Call control and traffic transport for connection-oriented highspeed wireless personal communications over metropolitan area networks

A distributed circuit-switched approach for supporting the deployment of high speed wireless personal communication services in urban areas through the interconnection of base stations via metropolitan area networks (MANs) is proposed. Broadband MANs minimize traffic congestion by dynamic sharing of link capacity and by serving as distributed switches for partitioning call control functions. While the DQDB protocol readily supports distributed packet-switching over the IEEE 802.6 MAN, isochronous traffic such as voice and video is best supported by circuit-switched connections. The authors present an enhanced bi-state pre-arbitrated (PA) transport mechanism, and associated call control and handoff management techniques, which enable distributed circuit-switching over the MAN. These capabilities are not currently addressed in the 802.6 standards. The bi-state PA transport mechanism facilitates statistical multiplexing of variable rate isochronous traffic sources. The network capacity is constrained by the call setup delay performance, and is analyzed by simulations. Alternative signaling architectures, involving different placements of call control network elements, are evaluated. The effects of erasure nodes, and close bus versus open bus architectures, are considered. The overlap inter-MAN call setup procedure is proposed to reduce delays. Different call handoff procedures are formulated according to the type of handoff and the resulting change in call connectivity. Most handoffs are intra-MAN, requiring simple procedures with short delays     

MRT of experimental liver abscesses: a comparison of a new blood pool contrast medium with gadolinium-DTPA in animal experiments

PURPOSE: In an experimental pyogenic liver abscess model, the signal intensities were compared intraindividually and interindividually after the application of a new blood pool contrast agent, 24-gadolinium-DTPA (diethylenetriamine-pentaacetic acid) cascade polymer, and after the application of gadopentetate dimeglumine. METHODS: In 20 rabbits with experimentally induced liver abscesses, the relative signal intensities of the liver, abscess centre, abscess wall and portal vein were assessed before and between 30 seconds and 60 minutes after injection of a 25 mumol/kg dose of gadolinium polymer and of 100 mumol/kg of gadolinium-DTPA, respectively. Measurements were performed at 1.5 Tesla, using a head coil and a Flash-2-D sequence. RESULTS: The interindividual comparison (unpaired T-test, p < 0.05) yielded significant differences of the relative signal intensities of the abscess centre (at any time point after contrast-media application), abscess wall (between 15 and 60 minutes after contrast media application), and portal vein (between 30 seconds and 7.5 minutes after contrast media application). The interindividual comparison showed a significantly higher abscess centre-liver contrast (between 30 seconds and 12.5 minutes after contrast media application) and a significantly higher abscess wall-centre contrast (between two and 7.5 minutes after contrast media application) after the application of gadolinium polymer compared with gadopentetate dimeglumine. CONCLUSION: In this animal model, the higher abscess centre-liver contrast after the application of gadolinium polymer was the basis for a better and prolonged visibility of the abscesses, as compared with images acquired after injection of gadopentetate dimeglumine.     

Minor inflammatory lesions and sudden infant death: cause, coincidence, or epiphenomena?

Minor inflammatory changes are often found in tissues of infants who die suddenly. Recently it has been proposed that these infiltrates signal significant underlying infectious disease and are responsible for death. Currently there is no unanimity about the percentage of cases in which inflammatory infiltrates occur and no international consensus in regard to the minimal criteria required for their diagnosis or their significance. We recommend that the presence of minor inflammatory infiltrates should not detract from the diagnosis of sudden infant death syndrome (SIDS) until further study has determined otherwise.     

Diffusion in metallic glasses

Rutherfordα-particles backscattering technique was employed for measurements of diffusion rates in metallic glasses. Effects of relaxation, crystallization and plastic deformation on diffusion rates were also investigated. It has been observed that the diffusion rates of a metallic solute are of the same orders of magnitude in both metal-metal and metal-metalloid glasses. A higher diffusivity is likely if there is a large difference between melting points of the solute and matrix. Relaxation has no effect on diffusion, however, diffusivity increases on crystallization. An increase in diffusivity is also observed on plastic deformation of metallic glass.     

The slot-coupled hemispherical dielectric resonator antenna with a parasitic patch: applications to the circularly polarized antenna and wide-band antenna

The aperture-coupled hemispherical dielectric resonator antenna (DRA) with a parasitic patch is studied rigorously. Using the Green's function approach, integral equations for the unknown patch and slot currents are formulated and solved using the method of moments. The theory is utilized to design a circularly polarized (CP) DRA and a wide-band linearly polarized (LP) DRA. In the former, the CP frequency and axial ratio (AR) can easily be controlled by the patch location and patch size, respectively, with the impedance matched by varying the slot length and microstrip stub length. It is important that the AR will not be affected when the input impedance is tuned, and the CP design is therefore greatly facilitated. For the wide-band LP antenna, a maximum bandwidth of 22% can be obtained, which is much wider than the previous bandwidth of 7.5% with no parasitic patches. Finally, the frequency-tuning characteristics of the proposed antenna are discussed. Since the parasitic patch can be applied to any DRAs, the method will find applications in practical DRA designs.     

Orbital volume measurement in the management of pure blowout fractures of the orbital floor

With the recent advent of accurate orbital volume assessment by computed tomography, a retrospective analysis was made of 31 patients with 'pure' blowout fracture of the orbital floor, managed either surgically or conservatively, to determine whether orbital volume measurement could provide an additional parameter of use in the management of such fractures. There was a significant difference in orbital volume discrepancy between patients managed surgically or conservatively suggesting that this investigation may be of use in decision making on surgical intervention in patients with orbital blowout fractures.     

Sensitivity of LR 115 SSNTD in a diffusion chamber

Solid-state nuclear track detectors (SSNTDs), such as LR 115, have been commonly used in diffusion chambers for long-term measurements of radon gas concentrations. For the LR 115 SSNTD, it has been found that the active layer removed during chemical etching is significantly affected by the presence and amount of stirring, and thus cannot be controlled easily. However, the sensitivity of the LR 115 detector inside a diffusion chamber to the radon and/or thoron gas concentration is dependent on the actual removed active layer thickness. This relationship is dependant on the geometry of the diffusion chamber and the deposition fraction of ²¹⁸Po in the diffusion chamber, as well as the V function for the LR 115 detector (V is the ratio between the track etch velocity V_t to the bulk etch velocity V_b). This paper presents the experimentally determined relationships between the sensitivity of the LR 115 detector inside a Karlsruhe diffusion chamber and the removed active layer thickness, for both radon and thoron. A V function was adjusted to simulate the relationships. In particular, for the case of ²²²Rn, we have found f ∼ 0.5, where f is the fraction of ²¹⁸Po which decays inside the diffusion chamber before deposition onto available inner surfaces of the chamber. In conclusion, we have found that the sensitivities critically depend on the actual removed active layer thickness, so this should be monitored and used in determining the sensitivities.