phosphate catalysts at 700 and 775 °C with and without the introduction of a small quantity of tetrachloromethane (TCM) to the feedstream. In general, the conversion of methane was enhanced by the addition of TCM but the effect on selectivity was dependent on the catalyst being examined. The selectivity to C₂ and higher hydrocarbons and that to oxidation products have been shown to have a dependence on the cation radius/charge ratio.     

Hydrophobic effects on protein/nucleic acid interaction: enhancement of substrate binding by mutating tyrosine 45 to tryptophan in ribonuclease Tl

Hydrophobic effects on binding of ribonuclease Tl to guaninebases of several ribonucleotides have been proved by mutatinga hydrophobic residue at the recognition site and by measuringthe effect on binding. Mutation of a hydrophobic surface residueto a more hydrophobic residue (Tyr45 – Trp) enhances thebinding to ribonucleotides, including mononucleotide inhibitorand product, and a synthetic substrate-analog trinudeotide aswell as the binding to dinucleotide substrates and RNA. Enhancementson binding to non-substrate ribonucleotides by the mutationhave been observed with free energy changes ranging from –2.2 to – 3 .9 kJ/mol. These changes are in good agreementwith that of substrate binding, –2.3 kJ/mol, which iscalculated from Michaelis constants obtained from kinetic studies.It is shown, by comparing the observed and calculated changesin binding free energy with differences in the observed transferfree energy changes of the amino acid side chains from organicsolvents to water, that the enhancement observed on guaninebinding comes from the difference in the hydrophobic effectsof the side chains of tyrosine and tryptophan. Furthermore,a linear relationship between nucleolytic activities and hydrophobicityof the residues (Ala, Phe, Tyr, Trp) at position 45 is observed.The mutation could not change substantially the base specificityof RNase Tl, which exhibits a prime requirement for guaninebases of substrates.     

Antioxidant effects of chlorophyll and pheophytin on the autoxidation of oils in the dark. I. Comparison of the inhibitory effects

The effects of chlorophyll and pheophytin on the autoxidation of oils in the dark were investigated by oven tests. The results indicated that both chlorophyll and pheophytin show antioxidant activity when methyl linoleate is used as substrate. Furthermore, chlorophyll retarded the oxidative deterioration of triglycerides in rapeseed and soybean oils at 30 C. Among the four chlorophyll derivatives (chlorophylls a and b and pheophytins a and b), chlorophyll a showed the strongest antioxidant activity. The antioxidant effects of chlorophyll and pheophytin depended on the storage temperature and the kinds of oil used as substrate.     

Distribution of double bonds in thermally degraded polyisobutylene

The distribution of double bonds in thermally degraded polyisobutylene was determined quantitatively by using pulsed Fourier transform ¹H n.m.r. spectroscopic analysis. The double bonds in the degraded polymer did not exist in the interior but at the terminal positions of the polymer chain. These olefins were of the terminal trisubstituted and terminal vinylidene types. The content of the former was much greater than that of the latter. This shows that radical chain transfer predominantly occurs at the methylene hydrogen rather than at the methyl groups of the polymer chain. The average number of double bonds per molecule, f, was greater than 1 and tended to be near 2. Thereby most of the degraded polyisobutylene was shown to have two terminal unsaturations per molecule.     

EELFS as a new tool of local structural characterization of solid surfaces

A new apparatus to obtain information on local structures and chemical states of solid surfaces has been constructed, with which we measure electron energy-loss fine structures (EELFS), excited by electrons of a few keV incident at a grazing angle. We describe results about O/Ni(100) and O/W(100) systems, where we extensively take advantage of anisotropy in regard to momentum transfer of the probe electron and high surface sensitivity of this technique.     

Low-Temperature Synthesis of ZrC Powder by Cyclic Reaction of Mg in ZrO2–Mg–CH4

We investigated the conditions for low-temperature synthesis of ZrC fine powder from ZrO₂–Mg–CH₄. The synthesis utilizes a thermite-type reaction, with Mg as the reducing agent, and a reaction between Mg and CH₄ gas as a carbon source. The Mg/ZrO₂ molar ratio as well as the heating rate were varied. Because C can be continuously fed into the reaction group by the cyclic reaction of Mg through the formation and decomposition of Mg₂C₃ (2Mg + 3CH₄→ Mg₂C₃+ 6H₂→ 2Mg + 3C), a molar ratio of 2.2 for Mg/ZrO₂ was sufficient for the synthesis of single-phase ZrC. ZrC powders were synthesized under the following conditions: Mg/ZrO₂ molar ratio = 2.2, heating rate = 20°C/min, and temperature maintained at 750°C for 30 min. The amount of reaction heat produced in the reduction reaction of ZrO₂ by Mg depended on the Mg/ZrO₂ molar ratio, specifically, the amount of ZrO₂ contained. Moreover, the cyclic reaction of Mg-Mg₂C₃–Mg was influenced by the amount of reaction heat described above and by the heating rate. The ZrC fine powder showed little aggregation and high dispersibility.     

Radical polymerization of (phenylethynyl)styrenes and characterization of poly(phenylethynyl)styrenes as a thermally curable material

Summary The radical polymerizations of 2-, 3-, and 4-(phenylethynyl)styrenes (1a–c) and the copolymerizations of 1a–c (M₁) with styrene (M₂) were carried out using AIBN as the initiator in toluene at 60°C. The number-average molecular weights (M _ns) were extremely low for poly(2-phenylethynylstyrene) (2a) and poly[(phenylethynyl)styrene-co-styrene] (3a), and increased in the order of 2a, 3a << 2b, 3b < 2c, 3c. Monomer reactivity ratios were determined as r ₁= 1.80 and r ₂= 0.51 for 1a, r ₁= 1.72 and r ₂= 0.53 for 1b, and r ₁= 3.17 and r ₂= 0.24 for 1c. Polymers 2a–c and 3a–c underwent an exothermic reaction at elevated temperature to form organic solvent-insoluble polymers. Although the decomposition of 2a was observed from 200°C, 2b and 2c exhibited a high heat-resistance property in both nitrogen and air atmospheres, in particular, 2b showed no significant weight loss below 450°C. Received: 28 January 1998/Accepted: 5 March 1998     

Selective formation of CH3OH in the photocatalytic reduction of CO2 with H2O on titanium oxides highly dispersed within zeolites and mesoporous molecular sieves

Highly dispersed titanium oxide catalysts have been prepared within zeolite cavities as well as in the zeolite framework and utilized as photocatalysts for the reduction of CO₂ with H₂O to produce CH₄ and CH₃OH at 328 K. In situ photoluminescence, ESR, diffuse reflectance absorption and XAFS investigations indicate that the titanium oxide species are highly dispersed within the zeolite cavities and framework and exist in tetrahedral coordination. The charge transfer excited state of the highly dispersed titanium oxide species play a significant role in the reduction of CO₂ with H₂O with a high selectivity for the formation of CH₃OH, while the catalysts involving the aggregated octahedrally coordinated titanium oxide species show a high selectivity to produce CH₄, being similar to reactions on the powdered TiO₂ catalysts. Ti-mesoporous molecular sieves exhibit high photocatalytic reactivity for the formation of CH₃OH, its reactivity being much higher than the powdered TiO₂ catalysts. The addition of Pt onto the highly dispersed titanium oxide catalysts promotes the charge separation which leads to an increase in the formation of CH₄ in place of CH₃OH formation.     

Lithium-doped sulfated-zirconia catalysts for oxidative coupling of methane to give ethylene and ethane

Li-doped sulfated-zirconia catalysts were found to be effective for oxidative coupling of methane (OCM). The catalyst performances depend on the sulfate content and calcination temperature. A maximum C₂ yield is attained over the catalysts, which contain 6 wt.% sulfate and calcined at 923–973 K, being closely related to the preparation conditions of sulfated-ZrO₂ as solid super-acids. When the performances of the Li-doped sulfated-ZrO₂ (Li/SZ) catalysts were tested at 1023 K as a function of reaction time, both the C₂ and CO_x selectivities remained constant over the range of 8 h, but the CH₄ conversion decreased from 17.5% to 11.9%. The nature of Li/SZ catalysts for the OCM was investigated by X-ray diffraction, XPS, and NH₃ and CO₂ TPD measurements. It could be postulated that the sulfated-ZrO₂ surface could play an important role in the formation of a catalytically active structure by Li-doping.     

Effect of green compact structure on the sintering of alumina

The effect of particle agglomeration on sintering has been studied by slipcasting suspensions with pH values ranging from 2 to 11. The rate of densification has been found to depend on the degree of agglomeration. Complete dispersion of alumina primary particles has not been attained through adjustment of pH of suspensions, and agglomerates also remained in the best-dispersed suspension. Elimination of the agglomerates by sedimentation lowered the densification temperature of slip-cast compacts. The grain size-density curve is a function of temperature. High-density and small-grained sintered bodies were obtained by low-temperature long-time firing.